Water flows in the canal of trapezoidal cross section shown in Fig. The average velocity inthe canail is 10.2 ft/sec. Determine the F, and R, for this flow.y= 5 ft12 ft

Answered: Image /qna-images/answer/e2334a04-e7b9-4e56-9425-dae143a6097d.jpg

Answered: Water flows in the canal of trapezoidal…

Water flows in the canal of trapezoidal cross section shown in Fig. The average velocity in the canal is 10.2 ft/sec. Determine the F, and R, for this flow. yD5tt 12 ft

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Q- 7 If the slope of a chanel is 1/225 and 1/625. Then find the ratio of the discharge for this…

A: Given data- slope of a chanel-S1= 1/225 S2=1/625To Find-The ratio of the discharge

Q: For the half-Vee channel in Fig., let the interiorangle of the Vee be θ. For a given value of area,…

A: Write out Manning's formula

Q: A critical flow can occurs when оа. Humping(Raising) in the bottom of the channel Abrupt change in…

A: Introduction : Critical flow : When the flow velocity in a channel equals the wave velocity created…

Q: 90o (total angle) V-notch

A: FM3

Q: An open channel of most economical section of a trapezoidal cross section is required to pass 36000…

Q: 6) Determine the critical velocity in ft/s in a rectangular channel with base width 10ft if the flow…

A: The given data is shown below: Base width=10 ftFlow rate=200 cu.ft/s

Q: mean velocity and discharge of a trapezoidal channel in which depth of flow is 3.0 m. The channel is…

Q: Q4/ A trapezoidal open channel. Flow rate in the channel Q = 150 (m3/s), Cross -sectional area of…

A: Given: A = 100m2 P = 150m y = 5m So = 0.0001 n= 0.025 m1/3/s

Q: Water flows in the canal of trapezoidal cross section shown in Fig.. The average velocity in the…

Q: - A trianqular oPen channeL with (o.25m) depth and 60 angle conveys water. if the bed slope is (1:…

Q: A trapezoidal channel has a bottom width of 6 m and side slope of 2 horizontal and 1 vertical when…

Q: For vertical gate, the flow condition was classified as submerged flow: (a) if t (c) if both (&) > 1…

A: A vertical sluice gate for which we need to choose a flow condition for submerged flow

Q: A trapezoidal channel lined with concrete, C=130,B=10m, side slope=1:1,depth=5m,channel slope…

A: It is required to determine the top width of channel. T=b+yz1+z2 Here b is the bottom width, y is…

Q: Determine the discharge, in L/s,

A: Solution: Givendata, Weir head = 0.30 m weir sides = 14.04 length of crest = 2m

Q: 4.a. Describe the characteristics of flow profile in prismatic channel?

A: Prismatic channels are those channels having a straight alignment and constant bottom slope,…

Q: Uniform flow occasionally occurs in a 5-m-diameter circular concrete condui flow can vary. The…

A: Discharge or rate of flow (Q), is defined as the amount of fluid flowing per second through a pipe…

Q: --1. For supplying water to a colony, it is intended to store water in a Targe tank, whose water…

Q: A rectangular channel carries 6.0 m³/s. Calculate the

A: Given: A rectangular channel carrying discharge, Q=6 m3 /s width, B=4 m To calculate: critical…

Q: B- For the Given canal section the sides of canal tilted at un angle 30" with the horizontal…

Q: 5. How is absolute velocity at inlet denoted? a) V b) V1 c) C d) v

Q: A regime channel carries discharge of 25 m³/s. If the dmm-0.25 mm. Find the slope of bed.

A: given- discharge Q=25 m3/smean size dmm=0.25 mm

Q: S Q1: An open channel of trapezoidal section has side slope of 2 horizontal to 1 vertical and…

A: Given:- Open channel having trapezoidal section Side slope of 2 horizontal and 1 vertical Rate of…

Q: Given Q=12.5m³/sec, Z-1, n=0.0225 and S.-30cm/km. Design the canal cross-section and check the…

A: Flow rate in canal Q = 12.5 m3/sSide slope Z = 1Manning's coefficient n = 0.0225Canal Bed slope = 30…

Q: For a rectangular channel of 20m width, construct a family of specific energy curves for Q = 0, 50,…

A: Specific energy Energy per unit mass is known as specific energy or massic energy. It's also known…

Q: A pipeline ABC 300 m long, is laid on an upward slope of 1 in 60. The length of the portion AB is…

Q: In a rectangular open channel, 2.0 m wide, water flows at a depth of 0.8 m. It discharges over an…

A: given- width B=2 mdepth y=0.8 mCc=0.612g=4.43H=0.25 m

Q: 7. A rectangular channel, 20 feet wide, carries a discharge of 200 cfs. Compute the critical depth…

Q: Find the critical depth of a rectangular channel having a width of 6 ft. which carries a discharge…

A: Given data Type of the channel = Rectangular Width of the channel (B) = 6 ft Discharge (Q) = 120…

Q: A pipeline consists of successive lengths of 325mm, 300mm, and 150mm diameter pipe with a continuous…

Q: Water flows in a triangular channel of side slope 1 horizontal: 1 vertical and longitudinal slope of…

Q: A trapezoidal channel carry water at a rate equal to 10 m3/sec, Manning's n is 0.02 and bed slope is…

Q: cement lined rectangular channel (20ft) wide Carvies Water at arate flow (nooff/sec) Assuming…

A: B=20ftQ=400ft3/sn=0.0121.yc ,vc2. slope at y=4ft3.slope at y=1ft

Q: ind the critical depth of flow for a trapezoidal channel with a bottom width of 8 m, and a side…

A: Any of the designing of the Trapezoidal cross-section is basically done for the critical flow…

Q: An open channel has a cross-sectional area of flow of 0.5 m² a hydraulic radius of 0.15 m and a…

Q: A 180 degree horizontal bend narrows from a 14in. diameter upstream to a 10in. diameter downstream.…

A: Since the question comprises of a number of subparts, the solution for first three subparts is as…

Q: EL (H7-3) 4 y,y2 = power loss due to jump in rectangular channel can be estimated by the following…

A: ρ symbol used here to indicate the density of fluid.

Q: What is the depth of normal flow and slope of a rectangular channel to conduct 5 m³/s of water a…

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

Water flows in the canal of trapezoidal cross section shown in Fig. The average velocity in
the canail is 10.2 ft/sec. Determine the F, and R, for this flow.
y= 5 ft
12 ft

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A wide open rectangular channel, 5.51-meter wide, the critical velocity is 7 m/s. Compute for the critical flow (m3/s) of the channel.
How to solve the problem ( topic open channel)
hydraulics - open channel flow
50 ft 7/3 3/7 8/4 4/8 30 ft. -100 ft- k=k, 4 x 10-4 in./sec 60 ft What is the number of flow channels over the number of equipotential drops (Nf/Nd) ratio?
3
Q4] A triangular channel of apex angle 90° and a rectangular channel of the same material have the same bed slope. If the rectangular channel has the depth of flow equal to the width of the channel and if the flow areas in both the channels are the same, find the ratio of discharges in the rectangular and triangular channels respectively.
2-3 A channel of rectangular cross section and width 4 m is carrying a discharge of 2 m3/s at a uniform depth of 1.5 m. if Manning's n for the channel is 0.012, Find the slope of the channel in % and in m/km
(3-1) A rectangular open channel carries 22m/s with a bottom width of 5m and a water depth of 2m. The engineer has a plan that the channel bed is raised by the 0.2m height of hump and the channel width is also reduced to 4m at the same downstream section. Assume that any friction energy loss is negligible in the channel a) Demonstrate mathematically whether the flow is the sub-critical or super-critical at the upstream section b) Calculate the critical velocity at the downstream section. c) Calculate the height of hump which cause the critical flow condition at the downstream section d) Evaluate whether the choking flow condition occurs or not at the downstream section e) Calculate the upstream water depth to cause the flow at the downstream section if the choking flow condition prevails.
A pipe system is using a lake as water source at elevation Om. The water is supplied in a reservoir tank with target elevation of 200m. The water system has a pipe length of 1.5 kilometers, diameter of 600mm, friction factor f = 0.02, and carries 1750 L/s uphill. %3D Determine the head in meters that the pump must add in the gradeline.
None
5. Determine the slope of a channel if it has a bottom width of 20 ft, side slope of 2:1, water depth of 3.36 ft, discharge of 400cfs and n= 0.025.
Uniform flowWe will observe the stretch of the Salt River below Stewart Mountain Dam, Arizona. If the width of the river is 60 feet, the discharge is 150 cfs, the bed slope is 0.001, and n = 0.032, what is thenormal depth of flow assuming extra-wide and shallow conditions? What is the normal depth of flowif a rectangular cross-section that is not extra-wide and shallow is assumed?