Water is moving forward through parallel plates at standard conditions. The bottom plate is fixed, and upper plate moves when a force is applied. What force value is required to make the upper plate move if the length of both plates, mean velocity. effective area, and vertical distance between the two plates are 5.08 cm, 3 f/s, 200 in and 0.2 in respectively? Determine the effective diameter? The velocity profile is given by U(x.y) - Umean cos(x2 + 2y) -e Attach

Q: Problem 1 Water with density Pwater = 1000 kg/m³, is transported in 30° circular pipe, inclined at…

A:

Q: A) Figure (2) shows the velocity distribution for flow of water between two parallel plates.…

A: As per honor code and answering guidelines I can answer first 3 sub parts at a time if you want…

Q: What is the pipe velocity at point 1? Given the specific gravify of pink liquid S=3.9 and height…

A: Given data  Specific gravity of pink liquid(S) = 3.9 h = 1.4 m of pink fluid To determine  the…

Q: The minimum pressure on an object moving horizontally in water (Ttemperatu at10 degree centrigrade)…

A: Soln:- T = 10 °C        p = 1000 kg/ m^3            D= 1 m              pmin= 80 kpa           Patm=…

Q: An oil drop has a density (?1 ) of (560+R) kg/m3 . The terminal velocity of a spherical drop of this…

A: Given data ρ0=560+R kg/m3VT=15+R ×10-2 m/sμ=18×10-6  pa·sec

Q: Question 3 What force must be applied at the lower edge of the plate so that plate is kept vertical.…

A: Jet cross sectional area = 10 mm2 & impinges normally on the plate with a Velocity of 5…

Q: A pitot-static probe will be used to measure the velocitydistribution in a water tunnel at 20°C. The…

A: Given data as per the question  the specific gravity of liquid = 1.7 velocity in the water tunnel =…

Q: Q. 6 A 4.5-cm wide space between two plates is filled with SAE 30W lubricating oil at 26.7°C (Hoil =…

A: Given, Width between the plates,w=4.5cmViscosity of oil,μ=0.301645Ns/m2Drag force, F=18NVelocityof…

Q: Problem 5. A thin oil film (u= 0.80 N - 8/m2.p=865 kg/m') of height h = 5.0 mm is squeezed between…

A: Given, Fluid Viscosity μ=0.8 Ns/m2 Density ρ = 865 kg/m2 Height h = 5 X 10-3 m Velocity of bottom…

Q: A jet propelled boat is discharging water at a speed of 10 m/s relative to the ship in a jet of 0.02…

A:

Q: determine the steady state velocity.

A:

Q: As given in the figure below, a square block weighing 1.1 kN has a 20° inclination and is 0.25 m x…

A:

Q: 8-2 For this weird nozzle, what force would have to be applied through the bolts in the flange to…

A:

Q: Consider air flowing past a hemisphere resting on a flatsurface. If the internal pressure is pi,…

A: The expression for the force on the hemisphere is, From the above expression, the pressure force…

Q: The 100-mm-diameter pipe is connected by a nozzle to a large reservoir of air that is at a…

A: The schematic diagram is,Here, point 2 is the exit point.

Q: Two endlessly long flat plates, separated by 3 inches in distance but with a thickness of 5 inches,…

A: Given Data SG=0.89 Dynamic viscosity=1 Pa.s H=3 in V=5 m/s

Q: In Fig. I the upper plate moves upwards in 1.5 m/s and the lower plate moves upwards ini m/s, the…

A:

Q: Verify that the flow of oil is laminar (barely) for an oil gusher that shoots crude oil 25.0 m into…

A: Understand that at the topmost point the velocity of the water stream will be zero and the water…

Q: 2. A cylindrical shaft of radius 4 cm is rotating at a speed of 30 rad/s in a cylindrical bearing .…

A: Given data: For cylindrical shaft: radius, r=4 cm, rotating at a speed of, ω=30 rad/s in a…

Q: Water at 30ºC is able to climb up a clean glass of 0.2 mm diameter tube due to surface tension.The…

A:

Q: value of the pressure coefficient for an airplane flying at 170m/s in air at 2

A:

Q: ) A 75 mm-diameter orifice is on the vertical side of a closed tank. The tank rests on a flat ground…

A: Given: Diameter of orifice→D=75 mm=0.075 m Height of the orifice from the ground: →h=0.5 m Hence…

Q: o indefinitely long flat plates separated by 3 inches in distance but with a thickness of 5inches…

A: Given:Distance between plates, b=3 inThickness of plates, d=5 inVelocity of alcohol, v=5…

Q: A square block is weighing 300 N and having a length of 20 cm on one edge slips on a 20° inclined…

A: Given data  weight of block (W) = 300 N  Length (L) = 20 cm = 0.2 m  inclination of inclined surface…

Q: A plate of 0.125 mm distant from a fixed plate, moves at 20cm/s and requires a force of 40 N per…

A: Given data,  dy= 0.125 mm =0.000125 m du=u= 20 cm/s =0.2 m/s τ= 40 N/m²

Q: frichion negketing betueon jet and plate, find the reattim (Fre) raquired on the plate?

A: Given: To determine: The reaction force on plate

Q: (a) The gap between two horizontal plates is 5 mm. The gap is filled with oil of a relative density…

A:

Q: A 30cm-by-30cm flat plate is being pulled at 5.2 m/s horizontally through a 3.6 mm thick oil layer…

A:

Q: A capillary tube has an 8mm inside diameter through which liquid fluorine refrigerant R-11  flows at…

A: To find(a) What is the required velocity in the model for dynamic similarity?(b) When dynamic…

Q: Fluid with the viscosity of 5X10-4 m2/s, is flowing in a pipe with the diameter of 35 cm and…

A:

Q: To cool a given room it is necessary to supply 4 ft3/s of air through a 5-in-diameter pipe.…

A:

Q: A а 20°

A: given:weight of the block W=300NLength l=20cmθ=200oil thickness y=1mmFOR SAE30 μ=0.29pa-s

Q: A capillary –tube viscometer is being selected to measure viscosity of a liquid food. The maximum…

A: capillary –tube viscometer is an apparatus for measuring the viscosity of a fluid by passing it…