Answered: Water flows steadily through the large…

Water flows steadily through the large tanks shown in fig. Find the water depth, ha Ans. (hA = 15.4 m) %3D (1) 0.03 - mn diameter (2) |(3) 0.05 - m diameter hB = 2 m (4)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 2. Three reservoirs A, B, and C are connected respectively with pipes 1, 2, and 3 joining at a…

Q: 12: For the given figure, r₁ = 30 m r₂ = 10 m H = 20 m t = 15 m Q = 13 L/s h = 13.6 m h₁ = 17.6 m h₂…

Q: 4. Using the figure below, find the time it takes for tank 2 to increase water level by 2m. (C =…

Q: For the dam indicated in the figure below, the flow network was drawn according to Casagrande…

A: Step 1: Determine the parameters based on the student's RAFor RA where:- X = 6- Y = 1- Z = 0…

Q: Water at flows in the system shown. The density of the water is 1.94 slugs/ft', and the viscosity is…

Q: The flow through the aquifer can also be calculated from the equation

A: Q=-T *dh/dx=qx Where T= Transmisibility h= head X= distance between two points q = Discharge per…

Q: Use the constant head permeability to find (K) in diameter cylinder 65 mm ,the length= 45 mm , AH=12…

A: Given-discharge=22cm3/dayConstant head causing flow=12mm=1.2cmlength=45mm=4.5cmDiamter =6.5cm

Q: Current Attempt in Progress Determine the elevation difference, Ah, between the water levels in the…

A: So,Using pressure equation between both tanksPA-γwh+Sγw0.4+γwh-0..4+γwΔh=PBTaking PA=PB=PAtm=0

Q: There is a capillary action that takes place above the groundwater table up to 1.3 m in height.…

Q: Please show illustrations. If the water surface elevation in reservoir B is 110m, what must be the…

Q: In fig. if water level = 2 m and the liquid * ?--- =S.G=0.85 , hl %3D Water Ah A' B' 2.35 m. 3.35 m…

Q: Calculate: a) Frictional Losses and the total loss in the suction and delivery pipes (m) b) Total…

Q: vertex. 1. Find the volume of its content in m³. a. 0.318 b. 0.357 c. 0.453 d. 0.678 2. Find the…

A: Step: 1 Cone: - It is defined as a structure whose shape tapers smoothly from base to vertex. Cone…

Q: 5. According to the constant-head permeability test, calculate the hydraulic conductivity in cm/sec.…

Q: There is a capillary action that takes place above the groundwater table up to 2.3 m in height.…

A: Due to capillary rise above the ground water table(GWT), the soil above GWT remain saturated but due…

Q: schematic of a constant head permeability test is shown below. The measured essures at points A and…

Q: The sludge hopper of a sedimentation tank is approximated as a truncated square prism provided with…

A: Solution: Orfice daimeter=100 mm=0.1 mCd=0.62 As per Diagram

Q: The hydraulic conductivity of soil is O a. proportional to the unit weight of water flowing through…

Q: 5) The piping phenomenon in the downstream of water structures could take place at a critical…

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: Given: Flow rate of water = 500 L/min Suspended solids concentration in influent water = 100 mg/L…

A: As per guidelines, only first question is been solved.

Q: I needed help with part b

Q: Determine the water flow rate of hydraulic system shown in Fig. (neglected the . minor losses) $00…

Q: 12. For the Dam shown in the figure a) Draw the flow net in the soil under the dam b) Calculate q…

A: Note :- nothing said about how many flow lines and equipotential lines to be drawn so taking it as…

Q: a) Reduce the water level by Im, b) Empty the tank

Q: As shown in the figure compute the amount and location of the vertical and horizontal components of…

A: Given data,radius is 7.5mL=10mFINDAmount and location of vertical and horizontal component

Q: 5. Field Permeability Testing Calculate the permeability of the soil from a confined aquifer given…

A: Note: Hi! Thank you for the question As per the honour code, We’ll answer the first question since…

Q: The rectangular channel is 2 m wide, and the depth of the water is y₁ = 1.6 m as it flows with an…

Q: please give exact solution A pipe with a diameter of d is used to transport an incompressible fluid.…

A: Reynolds Number Re=Inertial forcesViscous forces =ρVavgdμ we do not have any of these data to…

Q: What will be the diameter (in mm) of a water droplet, the pressure inside which is 0.05 N/cm²…

A: Given data- Pressure inside water droplet-P=0.05 N/cm2Surface tensionσ=0.075 N/mTo Find-Diameter of…

Q: 3. A permeameter is filled with sand. When water is allowed to flow through the device, a flow rate…

A: The given data is: Qwater=10 cm3/s ρoil=0.9 ρwaterμoil=1.8 μwater

Q: 1.GIVEN: The vessel is initially full. Do = 200 mm %3D C = 0.8 REQUIRED: Time to empty the vessel.…

Q: A cylinder of cross- sectional area 3500 mm is filled with sand of Overfow permeability 6 mm/s.…

A: Solution Given Data Cross-sectional area= 3500 mm2 Permeability= 6 mm/s

Q: A field pumping test was conducted from an aquifer of sandy soil of 4 m thickness confined between…

Q: Show that at saturation the water content is: @=Yw ( Starting from Se = wGs 1 Ya Ys

Q: a. Find Q in [cfs] b. Draw the EGL and HGL for the system. Be precise when drawing so your graphs…

A: Elevation of Reservoir A= 120 ft Elevation of Reservoir B= 100 ft Pipe length of reservoir A=12800…

Q: A fluid with a kinematic viscosity equal to 2,951E-5 ft2/s moves within the section Shown. It is…

A: Given, Re = 27066 v = 2.915 x 10-5 ft2/s

Q: 88.18 liters of a distinct liquid weig ermine its density ( D0 liter = 1 m3

A: Given data- Mass(m) = 417.91kg Volume(V)= 388.18 lit 1 m³ = 1000 lit Volume(V)= 388.18 lit =…

Q: What will be the diameter (in mm) of a water droplet, the pressure inside which is 0.05 N/cm²…

Q: Provide complete solution. A frustum of a cone is shown, with the orifice at the bottom. C_d=0.62.…

Q: For the pipe assembly shown if F = {34i - 51j + 69k} N, Determine: The magnitudes of the component…

A: Force(F)=(34i-51j+69k), Force acting at point C.

Q: What will be the diameter (in mm) of a water droplet, the pressure inside which is 0.05 N/cm²…

A: Given Data The pressure inside the water droplet = 0.05 N/cm2 The surface tension T = 0.075 N/m We…

Q: By what factor will the hydrostatic force on ne of the vertical sides of a beaker decrease the…

A: Fluid mechanics: option c

Q: p 18.46kPa Figure 34(01)A A OR, s 0.8 7 m 6 m 2 m

Q: For the constant head permeability test apparatus shown, cross-sectional area A flow, distance /…

A: We are given the following information: Cross-sectional area (A) = 78.5 cm² Distance between…

Q: Consider two wells separated a distance L from each other. Assume porous media with v=-(K/μ)Vp where…

A: Streamline Flow : The flow of the water is determined by streamflow. The flow of fluid in case of…

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

Water flows steadily through the large tanks shown in fig.
Find the water depth, hA
Ans. (ha = 15.4 m)
%3D
(1)
hA
0.03 -m diameter
(2)
A
(3)
0.05 - m diameter
hB = 2 m
(4)
B

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

In fig. FV = Water --? If the tank width is 5 m (into the paper) 4m 0 5m C 5m B 1941.6 N 1941600 KN 1941.6 KN
Q:/Gage A shown in Figure No (2) reads 4 (Bar). Find the reading of Gage B. If the value of PA is not equal to the value of PB. Mention the REASON. 1m P.=150 (KN/m²) compressed air h water PA PB 1.2m Mercury A Fig.(2)
92 Calaulate the flow rate of the each pipe is given belowi O.120m/s (4) K2=2 (2) Ku=4 (3) (5) Es=5 0.040 m/s O-030 ms The initial value of the flow rate for pipes ore gren as Ri=0.07 /s 92=0.05 m/s 93= 0.01 m% Q4=0,01ms and Q5=0,03 m3
What is the density in the throat section? What is the area in the throat section? What is the velocity in the throat section?
An unconfined aquifer is 10 m thick and is being pumped so that one observation well placed at a distance 76 m shows a drawdown of 0.5 m. On the opposite side of the extraction well is another observation well 100 m from the extraction well, shows a drawdown of 0.3 m. Assume the coefficient of permeability of 50 m/day. a.) What is the discharge f the extraction well? b.) Suppose the well at 100 m from the extraction well is now pumped. Show with a sketch what this will do to the drawdown. c.) Suppose the aquifer sits on an aquaclude that has a slope of 1/100. Show with a sketch what this will do to the drawdown.
If the water surface elevation in reservoir B is 110 m, what must be the water surface elevation in reservoir A if a flow of 0.03 m^3/s is to occur in the cast iron pipe. Use f= 0.0021 for all pipes. Include minor losses. (DO NOT ROUND OFF)
answer number 2.show your solution asap
3. Determine the resultant of the three forces acting on the dam shown in the figure and locate its intersection with the base AB. Required: Resultant and its intersection with the base AB Solution: P-10,000 lb -24,000 f F-6000 tb
i need the answer quickly
Please aid me with this, i will also need to learn how to do this.
QI. s) Q1: A 1 m diameter well penetrates vertically through a confined aquifer (30 m) thick. When the well is pumped at (2712 m³/day), the drawdown in a well 15 m away from pumped well is 1.8 m; while the drawdown in another well 50 m away from pumped well is 0.5 m. Take the maximum head is 40 m. 1- Determine the transmissivity. 2- What is the approximate head in the first well? 3- What is the approximate head in the second well? 4- What is the approximate head in the pumped well for steady-state conditions? 5- What is the approximate drawdown in the pumped well?