Water of is Flowing through 2.54 cm horizontal tube diameter, what is the maximum will be average Velocity at which laminar Flow stable ? what The is the Viscosity of pressure 9 drop at water this Velocity? -3 is 1.8 * 10 Pa. S

Q: 7. A lubricating oil of viscosity 0.1 Ns/m² and SG of 0.9 is pumped through a 30 mm diameter pipe.…

A:

Q: Fluid A Fluid B hz Impact tube at center Question C1 Two liquids A & B are flow throw two pipes to a…

A: fluid A d1=38.1mm=0.0381m d2=18.9mm=0.0189m cd=0.965 R=148cm d=32.9mm note-all data we will take…

Q: What rotational speed must be maintained in operating a 10-in. diameter centrifugal bowl handling a…

A: A centrifugal bowl of D=10in Liquid layer Thickness of fluid layer t=2in Density of fluid ρ=72.5…

Q: 3. A fine (thin) ring with a radius 50 mm is being pulled from the surface of water. If the ring has…

A:

Q: Oil of density 936 kg/m³ and kinematic viscosity 100 mm²/s is flowing in a horizontal circular pipe…

A: Given Data : Density of oil (ρ) = 936kgm3Kinematic viscosity (κ)=100 mm2s=100×10-6m2sDiamter (D) =1…

Q: Nitrogen flows through a 4 in. x 6 in. rectangular duct at a rate of 2280 ft/s. What is the Reynolds…

A: Firstly hydraulic diameter was calculated for the rectangular duct and the Reynolds number is…

Q: Determine the Reynolds number for a flow of water at 25 ° C in a lin diameter sanitary pipe at a…

A: At Temperature = 25 C  Properties of water Density= 997 Kgm3 Viscosity, u =8.90 × 10−4  Pas mass…

Q: Determine the surface area required for a rectangular settling tank for a wastewater flow rate of…

A: The surface area required by the rectangular settling tank for the given flow rate of wastewater is…

Q: lo Poo S, = 998 kglu? 1. Sm Sa- 680ylu? Gasoline Water S = 1.6 In

A:

Q: 3-foot-long, 8-inch-diameter cylinder inside a 25.8-inch-diameter tube at 3 feet per second. Fluid…

A: Given data: Length of pipe= 3ft Kinematic viscosity=0.006 ft2/s Constant velocity=3fps  Relative…

Q: Determine diameter of galvanized pipe needed to make the water flow along 180m with flow rate 85L/s…

A: Given data: Length of pipe = 180 m Volumetric flow rate = 85 L/s Head loss = 9 m Kinematic viscosity…

Q: (Show complete solution) For flow of water at a Reynolds numver of 1.03x106 through 5-cm diameter…

A:

Q: What is the formula for number of revolutions Ne in the outer vortex of cyclone seperator?

A: The number of revolutions Ne in the outer vortex of the cyclone separator is the number of effective…

Q: What is Outlet Gas Velocity in a cyclone seperator?

A: In mechanical operation, Cyclone separators are separation devices that use the principle of inertia…

Q: What is the entropy increase through a convergent-divergent nozzle, if a normal shock occurs at a…

A: The entropy change of gas flowing in a nozzle is an isentropic process i.e. the change in entropy is…

Q: As shown in figure below, oil can be siphoned from a tank using a flexible hose, provided that the…

A: Taking point B as the reference plane that is height at B, hB = 0 Hence, Height at point A, hA =…

Q: 13.1 Anoil with kinematic viscosity of 0.08 x 10-3 n2/s and a density of 57 lbn flows through a…

A: The flow in the tube is assumed to be fully developed. It is assumed to be a steady-state condition.…

Q: Which among the statements is incorrect? (Α The flow velocity profile for turbulent flow is fairly…

A: The incorrect statement is:

Q: At what distance from the leading edge of a flat surface will the transition from laminar to…

A: Dear User ,According to Bartleby policy , we can answer only 3 subparts of a question , kindly post…

Q: : Determine the pressure difference between the two points in figure below Oil (S=0.75) X- ----- S,…

A:

Q: Calculate the kinetic energy changes

A:

Q: 1. An oil having a density of 1200 kg m3 and a viscosity of 0.02 Pa s flows through a 25 mm diameter…

A: It is to be mentioned whether the flow of oil is laminar or turbulent.

Q: Compute the capillary rise in mm of pure water at 10 Celsius expected in an 0.8 mm diameter tube.

A:

Q: State the Navier-Stokes equation for the case of three-dimensional flow and give the uses of…

A: --> Give the navier- Stokes equation for three dimensional flow. --> uses of navier- stocks…

Q: Q. 4) from the schematic diagram find, (a) Length of fin, (b) Fin effectiveness. Account for tip…

A: From the given diagram(Convection at the tip) Find Length of fin,L Fin effectiveness,ε

Q: For a parallel plate arrangement, it is found that when the distance between the plates is 5 4 mm, a…

A:

Q: 6. Oil with a viscosity of 30 cP and a density of 60 lb/ft^3 flows through a % inch inside diameter…

A:

Q: Derive the equation of average permeability of linear flow of two layered-parallel beds with…

A: The average permeability is calculated from the the average method. The average method is used to…

Q: Q2: With laminar flow in a circular pipe, at what distance from the centerline (in terms of the pipe…

A: Consider the laminar flow of fluid through a pipe as shown in the figure. An elemental volume has…

Q: Exz: water at 1SC Hows between tow large plate at avelocityof 15 ms the plates are seperated by…

A:

Q: The power of viscosity correction factor is for laminar flow.

A: Consider the laminar flow of a fluid in the thermal and hydrodynamic entrance region. The viscosity…

Q: 4. What is the terminal velocity of a cubic steel particle, 0.40 mm in each side, settling in an oil…

A: Write the expression for terminal velocity as follows: vt = 2mgρACd     ......1   Here, vt is the…

Q: A 0.6 mm diameter glass tube is inserted into water in a cup. Determine the capillary rise of water…

A: The liquid rises due to the forces of adhesion, cohesion, and surface tension. If adhesive force…

Q: 1. Water (p= 1000 kg m-³ and μ = 0.0011 kg m-¹ s-1) flows at 5 m s-1 over a 0.3 m long flat plat.…

A:

Q: orizontal force of to move a 5.00N block in a constant velocity is what is the coefficient of…

A: Given that Horizontal force of to move 5 N block is 1.5 N We have to find the coefficient of kinetic…

Q: mine the change in length in metre due to work by surrounding on the system of 15 kJ with

A: Work done = 15KJ = 15*10³J = 15*10³kgm²/s² Force = 300N = 300kgm/s²

Q: 4. Consider two-dimensional, laminar, unidirectional flow between parallel (spacing: 2h), vertical…

A: Distance between two parallel plates = 2h Two dimensional, laminar, and unidirectional flow takes…

Q: The surface tension of water at 20°C in a 2mm diameter tube is equal to 0.075 N/m. For a water-…

A: Given  Surface tension( T )  = 0.075 N/m Diameter of tube( D)= 2mm                                =…

Q: Air is flowing through a horizontal tube with 1.00-in inside diameter. What is the maximum average…

A: Given data: Inner diameter of pipe = 1 in