Answered: Water flows through the Venturi meter…

Water flows through the Venturi meter as shown in the figure below. The specific gravity of the manometer fluid is 1.52. Determine the flow rate in feet cubed per second. 2 in. SG= 1.52 er

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The velocity field of a fluid v (in meters per second) has divergence div(v)(P) = 3 at the point P =…

A: The divergence of a velocity field is a scalar quantity that measures the net rate of change of the…

Q: In a simply-supported beam loaded as shown below, the maximum bending moment in Nm is 1000 mm 500 mm…

Q: Example Problem: Venturi meter system. The venturi meter shown in figure blow carries water at 60°C.…

A: P1=PA+γWy+1.18PA-PB=γ0.46-1.18+1.25×γw1.18PA-PBγ=-0.72+1.27×1.18PA-PB9.65=-0.72+1.27×1.18PA-PB9.65=0…

Q: The venturimeter shown has an pipe diameter of 500mm and narrows to a throat diameter of 200mm. If…

A: This term water flow rate refers to the amount of water that can theoretically escape from the pipe…

Q: A manometer is attached to a water tank as shown in the figure. Find the absolute pressure at the…

Q: 2. Both a gage and a manometer are attached to a gas tank to measure its pressure. If the reading on…

Q: Flow from a tank. For the tank shown in figure below, compute the velocity of flow from the nozzle…

Q: 4. In a U-tube manometer, one end is open to the atmosphere, the other end attached to a pressurized…

Q: A U-tube manometer is connected to a closed tank containing air and water as shown in the figure…

Q: Q5) For the inverted manometer of Figure , all fluids are at 20C. If pB – PA=7 kPa, what must the…

A: Pressure at height h of the fluid= density of fluid × g × height of fluid.

Q: 6. A differential manometer is attached to a pipe, as shown in figure below. Calculate the pressure…

Q: Notice in the figure, a free jet falling from a nozzle of triangular cross section. After it has…

A: Given: The entrance of the nozzle is in triangular shape with length sides l=0.19 ft. The exit…

Q: 1. The right limb of a simple U-tube manometer containing mercury is open to the atmosphere while…

Q: A fluid of specific gravity 0.8 is flowing in a pipe. The pressure drop across a flow secti between…

A: specific gravity of fluid is 0.8

Q: 4. In figure, fluids A and B have specific gravities of 0.75 and 1.00, respectively. If mercury is…

A: Given data : S.GA=0.75S.GB=1.00

Q: A flow rate measuring device is installed in a horizontal pipe through which water is flowing. A…

Q: 5.5 in. Open 1.4 in. Water Unknown fluid Open 4.9 in. 3.3 in.

Concept explainers

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with. 

Question

Water flows through the Venturi meter as shown in the figure below. The specific gravity of the manometer fluid
is 1.52. Determine the flow rate in feet cubed per second.
2 in.
SG= 1.52

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 300mm by 150mm venturi meter is installed in a vertical pipeline carrying water as shown in the figure. the flow is upward through the meter. A differential manometer containing carbon tetrachloride (sg=1.50) is attached to inlet and throat, the difference in gage levels being 750 mm. Neglecting loss of head, compute the discharge of the venturi meter.
Closed valve -Air pressure = 16 psia 4 ft Air 2 ft Water Gage fluid (y = 90 lb/ft 3) Pressure gage Consider the tank in the figure above. Determine the pressure gage measurement. Assume a reasonable value of the specific weight for water at ambient temperature in Ib/ft
Write your step by step solutions.
A fluid of specific gravity 0.8 is flowing in a pipe. The pressure drop across a flow secti between 1 and 2 is measured by a differential manometer as shown in the figure below The manometric fluid is mercury (S = 13.6). The pressure drop is Fluid (5-0.8) 2 m 0.5 m He Assume density of water is 1000 kg/m³ and g = 9.81 m/s².
A differential manometer is connected at the two points A and B of two pipes as shown below. Pipe A contains a liquid of specific gravity of 1.5 while pipe B contains liquid of specific gravity of 0.9. The pressures at A and B are 1 1.8 kgf/cm2 respectively. Find the difference in mercury level (h) in the differential manometer. (1 kgf = 9.81 N; acceleration due to gravity = 9.8 m/s; specific weight of water = 9.8 KN/m3) Sp. gr.= 1.5 PA 1 kgf /cnf 3m Sp. gr=0.9 2.0 m Pe = 1.8 kgf /cm? h O a. 0.33 m O b.0.18 m O C. 0.15 m O d. 0.74 m
The venturi meter shown below carries water at 60°C. The inside dimensions are machined to the sizes shown in the figure. The specific gravity of the gage fluid in the manometer is 1.25. Calculate the velocity of flow at section A and the volume flow rate of water. 200-mm inside diameter Flow 0.46 m y is an unknown distance y 300- mm inside diameter 1.18 m
Q1) A simple manometer is attached to a water tank, as shown in the figure below. Find the height (H) of free water surface above the bottom of the tank? Water Surface Water H Fluid Sg - 4.5 0.25 m 0.15 m
The Venturi meter shown in the sketch below, contracts the flow down to one quarter of its original area. Cold air at 0 deg C flows in the pipe through the Venturi meter. The velocity of the air upstream of the Venturi meter is equal to 40 ft/s and the pressure at the same point is equal to 30 psia. What is the manometer reading if the fluid of the manometer is water with density 1000 kg/m3 . Assume that the air behaves as an ideal gas with molecular weight equal to Mw=29 kg/kmol and constant density evaluated at upstream conditions. Use Bernoulli's equation for your calculations. please respond asap!
A 12-inch by 6-inch Venturi meter is installed in a vertical pipeline carrying water as shown inthe Figure C. The flow is upward through the meter. A differential manometer containing fluid,with sp.gr 1.67, is attached to inlet and throat, the difference z in gage levels being 5.76 ft.Neglecting loss of head, write energy equation from inlet to throat of meter. Also write stepby step equation of the differential gage between inlet and throat and combine the twoequations to compute the discharge
A manometer consists of a tube of 0.5 inch in the inner diameter and an amount of mercury (SG Hg =13.55). On one side of the tube, oil (SG=1.4) was trapped, a bubble formed, and the fluid inside was stationary. The volume of the oil was 0.6 in^3 and the volume of the air was 0.2 in^3. Now, the oil and bubble are removed. The pressure change across the air bubble is negligible and any curvature on the bubble surface can be neglected in calculating the volumes. Determine how much the mercury height rises (i.e. h 4 -h 2 ).
Water flows at 0.07 cubic meter per second through a pipe. A horizontal venturi meter with throat diameter of 150-mm was used to measure the velocity inside the pipe. Based on manometer reading, the differential gauge is deflected 1.2 meter. If the specific gravity of the manometer fluid is 1.60, the velocity, in meter per second (m/s), of water inside the pipe is ____ ANSWER ASAP