What are the radian and degree–minute–second equivalents for the following anglesgiven in grads:(a) 136.0000 grads (b) 63.0984 grads (c) 235.8760 grads

Q: A line measured with a 50-m steel tape was recorded as 352.70 m. If the tape is 50.08 m long during…

A:

Q: Station A B C Angles 41° 73° 67° No. of Measurement 4 6 2 A. Compute the most probable value of…

A: Weight is inversely proportional to number of observation

Q: From the values ​​of the magnetic quarter circular directions, find the value of the following…

A: From the given date it is required to find the angles given. DAE, EAB, BAD, CAE

Q: Determine the characteristic of Log (1020.20) O 1020 0 0.20 O 20

A: Integer part is characteristics

Q: A) identify the best line. (2pts) B) What is the forward and back bearing of the best line? C)…

A:

Q: X is a point having an elevation of 756.32 m above the datum. Point Y and Z are of unknown…

A: Given:

Q: 30 15 050 What are the commands needed to solve this ?question in AutoCAD Ø100 8x 010 ON PCD 80 23…

A: To Determine Commands needed to draw the given image in AutoCAD.

Q: Determine the moment of inertia about its horizontal centroidal axis of a T-beam shown. In mmª 600…

A:

Q: Compute the area of the given fraverse using DPD and DMD method.

A: Solution: DMD and DPD Method:

Q: If the magnitude of R is 560 N, what is the value of Q? y (30% 25° R /30%

A:

Q: Moment of inertia of a triangle having base 15 m and height 6 cm about edge opposite to base is

A: Given: Triangle having base, b=15 cm height, h=6 cm   To find. Moment of inertia about edge opposite…

Q: From the following measured interior angles of a five sided figure: Station Values of Angles ( No.…

A: To find :

Q: Question: 1.What is the adjusted bearing angle of Line DE, CD, EF, FG 2.What is the total length…

A: Solution line  Length Bearing Difference Forward Backward Forward Backward in bearing reading…

Q: Calculate the ED, EL, Eclosure and Precision of the given figure of a lot: Round off to 3 decimal…

A:

Q: 3. A transit with stadia interval factor of 100.8 was set up at point C on the line between points A…

A: Here distance has to calculate between A and B

Q: questions by completing the tabulation below. Determine the DMD of course EA using compass rule.…

A: To Find : 1) DMD of EA using compass rule 2) Adjusted bearing of line DE using transit rule

Q: 2. Convert to degrees, minutes and seconds the decimal angle 325.7541667 degrees. 3. Convert 270°…

A:

Q: A 55°25' D S 80°21'E N 85°31'W B a. North 29 degrees 05 minutes West b. South 30 degrees 06 minutes…

A:

Q: 10. Complete the following table using the knowledge obtained in class about differential leveling…

A: Complete the following table using the knowledge obtained in class about differential leveling

Q: 2. The following values were determined in a series of tape measurements of a line: 920.58,…

A:

Q: A 55°25' D S 80°21'E N 85°31'W B S 6°19'E C For the accompanying figure, what is the bearing of the…

A:

Q: Do not include the unit in writing the answer. Express all values up to 3 decimal places. You can…

A: To Determine :- Highest elev of the line of sight Station with the highest elevation (excluding BM1…

Q: Calculate the area of closed traverse

A: Given: Station X (Easting) Y (Northing) 1 0 0 2 51 54 3 104 111 4 159 171 5 216 234 6…

Q: Engineering survey شمدنسحب

A: Simpson rule is used to calculate a.) Distance b.) Volume c.) Volume

Q: Problem 4: The angles of a triangles are measured not under the same conditions with results given…

A: Given,  Observed angle:- X = 33°47'01" Y = 54°38'23" Z= 92°35'36"

Q: To mitigate the closing error, sum of latitudes and departures mu equal to zero. O a. True O b.…

A:

Q: Please enlighten me on how did they get those values that I encircled. Thank you very much! I'll…

A: The encircled value of 91.8 kN has come from the concentrated load 34 kN at point B.

Q: 1. Convert the angle 238°25'50" into its equivalent in decimal degrees.

A: I will only solve the first question as per the guidelines. So, upload other questions as separate…

Q: 1. The distance from points A to point B was recorded as 576.35 m and the reverse distance was…

A:

Q: the linear misclosure the final coordinates of stations

A:

Q: Q3: In the figure, Find the distance from B to C: A (100/lo0) 155.3oum UN49 30w 245.918 m

A: Given that: A traverse as shown

Q: Q.4. Please calculate elevations in the stations given in the table and show the arithmetic check.…

A: Levelling of a site must be done in order to understand the nature of whether the site is having a…

Q: Multi-annual time scale is typicall used in hillslope spatial scale True O False

A: Given To say true or false

Q: What is the area of the following closed traverse? A B с D N 1326.485 1542.432 1227.488 1099.338 E…

A:

Q: Calculate the area of the rectangle where the coordinates are given in meters as shown in Figure…

A:

Q: 1. For the following two channels x-section, calculate energy and momentum factors a and B. Values…

A: Energy correction factor (α)=Kinetic energy based on actual velocityKinetic energy based on average…

Q: If the magnitude of R is 560 N, what is the value of P? y (30% 25° R /30%

A:

Q: 0 63662 x1000 × Lor 1. 27 324 050X10 200 100 Lbr = 0.4 9998 0.50 m bronze = O:50m lenth of the

A: This is the simplification problem for the given equation which we need to calculate the length of…