Vin Vin = I(R, + R2) Sensor + Signal Conditioning Circuit VR1 R1 Vout + AIU Analog Input Unit R2 R1 + R2 VR1 R2 Vout = Vin Gnd Figure 95

Q: Plot the output voltage waveform for the analog switch. Analog inpur Control voltage (high level…

A: Given, we are required to plot the output voltage when input signal is as,

Q: Question: A 230 V, 50 Hz one pulse SCR connected half wave rectifier is triggered at a firing angle…

A: The solution can be achieved as follows.

Q: A rectifier is a component that converts ac to dc by allowing the current to be

A: Given, Rectifier . Let's write the definition of rectifier.

Q: Q1.Three-phase half-wave controlled rectifier is shown in the figure below.Delivers 250W power with…

A:

Unijunction Transistor (UJT)

The Unijunction Transistor (UJT) is a three-terminal switching semiconductor device. It contains an n-shaped silicone object bar with a terminal attached to its two ends known as base one and base two. The third terminal is connected to a highly enclosed p-type material attached to the bar section of its length and is known as emitter. As there is only one corrective cross within the device, it is therefore called the 'Unijunction' transistor. The characteristics of the single junction transistor show the wrong resistance if it finds use in resting oscillator circuits for various applications.