(WEB) Air at 17°C, 100 kPa flows in a duct. A stagna-P4-46tion tube connected to a U-tube manometer filled with mercury isplaced in the duct. Using data on the figure, find the air velocityAssume atmospheric pressure is 100 kPaAir at 17°C, 100 kPa30 mmMercury

Answered: (WEB) Air at 17°C, 100 kPa flows in a…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A plane is flyng at an alHitude where the local air pressure (P) and temperatuve (T) are 70 KPa and -30c. The flight apeed is 600 miles per hour. The Mach number of flight i's, 4. a. 0.56 ; b. O.66 ; c. 0:76 ; d. 0-86 ;e. 0.96
95kPa AIR hc he n A hA An Air tank is connect to a U-tube that contains three separate liquids as follows: (A) mercury, (B) kerosene (C) brine ha = 50 cm hB = 40 cm hc= 30 cm If the atmospheric pressure is 95 kPa, find the pressure in the Air tank.
I need the answer as soon as possible
Prove your answer using diagram and equation.
Please explain using diagram and equation
Q1: when aircraft is ffying at subsonic velocity, the pressure at its nose i e. the stagnation point is found to be 160 kpa. if the ambient pressure and temperature are 100 kpa and 298k respectively, find the speed and Mach number at which the aircraft is flying.-
The pressure of steam 400 C and u = 2949 kJ/kg is most nearly
The values of Cp for the consu Ammonia in air is a toxic mixture when the ammonia is 0.45% by volume. Calculate how much leakage from an ammonia compressor can be tolerated per 1000m³ of space. The pressure is 1bas and the temperature is 15 °C. The molar mass of ammonia (NH3) is 17kg/kmol, and it may assume to act as a perfect gas in this case. and 70 °C. The vessel is A perfect insulated vessel having three compartments A, B and C of volume 1.3m³, 1.2 m³ and 1.0 m² respectively are separated from each other by thin membrane. Compartment A is filled with ritrogen having a pressure 3bar, at a temperature 25 °C, compartment B is filled with hydrogen having a pressure of 20bar at a temperature -40 °C and compartment C filled with carbon (IV) oxide at a temperature 175 °C and pressure 6bar. If the thin membrane are punctured and the three gases allowed to mix freely, calculate: (i) The final temperature of the mixture The final pressure of the mixture (iii) The change in entropy of the…
1- In c-d nozzle, after the throat the relation between the velocity of air flow (1) and area (1) is given by: V-100+2012. This means that the flow at exit is.... (A) Sonic (B) subsonic (C) supersonic (D) not specified 2- After the expansion waves, the quantity that decreases is the: (A) Density (B) stagnation pressure (C) Mach number (D) (A) and (C) 3- For a converging nozzle, when the assumed critical pressure (p) is greater than the ambient pressure, the nozzle is: (A) Mc <1 (B) McI (C) chocked (D) (A) and (C) 4- The stagnation temperature To remains constant across the shock wave because To represents.... (A) thermal energy (B) total energy (C) kinetic energy 5- The expansion waves are a series of ...... expansion processes. (A) isothermal (B) adiabatic (C) isentropic 6- For a flow through a c-d nozzle, when the flow is maximum, then the critical arca (A*) is (A) equal to throat area (B) greater than throat area (C) less than the throat area 7- Over a convex corner, the most…
A bicycle pump contains air at STP. As the tire is pumped up, the volume of air decreases by 57 percent with each stroke. What is the new pressure of the air in the chamber after the first stroke, assuming no temperature change? Answer in units of atm. Answer in units of atm
I need the answer as soon as possible
Q2: The large compressed-air tank shown in the figure bellow exhausts from a nozzle at an exit velocity of V235 m/s. Assuming isentropic flow, compute: a) the exit Mach number. b) the pressure in the tank. (take; k = 1.396, C, = 917 J/Kg.k and R = 260 J/Kg.k) air at 30 C tank conditions Pan= 101 LPa

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS

(WEB) Air at 17°C, 100 kPa flows in a duct. A stagna- P4-46 tion tube connected to a U-tube manometer filled with mercury is placed in the duct. Using data on the figure, find the air velocity Assume atmospheric pressure is 100 kPa Air at 17°C, 100 kPa 30 mm Mercury