What are four important properties of the media for a heavy medium separation?           b) With the aid of a simple or flow schematic diagram, describe the basic features of a heavy  medium plant.    c) Discuss the advantages of using a centrifugal separator over using a gravitational separator/bath

Q: Derive the Kremser equation for a stripper with three equilibrium stages

A: Kremser equation for stripping section is to be derived.

Q: For heat transfer, the surface resistance was characterized by a convective heat transfer…

A: For convective heat transfer the heat transfer quotient h is given by:

Q: In general, why should the operating pressure be high and the operating temperature be low for an…

A: The reason for the high pressure and low temperature for the absorption process is to be mentioned…

Q: B/ Define the Schmidt number, Prandtl number and Reynolds number and clear up the relation for each…

A: The Schmidt number (Sc), Prandtl number (Pr), and Reynolds number (Re) are dimensionless variables…

Q: 2. Label the names of the following membrane filtration operation modes at the bottom of the images

A: This is dead end flow  The particles are trapped within membrane and all water   Will pass…

Q: 2. How is phase diagram of water different from most other materials show with sketches. What is its…

A: In a phase diagram; there are certain important terms which should be explained first. Different…

Q: discuss any one horizon sand mill in Oil & Paint Technology

A: A Horizontal Bead (Sand) Mill is a type of grinding machine that is used to disperse and grind…

Q: Analyze the following images. Identify the type(s) of corrosion. Clearly state your assumptions.…

A: By seeing this image, we can infer that this is an image of a switchboard and by the use of screws…

Q: (b) The general characteristics of three oil wells selected for artificial lift as production method…

A: Table of 3 well are given.

Q: Given the table below and your judgement for extreme operational conditions, select polymers for the…

A: Given Data Different Material With their Glass Transition Temperature and Melting Point.  To find…

Q: Because intermolecular forces can only be controlled at surfaces & interfaces. Because of the high…

A:

Q: Discuss the classification of heat exchangers.

A: Heat exchangers are those equipment's which is used to transfer heat from a hot fluid to a cold…

Q: A piece of hollow fiber membrane shows a flux value of 5.70 cm³/cm².s based on the outside area of…

A: Given: Flux value based on outside diameter is 5.70 cm3/cm2 s Flux value based on inside diameter is…

Q: 2. In 3D printing, small liquid droplets are formed when a liquid jet breaks up in spray and fuel…

A: it is given that

Q: Please discuss "Drilling problems related to drilling fluid rheological property"

A: Drilling muds or fluid is sued as carrier of rocks produced during the oil and gas drilling…

Q: Represents and describes by means of a diagram the main parts of the evaporation equipment.

A: Evaporation  It is the process of concentrating the stream by removing water. The process is energy…