Answered: Water flows from a drain spout with an…

Water flows from a drain spout with an initial velocity of 1 m/s with angle of 15°. Determine the range (d) of values of the distance (d) for which the water will enter the trough BC *

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The diameter of a pipe at the section 1 and 2 are 10 cm and 15 cm respectively. Find the discharge through the pipe if the velocity of water flowing through the pipe at section 1 is 5m/sec. Determine the velocity at section 2.
Water flowing through a contraction pipe with diameter of 20mm and 5 mmrespectively. If the velocity of water at the larger diameter is 0.5 m/s, determine the discharge in the pipe and the velocity at the smaller diameter. Based on your result,state the correlation between flowrate and area of pipe diameter.
A 150-m-wide river flows due east at a uniform speed of 2.0 m/s. A boat with a speed of 6.0 m/s relative to the water leaves the south bank pointed in a direction 30° west of north. (a) Draw the vectors triangle using scale 1.0 cm : 1.0 m/s and label the corresponding relative velocities. (b) Determine the magnitude of the boat's velocity relative to the ground. (c) Determine the direction of the boat's velocity relative to the ground. (d) Find the time for the boat to cross the river. SS
7.60 PLUS The pump shown draws water (20°C) through a 20 cm suction pipe and discharges it through a 10 cm pipe in which the velocity is 3 m/s. The 10 cm pipe discharges horizontally into air at point C. To what height h above the water surface at A can the water be raised if 26 kW is delivered to the pump? Assume that the pump operates at 60% efficiency and that the head loss in the pipe between A and C is equal to 2 V/2g. Assume a = 1.0 throughout. Pump C Water PROBLEMS 7.59, 7.60
Ballast Dropped from a Balloon A ballast is dropped from a stationary hot-air balloon that is hovering at an altitude of 520 ft. The velocity of the ballast after t sec is -32t ft/sec. Ballast (a) Find the height h(t) (in feet) of the ballast from the ground at time t. Hint: h'(t) = -32t and h(0) = 520. h(t) = -162. + 520 (b) When will the ballast strike the ground? (Round your answer to two decimal places.) 16.25 X sec (c) Find the velocity of the ballast when it hits the ground. (Round your answer to two decimal places.) ft/sec
For the system of pipes shown, the flow of water in pipe (3) is 25 L/s. Find: The flow in pipes (1) and (2): Q1 =……………….., Q2 =…………………. The difference in head between the two tanks is H =………………… f1:0.016 f2:0.028 f3:0.018
A sharp-edged orifice of 12.5 mm in diameter has a coefficient of discharge of 0.6 and is situated in the base of a closed tank. At a given instant the head of water above the orifice is 1.8 m. The density of the water is 998 kg/m3. If the discharge of water is to be 90 kg/min at this instant, calculate against which pressure the air must be pumped in the tank above the water.
correction the given its + sign not - (0.14 t^4 + 4.1t^3 + 0.12t^2) answer by step thank u..
A fan impeller is 800 mm in diameter and rotates at a constant angular velocity of 600 rpm. Determine the tip speed, i.e. the circumferential velocity, of its blades.
A ship is approaching the dock at 45 cm/s . A landing equipment was left on the dock and needs to be thrown to the ship just before it can dock. The equipment is thrown 15 m/s at 30o with the vertical from the top of the tower 8.75m above the ship deck. Compute the distance from the deck to the ship be at the instant the equipment is thrown.
2. Two interconnected pipes A and B with 300 mm and 200 mm diameter, respectively, carries a flow of 0.116 m3/s. Determine the velocity in m/s of pipe A and pipe B. If pipe B was replaced with 400 mm diameter, determine the velocity in m/s of pipe B.