Water is flowing through a pipeline shown on the right. The radii of the pipe at points 1 and 2 are 0.500 m and 1.50 m, respectively. The volume flow rate through the pipeline is 2.50 L/s . If the pressure at point 1 in the pipe is 200 kPa, what is the pressure at point 2, located 5.00 m above point 1?

Q: A reservoir has a shape that is approximately rectangular. It is being held by a dam that is 525…

A: Given value--- breadth = 525 m. length = 12700 m. height = 84 m. We have to find--- What is the…

Q: A refinery uses a Venturi tube like the one shown in the figure to monitor the flow of gasoline (? =…

A: density of fluid = ρ= 7 x 102 kg/m3 inlet radius = r1= 2.5 cm outlet radius = r2= 1.4 cm pressure…

Q: A round pipe of varying diameter carries petroleum from a wellhead to a refinery. At the wellhead,…

A: Given data: Diameter at wellhead (d1) = 0.511 m Flow speed at wellhead (V1) = 11.3 m/s Flow speed at…

Q: 1000kg/m is flowing through a pipe that has an area of 0.5m2 with a velocity of 1 m/s at position A.…

A:

Q: You build a pressure gauge as shown in the figure below. The spring has spring constant of 1000 N/m…

A:

Q: A pump circulates water through a system of connected pipes on a house from the basement to the top…

A:

Q: A non-viscous fluid with density ρ = 0.810 g/cm3 is flowing in a horizontal direction as shown in…

A: Write a given values of this question. ρ=0.810g/cm3=0.810×10-310-6kg/m3=0.810×103…

Q: The water in a tank is pressurized by air and the pressure is measured by a multifluid manometer as…

A:

Q: (Figure 1) shows a tank of 20°C water with a nozzle h = 25 cm below the surface. Bernoulli's…

A: Given:  The constant height, h = 25 cm Diameter of nozzle, d = 1.0 mm   To Find:  Volume flow rate…

Q: Oil is flowing through a pipeline at a speed of 1.4 m/s. If the diameter of the pipe is 0.12 m, what…

A: Given Speed = 1.4 m/s Diameter of the pipe = 0.12 m Radius of pipe = 0.06 m = 6 x 10-2 m

Q: A liquid is flowing through a horizontal pipe whose radius is 0.0224 m. The pipe bends straight…

A: Given: Horizontal pipe radii, r1=0.0224 m Pipe bent height, h=8.8 m Another horizontal pipe radii,…

Q: The drawing shows an intravenous feeding. With the distance shown, nutrient solution (p = 1050 kg/m)…

A: The pressure due to the fluid is given by  P = h d g  where, h is the height of the fluid, d is the…

Q: Water is stored in a pressurised container at a height ??= 11.2 m. It then moves through a…

A:

Q: established

A:

Q: Oil is flowing through a pipeline at a speed of 1.56m/s. If the diameter of the pipe is 0.48m, what…

A:

Q: Water is flowing in the pipe shown in the figure below, with the 7.55-cm diameter at point 1…

A: So,

Q: The average density of the material in intergalactic space is approximately 2.5 × 10–27 kg/m3.  What…

A: m =p*v m =(2.5*10-27kg/m3)(8*1024m3) m = 2*10-2kg m = plead*Vlead 2*10-2kg = (11300kg/m3) Vlead =…

Q: Water at a gauge pressure of P = 3.8 atm at street level flows into an office building at a speed of…

A: Ans:- Image-1

Q: Water is flowing through a pipeline shown on the right. The radii of the pipe at points 1 and 2 are…

A:

Q: The picture shows a section of pipe within a closed system (not open at the ends). Water (density…

A:

Q: A large diameter tank with the top closed and sealed is filled to a fluid depth of  3 meters. (fluid…

A: Given: The depth of water in tank h1 = 3 m. The height of water in pipe h2 = 5 m. Density of fluid…

Q: Water is flowing without friction through a pipe. At the beginning of the pipe the water is flowing…

A:

Q: Water moves through a constricted pipe in steady, ideal flow. At the lower point shown in the figure…

A: Step 1: Step 2: Step 3: Step 4:

Q: Water moves through a constricted pipe in steady, ideal flow. At the lower point shown in the figure…

A:

Q: Water is flowing in the pipe shown in the figure below, with the 8.10-cm diameter at point 1…

A:

Variation of pressure

From the equation of pressure, pressure is directly proportional to the applied force.