Water flows through a venturi as shown in the figure at a flow rate of Q= 12 L/s. The inlet and throat diameters of the venturi meter are (D = 4.0 cm and d = 3.5 cm) respectively. The height of water column in the manometers L, = 165 cm and L, = 50 cm respectively. %3D What is the head loss (cm) in the venturi (between 1 & 3)? Li L3 2 d 3 D

Water flows through a venturi as shown in the figure at a flow rate of Q= 12 L/s. The inlet and throat diameters of the venturi meter are (D = 4.0 cm and d = 3.5 cm) respectively. The height of water column in the manometers L, = 165 cm and L, = 50 cm respectively. %3D What is the head loss (cm) in the venturi (between 1 & 3)? Li L3 2 d 3 D

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

5. The below figure shows a pipe with a circular cross section of diameter D= 10 cm. Water enters the left end with a velocity 3 cm/s. The dynamic viscosity of water is 8.90 × 10-4 Pa·s, Find the type of flow. a. No flow b. Laminar flow с. Transitional flow d. Turbulent flow
I need the answer as soon as possible
Given : • The flow rate is 0.0015 m³/s. • The density of water is 890 kg/m3. • The head loss duc to friction is 6 m The pressure on the surface is zero gauge pressure. • The · Assume the vilocity Vtop=0 m/s Choose the correct avlue of the pressure P1 (2) (1) P1
A pipe of diameter 18 cm, is used to pump the water to the house in the Hamra hill at the height of 50 m than the ground. The discharge at the end of the pipe is 220 lit/s. The pressure gauge is fitted at the entry of the pipe in the ground is 35 N/cm². Find the following: (i) The velocity head at the entry of pipe (in m) (ii) Pressure head at the inlet (in m) (iii) Total available energy per unit weight of the water at the pipe inlet (unit in m) (Enter only the values by referring to the units given in brackets & DO NOT write the unit & do not send the handwritten answers to my mail id....) velocity head at the entry of the pipe is = (unit in m) pressure head at inlet = (unit in m) Total available energy per unit weight of the water at inlet of the pipe (unit in m) ,
Use Bernoulli's Theorem
A fan has a suction static pressure of 40mm of water vacuum with air velocity of 5m/s. The discharge has 160mm of water gage and discharge velocity of 9m/s. What is the total head of the fan if air density is 1.2kg/m3, mm of water gauge. Answer: 203.43
I need the answer as soon as possible
A (300mm) diameter of pipe, if the discharge (90 L/sec), nozzle diameter (75mm) and pipe length from (1 to 2) was (100m) Determine the length of pipe from (2 to 3), and the pressure at point (2). (e-0.026mm, v1.13" 10 m?/sec). Fig(1) 6m 23m Fig.(1) Nozzle
A pipe of diameter 12 cm, is used to pump the water to the house in the Hamra hill at the height of 60 m than the ground. The discharge at the end of the pipe is 200 lit/s. The pressure gauge is fitted at the entry of the pipe in the ground is 34 N/cm?. Find the following: (i) The velocity head at the entry of pipe (in m) (ii) Pressure head at the inlet (in m) (iii) Total available energy per unit weight of the water at the pipe inlet (unit in m) (Enter only the values by referring to the units given in brackets & DO NOT write the unit & do not send the handwritten answers to my mail id...) velocity head at the entry of the pipe is = (unit in m) pressure head at inlet = (unit in m) Total available energy per unit weight of the water at inlet of the pipe
A pipe is horizontal and carries oil that has a viscosity of 0.14 Pa s. The volume flow rate of the oil is 5.3 × 10^-5 m3/s. The length of the pipe is 38 m, and its radius is 0.57 cm. At the output end of the pipe the pressure is atmospheric pressure. What is the absolute pressure at the input end?
The inlet and throat diameters of a horizontal venturimeter are 30 cm and 15 cm respectively. The liquid flowing through the meter is oil S = 0.92. The pressure intensity at inlet is %3D 16 N/cm while the vacuum pressure head at throat is 40 cm of mercury. Find rate of flow, Assume, C = 0.9746.
The total head of fan is 200m and has a static pressure of 201mm of water gage. What is the velocity of air flowing if density is 1.16kg/m3. ANSWER: 22.9