Water flows through a 5 inch diameter pipe at 10 ft/s. If a test is performed using mercury moving at 4 ft/s, what diameter pipe (in inches) would be needed to maintain the same dynamic characteristics? Both fluids are at standard temperature and pressure. Hint: What dimensionless number do we use all the time for pipes?

Water flows through a 5 inch diameter pipe at 10 ft/s. If a test is performed using mercury moving at 4 ft/s, what diameter pipe (in inches) would be needed to maintain the same dynamic characteristics? Both fluids are at standard temperature and pressure. Hint: What dimensionless number do we use all the time for pipes?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Question 30 The minor losses in pipes is a factor usually of which head component? velocity head total head pressure head O elevation head
i need ans very very fast in 20 min and thank you | ᴅʏʙᴀʟᴀ ?✨؛
1. The represents the roughness of a pipe whereas the Icoefficient accounts for the roughness of the channel. (you may provide letters or words for the blanks) 2. Complete the table below Pipe flow Laminar Res Turbulent flow: Re 2 Channel Flow Laminar Re ≤ Turbulent flow: Re 2
Q1/ A liquid has a specific weight of 59 lb/ft³ and a dynamic viscosity of 2.75 lb-s/ft². Determine its kinematic viscosity.
The velocity through the throat of a venturi meter is four times that of the velocity through a pipe that has a diameter of 0.5 m. How much is the deflection of the mercury levels in mm if the reported discharge is 0.01 m³/s? Use cp = 0.6. Pressure-sensing holes Throat section Deflection Mercury
A differential "U"-tube manometer containing mercury of density 13000 kg/m³ is used to measure the pressure drop along a horizontal pipe. If the fluid in the pipe is water and the manometer reading is 0.65m, what is the pressure difference between the two tapping points? Fluid density Pw A B a b datum Manometric fluid density p Hg Figure of manometer setup
Complete answer
Express your solution in 4 decimal places.
Explain briefly how you would determine if the flow in a pipe was certain to be laminar
I need the answer quickly
After being filled to a depth d with SAE 30 oil (SG = 0.91), a glass is placed to float in a tank of water. What is the maximum permissible value of d so that the water level will just barely reach the brim of the glass, as shown? Assume that the SG of the glass is 2.55. icin-2 in 4 in. SAE oll Water
Question- topic fluid materials.