Water at 10°C flows through a branched pipe system as shown. Branch 1 is 400 m. long and branch 2 is 220 m long. Determine the flow rates Q1 and Q2 in each branch. The pipe material is commercial steel pipe. $75mm- Q1 Q2 Tee 1/2 open gate valve- Std. 90 elbows- Tee Q=30 L/s -Ø100mm

Q: EXAMPLE 10.5. A pump delivers 2.5 cfs of 70°F water from a reservoir at elevation 50-ft to a…

A:

Q: Water is drawn into the pump, such that the pressure at ne inlet A is -25 kPa and the pressure at B…

A: Given data :Pressure at point A and B is PA=-25kPA, PB=160kPaDischarge Q=0.08cumech=2m

Q: •.. 300 mm H20 150 mmg 425mm CHg C13-6) A 150mm diameter venturi meter is installed in a 300mm…

A: Given data, Dia of pipe, d1=300 mm=0.3 mdia of throat, d2=150 mm=0.15 mmercury differential,x=425…

Q: A 30 cm diameter pipe is connected by a reducer to a 10 cm diameter pipe. Points 1 (on the 30 cm…

A: Diameter =30cm pressure at 1 =250 kPa Discharge  Q1=Q2=Q=0.03 m3/sheadlossHL=20rmVelocity…

Q: For the pipe network shown below, estimate the diameter of pipe DE, knowing that the flow at A = 200…

A: Data given Find : Diameter of pipe ED

Q: Water flows in a steel pipe (ɛ = 0.00020 feet) at a flow Q = 12.5 cfs. The diameter of the pipe is D…

A: Given that:                           Surface roughness, ∈=0.00020 ftDischarge, Q=12.5 cfsDiameter…

Q: In Fig. all pipes are 8-cm-diameter cast iron. Determine the flow rate from reservoir (1) if valve C…

A: D = 8 cm or 0.08 m  Kv = 0.5

Q: Prob-8 A venture tube, fabricated with a machined entrance cone is inserted in a 4 in. inside…

A:

Q: Q1: Find the equivalent pipe for the loop shown below, also find the pressure at point C if the…

A: Given, Q=252 m3/hr=0.07 m3/sec Pressure at Point A=450 Kpa CHW=100 PIPE AB BC AC DIAMETER 200…

Q: A flow of 1m /s is received by two pipes which are parallel to each other. A150-mm diameter pipe…

A:

Q: Q4) Determine the required diameter of the pipe at A so that water flows through the pipes at the…

A: To determine the diameter of pipe A (DA) -

Q: 1. Water flows through a horizontal, 0.5-m-diameter pipe at a rate of 0.9 m³/s (Figure below). It is…

A:

Q: 1. A pump station design fills a pressurized water tank by pumping water from a reservoir. The flow…

A: Frictional loss is due to shear stress in the walls of the pipe.

Q: The pipe in figure discharges water from an upper tank to a lower tank as shown. The pipe consists…

A: Length of pipe=500ft Diameter of pipe=6 in To find discharge

Q: Q4: Assuming f-0.020, determine the discharge in the pipes. Neglect minor losses Pipe Diameter AB BC…

A: f=0.02 To find discharge in the pipes

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?