View Policies Show Attempt History Three solid bars, each with square cross sections, make up the axial assembly shown. Two loads of P = 16 kN are applied to the assembly at flange B, two loads of Q = 6 kN are applied at C, and one load of R = 15 kN is applied at end D. Bar (1) has a width of b₁ = 85 mm. Calculate the width b₂ required for bar (2) if the normal stress magnitude in bar (2) must equal the normal stress magnitude in bar (1). P b₂ by R (1) A (3) Submit Answer Attempts: 1 of 3 used Answer: b₂ = i Save for Later B P (2) mm ↑ D

View Policies Show Attempt History Three solid bars, each with square cross sections, make up the axial assembly shown. Two loads of P = 16 kN are applied to the assembly at flange B, two loads of Q = 6 kN are applied at C, and one load of R = 15 kN is applied at end D. Bar (1) has a width of b₁ = 85 mm. Calculate the width b₂ required for bar (2) if the normal stress magnitude in bar (2) must equal the normal stress magnitude in bar (1). P b₂ by R (1) A (3) Submit Answer Attempts: 1 of 3 used Answer: b₂ = i Save for Later B P (2) mm ↑ D

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A solid 1.00 in. diameter shaft is subjected to a torque of T = 240 lb-ft and an axial load of P = 5000 lb. (a) Determine the principal stresses and the maximum shear stress at point H on the surface of the shaft. (b) Show the stresses of part (a) and their directions on an appropriate sketch. Answer: (a) Op1 = i Op2 = i Tmax in-plane A i H (1) 요. 요.. psi psi T B psi P X (b) Show the stresses of part (a) and their directions on an appropriate sketch.
Calculate the safe shear stress value of the shaft, given that the smallest allowable diameter d of the shaft subjected to forces P and Q is given as 60 mm in the figure?
please box the final answer
Please show all steps so your process is easy to follow
Determine the absolute maximum shear stress for each of the following plane stress states for which the principal stresses are given. (a) Op1 = 2780 psi, Op2 = -2440 psi, op3 = 0 (b) op1 = 58 MPa, op2 = 35 MPa, Op3 = 0 Answer: (a) Tabs max= psi (b) Tabs max = MPa
a. Determine the maximum flexural compressive stress in the beam. Answer in MPa rounded-off to 3 decimal places. b. Determine the maximum flexural tensile stress in the beam. Answer in MPa rounded off to/3 decimal places
Your answer is partially correct. Determine the absolute maximum shear stress for each of the following plane stress states for which the principal stresses are given. (a) op1 = 2780 psi, o,2 = -2440 psi, op3 = 0 (b) Op1 = 58 MPa, Op2 = 35 MPa, Op3 = 0 Answer: (a) Tabs max psi 1390 (b) Tabs max MPa 29