Water is flow in a 4 in Schedule 40 steel pipe at 20 0C and 1 atm. Orifice meter with orifice diameter 6.2 cm is fitted in pipe to the horizontal to measure the flow rate of water. The difference in manometer head is 5 cm of mercury. Expansion factor can be taken as 1. a) Calculate the volumetric flow rate of water. (Fluid Mechanics Question)

Q: What are the liquid and vapor flow rates for the bottom and distillate streams

A:

Q: 7. A lubricating oil of viscosity 0.1 Ns/m² and SG of 0.9 is pumped through a 30 mm diameter pipe.…

A:

Q: Fluid A Fluid B hz Impact tube at center Question C1 Two liquids A & B are flow throw two pipes to a…

A: fluid A d1=38.1mm=0.0381m d2=18.9mm=0.0189m cd=0.965 R=148cm d=32.9mm note-all data we will take…

Q: Manometeri is being used to indicate the pressure difference between two point. Calculate the volume…

A:

Q: Water flows in a pipeline composed of 75 mm and 150 mm pipe. Calculate the mean velocity in the 75…

A:

Q: While attempting to extinguish a fire, firefighters are holding a nozzle at the end of a hose. If…

A:

Q: Water with density 1000 kg/m3 flow in a 4-in ID pipe at 1,2 m/s, witch connect to a Venturi meter to…

A: Density of water = 1000Inner diameter of pipe = 4 in.Water velocity at the inlet of pipe = 1.2…

Q: 5. A Pitot tube in the pipe in which air is flowing is connected to a manometer containing water as…

A: Given that- Manometer difference in water level, x=87.5 mm= 0.0875m Tube coefficient, CP=0.90…

Q: 1-Water with kinetic viscosity v-0.494 mm2/s flow through a pipe with diameter 18mm with velocity…

A: Kinetic viscosity = 0.494 mm2 /sdiameter = 18 mm V= 0.1 m/sf  = 0.03 mm

Q: A Venturi meter shown in fig. What is t city of the water in the first and second pip

A:

Q: Determine the Reynolds number for a flow of water at 25 ° C in a lin diameter sanitary pipe at a…

A: At Temperature = 25 C  Properties of water Density= 997 Kgm3 Viscosity, u =8.90 × 10−4  Pas mass…

Q: For the water flow at 20 °C, use the manometer measurement to estimate the (a) centerline velocity…

A:

Q: Determine diameter of galvanized pipe needed to make the water flow along 180m with flow rate 85L/s…

A: Given data: Length of pipe = 180 m Volumetric flow rate = 85 L/s Head loss = 9 m Kinematic viscosity…

Q: The velocity profile of a fluid in a horizontal circular pipe having a radius R is found as; Vz =0.4…

A: Given data: Velocity profile for a fluid in a circular horizontal pipe is given by the following…

Q: Q3: The flowrate of a fluid in a pipe is measured using a pitot tube which gives a pressure…

A: Perform force balances for streamline flow in pipe:

Q: a cubic reservoir has side of 10 meters. if it is initially half full with water by height,…

A: Given, Side=10 m Height of water, h=5 m

Q: 13.1 Anoil with kinematic viscosity of 0.08 x 10-3 n2/s and a density of 57 lbn flows through a…

A: The flow in the tube is assumed to be fully developed. It is assumed to be a steady-state condition.…

Q: 4. Water flows through a smooth horizontal 2 m long tube of 2 mm diameter with an average velocity…

A:

Q: At what distance from the leading edge of a flat surface will the transition from laminar to…

A: Dear User ,According to Bartleby policy , we can answer only 3 subparts of a question , kindly post…

Q: Unit for mass flow rate and molar flow rate

A: The mass flow rate is defined as the differential mass of the fluid flowing per unit of time. The…

Q: : Determine the pressure difference between the two points in figure below Oil (S=0.75) X- ----- S,…

A:

Q: Calculate the kinetic energy changes

A:

Q: 1. An oil having a density of 1200 kg m3 and a viscosity of 0.02 Pa s flows through a 25 mm diameter…

A: It is to be mentioned whether the flow of oil is laminar or turbulent.

Q: Water at 20°C flows in a cylindrical pipe with internal diameter of 2 cm. At what critical fluid…

A:

Q: A straight pipe with an expansion in pipe from 6 to 11 cm transports water at a rate of 0.011 m /s.…

A:

Q: State the Navier-Stokes equation for the case of three-dimensional flow and give the uses of…

A: --> Give the navier- Stokes equation for three dimensional flow. --> uses of navier- stocks…

Q: calculate the largest discharge for which the flow will be definitely laminar Water flows in a 2 cm…

A: This question is based on fluid mechanics. The flow in consideration is Laminar flow. Data given :…

Q: A fluid is flow through a pipe with velocity 3 m/s of diameter 1 meter and viscosity is 2 Pa s if…

A: Given  Diameter of pipe D =1 m Velocity of fluid through pipe V = 3m/s Density of fluid d = 800…

Q: Sulphuric acid is flowing through a pipe (2.5 inch diameter, 50 ft length) in a velocity of 0.006 m3…

A: Given: diameter D = 2.5 inch = 0.0635 m, A = pi.D2/4 = 0.003165 m2 Thus, V = Q/A = 0.006/0.003165  =…

Q: Liquid is flowing through a circular pipe in a laminar phase. Now, the fluid through the pipe is…

A: Given Details: Liquid flowing in circular pipe in laminar phase replaced with more viscous fluid and…

Q: Water at 30°C is being pumped through the annular area of a laboratory scale 1-pass, 1-shell tube…

A: Volumetric flow rate of water = 0.1 m3/s Inside diameter of the shell, d2 = 18.4 cm Outside diameter…

Q: Repeat problem 9.13 for the case where the fluid is water at 15°C, assuming the Reynolds number…

A: Note: Since we are entitled to answer only 3 subparts, we’ll answer the first 3. Please resubmit…

Q: mine the change in length in metre due to work by surrounding on the system of 15 kJ with

A: Work done = 15KJ = 15*10³J = 15*10³kgm²/s² Force = 300N = 300kgm/s²

Q: Water is flowing through a 30-m-long and 5-cm-diameter horizontal pipe at a rate of 9 L/s. Using…

A: We are given that  Length= L = 30 m diameter=d = 5 cm =0.05 m flow rate = Q = 9 L/s = 0.009 m3/s…

Q: Air is flowing through a horizontal tube with 1.00-in inside diameter. What is the maximum average…

A: Given data: Inner diameter of pipe = 1 in

Q: Q5:Air flows inside pipe 12 cm diameter with mass flow 1.5 kg/min. 1-Is flow laminar or turbulent?…

A: