Water enters a 10-cm-diameter pipe steadily with a uniform velocity of 3 m/s and exits with the turbulent flow velocity distribution given by u = umax (1 - r/R)1/7. If the pressure drop along the pipe is 10 kPa, determine the drag force exerted on the pipe by water flow.

Q: SA в

A:

Q: Consider a flow of SAE 30W oil at 20°C through a 2.4-cm-diameter smooth pipe at 1 million N/h.…

A:

Q: the pump power required to overcome the pipe friction losses in the lake section.

A: Given datathe diameter of the pipe D= 40cm=0.40mthe average velocity of the oil V=0.5 m/sthe length…

Q: Water is being heated in a straight pipe with an inside diameter of 2.5 cm. The heat flux is uniform…

A: Given data: The properties of water at 20 degrees Celsius are:

Q: The fluid condition at the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle…

A: h1=3089 KJkgc1= 229 kmhrc1= 229×518=63.61 msech2= 2569 Jkg v2= .63 m3kgA1=.2 m2v1=.31 m3kgNow apply…

Q: The fluid condition at the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle…

A:

Q: The pressure difference measured from the pitot tube when the aircraft is flying smoothly horizontal…

A: The pressure difference measured by the pitot tube, ∆P=2557.7 Pa

Q: A vehicle windshield is to be shaped as a portion of a half-body with the dimensions shown in the…

A: The free stream velocity is V = 70mph

Q: Water flows (from bottom to top) in a vertical duct of 5 cm of internal diameter. A differential…

A: Solution is attached below

Q: Consider an air solar collector that is 1 m wide and 11 m long and has a constant spacing of 3 cm…

A: Please Rate if this solution clears your doubtThank You

Q: Glycerin, with a density of 1260 kg/m3 and an absolute viscosity of 1.5 kg/m.s, flows in a tube with…

A:

Q: When taking data for the golf balls I usually run the wind tunnel at a velocity of 75 ft/sec. The…

A: Solution: Given Data: V=75 ft/sD=1.68 in   To Find: The Reynolds number for the golf ball.

Q: 6-16C A constant-velocity horizontal water jet from a stationary nozzle impinges normally on a…

A: The speed of water from nozzle is constant. The track is frictionless,

Q: A boiler uses 20 kg of air per kg of fuel. The fuel consumption is 33 kg/sec and actual draught…

A: Given that,   ma=20 kg/kg of fuel,   mf=33 kg/sechw=18 mm of waterC=0.3829HTa=25°C=25+273=298…

Q: Water flows through the duct as shown in the figure, which is 50 cm wide and 1 m deep into the…

A: Givenwidth w=50cm=0.5mdepth d=1mβ=90oF=2.8 kNV=1.2m/s

Q: Q1 / Show that velocity profile for fully developed laminar flow on an inclined plane, shown in…

A: Apply continuity equation and navier stokes equation to solve this problem

Q: Water is moving forward through parallel plates at standard conditions. The bottom plate is fixed,…

A: The data given is, Length of the plate, L = x = 5.08 cm = 0.0508 m The vertical distance between…

Q: A large, open tank contains oil and is connected to a 0.3 cm diameter conduit as shown in Figure. A…

A: Given data, d = Diameter of the conduit = 0.3 cm = 0.003 m A = cross-sectional area of the conduit =…

Q: The fluid condition at the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle…

A:

Q: Q1 What is the Reynolds number? How is it defined for (a) flow in a circular pipe and (b) flow over…

A: This question is based on the concept of fluid mechanics.

Q: ter at 27.5°C flows at a rate of 2.1 kg/s through a vertical pipe with an internal diameter of 17…

A:

Q: A ball has a diameter of 28 mm and falls in honey with a terminal velocity of 0.3 m/s. For honey,…

A: Given:The diameter of the ball d = 28 mmThe terminal velocity = V = 0.3 m/sThe density of honey =…

Q: Determine the Height of a chimney with a static draft of 12 mm if the losses total draft is 4 mm,…

A: given data as per question static draft =12 mm losses =4 mm Actual draft =12 - 4 =8 mm  Ambient air…

Q: Consider the flow of water past a (6 mx 2 m) plate as shown in figure. Assuming that the pressure is…

A: To find: The drag force on the plate. Given: The density of water is ρ=1000 kgm3. The velocity is…

Q: The fluid condition at the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle…

A: for solution refer below images.

Q: A cylindrical body of 70 mm diameter and 150 mm length falls freely in a 80 mm diameter circular…

A:

Q: The 25-cm diameter ram in a hydraulic lift slides in a 25.015-cm diameter cylinder. The viscosity of…

A: 1. Given data:2. Calculate the radial clearance (gap) between the ram and the cylinder: 3. Use the…

Q: Air enters a diffuser shown in with a speed of 200 m/s. Determine (a) the speed of sound and (b) the…

A: Given data: The velocity of air is, Vair = 200 m/s. The air temperature is, T = 30oC. (a)…

Q: The friction coefficient for a boundary layer is given by the expression: Cf 1.32 √Rez If the…

A:

Q: Air velocity in a duct is measured by a Pitot-static probe connected to a differential pressure…

A: To determine:The air velocity

Q: Consider laminar flow of a Newtonian fluid between two parallel plates as shown in the figure.…

A: Given data: uy=4umaxyh-yh2 Need to drive the formula for the drag force exerted on both plates.

Q: determine the average speed in the enlarged pipe.

A: need to determine the average speed in the enlarged pipe.

Q: A 3-m-long water taxi is floating in 1-m deep water on two lateral wings with the velocity of 30…

A:

Q: 1. The uniform velocity 'U' of water flowing in a pipe at 70 °F is R ft/s. Figure out the following…

A: Write the Given data:

Q: The duct has a diameter of 150 mm. Its average friction factor is f = 0.004, and air is drawn into…

A: Diameter = 150 mm Length = 90 m Friction factor = 0.004