Water flows at a steady rate in this vertical pipe. The pressure at A is 10 kPa, and at B it is 98.1 kPa. What is the direction of flow?

Q: Q. 2 Find the flow rate of water in each pipe and the pressure at point 3. Neglect the minor losses.…

A: Many combinations of pipes are connected in series, parallel, or complex networks. So by writing the…

Q: Question 4 Water flows upwards in a vertical (plane) pipe line of gradually varying cross section…

A: Given- Head difference between point 1 & 2 = 1.5 m, Discharge Q=0.9 m3/s, Diameter at section 1…

Q: In the parallel system shown, pipe 1 has a length of 3000 ft and 20-inch in diameter. Pipe 2 is 5000…

A:

Q: The pressures at the ends of 605m long horizontal pipe flow are 350kPa and 270kPa. The pressure at…

A:

Q: ASAP. Please answer the question properly with a complete solution. A non-rigid steel pipe 70 cm in…

A:

Q: x 75 mm venture meter is inserted in a 300 mm diameter main pipe where water flows at 55 L/s.…

A:

Q: Water at 40°C (p=62.42 lbm/ft³ and u=1.038×10 diameter 30-ft-long horizontal pipe at an averag (b)…

A:

Q: Solve for the water discharges in cach steel pipe as shown in Figure 3. You may assume that the…

A:

Q: At A, water (rho=1000kg/m* 3 and mu=1cp) at a pressure of 400 kPa and a velocity of 3 m/ s, flows…

A:

Q: PB = 2.3 PA 2 bars 30° 2m

A: Pressure at A, PA=2 bars =200KPaPressure at B, PB=2.3 bars =230KPa.Diameter of pipe at A,…

Q: The pressure at a point inside a horizontal domestic pipe is 30 psi. It has a diameter of 4-in. and…

A: The problem can be graphically expressed as follows: The pressure inside a point inside the pipe is…

Q: Water flows through a pipe at 14 cfs. At a point where the pipe diameter is 18 in, the pressure is…

A:

Q: 1. A pressure gage 6m above the bottom of the tank containing a liquid reads 90kPa. Another gage…

A:

Q: 2. Water at 100C is flowing from point A to point B the 600-mm B inside diameter through pipe shown…

A:

Q: A water pipe gradually changes from 150 mm at a point X to 450 mm at point Y. Point X is 5 m below…

A:

Q: Water at 65 degrees Celsius is flowing horizontally at a rate of 84.1 m^3/hr in a pipe. It enters a…

A: Answer We can determine the magnitude and direction of the force by using the equation of motion.…

Q: A horizontal pipe has two sections with diameters 5'7" and 1'1" respectively with a smooth…

A:

Q: A glass of water is filled to a height of 0.5 ft. Find the hydrostatic pressure at the bottom of the…

A: Hello dear this is the solution of your problem The answer is found to be Pressure at the bottom of…

Q: A pipe carries a flow of 5.17 cfs of oil (SG = 0.877). At one diameter is 6 inch, the pressure is…

A: Flow of oil in the pipe, Q = 5.17cfs , Specific Gravity of oil = 0.877 , d1= 6 in , p1= 13.2 psi =…

Q: Question 2 A concrete block is attached to the gate as shown. If the water level is 1.5 m from the…

A:

Q: ill be the flowrate? The pipes are galvanized iron with k, = 0.0005 ft. Take v = 1.06 x 5 ft/s and…

A: To find:Flow rate

Q: A non-rigid steel pipe 70 cm in diameter is to carry a maximum of 2,830Pa and additional pressure…

A:

Q: The Darcy friction factor for both of the pipes shown is 0.024. the total flow rate is 300 m3/h.…

A: Given Friction factor for both pipes is 0.024 Total flow rate is 300 m3/h.

Q: A horizontal 150mm diameter pipe gradually reduces its section to 50mm diameter, subsequently,…

A: P1= 140KPa P2 = 70 KPa

Q: SUBJECT IS HYDRAULICS SHOW DETAILED AND COMPLETE SOLUTION USED 3 DECIMALS FOR THE FINAL ANSWER The…

A: Given

Q: Q1:- Find the cast iron pipe size to carry laminar flow. Length of pipe was 200m, friction losses…

A: The frictional loss is given by: hf=fLV22gD Where, f = Friction factor L = Length of pipe hf =…

Q: There s a leak in a horizontal 30cm pipeline (f=0.025). Upstream from the leak two gages 600m apart…

A:

Q: A steel pipe has an inside diameter of 25mm, is 20 meter long, carries 10degree water at the rate of…

A: what is the static pressure of the water at the outlet,P2=?

Q: A pipe carrying water tapers from a diameter of 600 mm at 'A' to a diameter of 200 mm at 'B'. At 'A'…

A:

Q: Water is flowing in a straight concrete lining centrifugally spun pipe as shown in the figure…

A: The given data is: Length of pipe=310 m Difference between gauge reading, hf=185 kpa…

Q: 6. A horizontal 150 mm diameter pipe gradually reduces its section to 50 mm diameter, subsequently…

A: Given data in question  Diameter  Pressure  Head loss To find out  Discharge

Q: Water flows through a vertical constriction (venturi) section. Piezometers are attached to the…

A: step 1-

Q: Oil of viscosity 0.1 Pa.s and specific gravity 0.90, flows through a horizontal pipe of 25 mm…

A:

Q: An orifice in a 30 degree plane from horizontal as shown has its vena contracta at elevation 10.7m.…

A: The correct answer is (a) 0.983 Using Formula, u = Cd under root2gh

Q: A drain pipe exits a reservoir as shown. What is the pressure head at point 2?

A:

Q: Determine in psi the pressure drop between the ends of this duct.

A: Given data: P1=0.0406 lb/in2. P2=0.022 lb/in2.

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?