Water flows from a large tank through a narrow pipe. Height differencebetween the opening on the tank and the surface of the water is h 15.0 m.The cross-sectional area of the thicker part of the pipe is0.055 m2 and the narrower partA2A1density of the water is p = 1000 kg/m³.if V1 = = 47. 19 m/s,= 0.020 m2. The%3D17.16 m/s and V2%3D%3Dwhat is the amount of water flowing through the pipe?a) 343 kg/sb) 944 kg/sc) 2595 kg/s

Formula of mass flow rate of liquid is as follows; dmdt=ρA1v1=ρA2v2…

Water flows from a large tank through a narrow pipe. Height difference between the opening on the tank and the surface of the water is h 15.0 m. The cross-sectional area of the thicker part of the pipe is A1 = 0.055 m² and the narrower partA2 = density of the water is p = 1000 kg/m³. if V1 = 17. 16 mls and V2 = 0. 020 m². The %3D 47.19 m/s, %3D %3D what is the amount of water flowing through the pipe? a) 343 kg/s b) 944 kg/s c) 2595 kg/s

Water flows from a large tank through a narrow pipe. Height difference between the opening on the tank and the surface of the water is h 15.0 m. The cross-sectional area of the thicker part of the pipe is A1 = 0.055 m² and the narrower partA2 = density of the water is p = 1000 kg/m³. if V1 = 17. 16 mls and V2 = 0. 020 m². The %3D 47.19 m/s, %3D %3D what is the amount of water flowing through the pipe? a) 343 kg/s b) 944 kg/s c) 2595 kg/s

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

The density of water is 1.0g/cm3 and the density of oil is 0.80g/cm3. The height L in the U-tube shown below is: 3cm oil Lem 1 water Select one: O a. 5 cm O b. 15 cm O c2 cm O d. 10 cm O e 1 cm
A container has a large cylindrical lower part with a long thin cylindrical neck open at the top. The lower part of the container holds 19.5 m3 of water and the surface area of the bottom of the container is 7.80 m2. The height of the lower part of the container is 2.50 m, and the neck contains a column of water 8.50 m high. The total volume of the column of water in the neck is 0.200 m3. What is the magnitude of the force exerted by the water on the bottom of the container? in MN
A container has a large cylindrical lower part with a long thin cylindrical neck open at the top. The lower part of the container holds 22.2 m3 of water and the surface area of the bottom of the container is 8.90 m2. The height of the lower part of the container is 2.50 m, and the neck contains a column of water 8.50 m high. The total volume of the column of water in the neck is 0.200 m3. What is the magnitude of the force exerted by the water on the bottom of the container? _____ MN
A cylinder that is hi = 18.5 cm tall and open on top is filled with water. If a hole is made in the side of the cylinder, Ah Ah = 3.40 cm below the top level, how far x from the base of the cylinder will the stream land? h, Assume that the cylinder is large enough so that the level of the water in the cylinder does not drop significantly. cm
Mercury is poured into a U-tube as shown in Figure a. The left arm of the tube has cross-sectional area A, of 9.8 cm², and the right arm has a cross-sectional area A, of 5.50 cm². Two hundred gra 8 ст of water are then poured into the right arm as shown in Figure b. Water A1 Ag A1 Mercury Densities: Mercury 13.6 g/cm³, Water 1.0 g/cm³ (a) Determine the length of the water column in the right arm of the U-tube. cm (b) What distance h does the mercury rise in the left arm? cm. (c) In figure b, at the level of the dashed line, which side of the u-tube has larger pressure? O Mecure side Water side Same
Blood pressure is normally taken on the upper arm at the level of the heart. Suppose, however, that a patient has his arms in a cast, so you cannot take his blood pressure in the usual way. If you have him stand up and take the blood pressure at his calf, which is 87.5 cm below his heart, what would be the Ap = mmHg magnitude Ap of the difference between this measurement of blood pressure and a normal blood-pressure measurement? The density of blood is 1060 kg/m³. Is the blood pressure measured at the calf larger or smaller than the blood pressure measured at the upper arm? O larger smaller
To verify her suspicion that a rock specimen is hollow, a geologist weighs the specimen in air and in water. She finds that the specimen weighs twice as much in air as it does in water. The density of the solid part of the specimen is 3.61 x 103 kg/m³. What fraction of the specimen's apparent volume is solid? Number Units
An empty cylindrical 1L water bottle with the mass of 30 g floats upright in a pool. The radius of the bottle is 5 cm. Water density: 1.00 g/mL I calculated volume, depth, and pressure: Volume = m/p = 30 cm^3 ? Depth = V/ r^2 * pi = 0.38 cm ? Pressure = pgh = 1 g/mL * 9.8 m/s^2 * 0.38 cm = 3.7 Pa ? a) What force is exerted by pressure on the bottom of the bottle and what is the weight of the bottle? b) What is the pressure at a 15 cm depth?
A person is diving in a lake in the depth of h = 10.5 m. The density of the water is ρ = 1.0 x103 kg/m3. The pressure of the atmosphere is P0 = 1.0 x 105 Pa. The surface area of the top of the person's head is A = 0.0335 m2. a. Express the absolute pressure at the depth of h, P, in terms of P0, ρ, and h. b. Calculate the numerical value of P in Pa. c. Express the magnitude of the force exerted by water on the top of the person's head F at the depth h in terms of P and A. d. Calculate the numerical value of F in N.
A symmetric U-tube is open to the atmosphere at both ends. Water with a density 1x10^3 kg/m^3 is poured into a tube until the water rises halfway along the straight sides. Then some unknown liquid with a density of 8.5 x 10^2 kg/m^3 is poured into one end. This causes the water surface on that side to go down by 9mm. Calculate the height of the unknown liquid in the tube, h.
You put a marble on a balance and find it has a mass of 1.2 grams. It is an irregular shape, so you need to do displacement to find its volume. You put it in a graduated cylinder with a starting volume of 30.0 mL of water. After you add the marble, the water rises to 31.5 mL. What is the density? Group of answer choices 0.038 g/mL 1.3 g/mL 0.80 g/mL 1.8 g/mL
Oil (p = 920 kg/m³) is flowing through a pipeline at a speed of 1.88 m/s. If the diameter of the pipe is 0.16 m, what is the %3D mass flow rate? kg/s