Vhat is tne avergge parer cansumed $y tae charge!

Q: ) Explain the Voltmeter PMMC instrument and the Ammeter PMMC instrument in AC

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: What is external setup?

A: EXTERNAL SETUP: Setup is the method involved with setting up a machine to run an item. A portion of…

Q: What are the frequencies just above the EHF range called?

A:

Q: Specifications: (a) VDD = 9 V (b) The DC voltages at Vout1 and Vout2 are VDD/2. (c) IR,=10 μA. (d)…

A: The current mirror circuit is given as Given…

Q: 1) For purposes of measuring length, the human torso was a convenient tool, and gave us units…

A: 1) For purpose of measuring length the human torso was a convenient tool and gave us units of foot.…

Q: Draw the circuit of generated Pam??

A:

Q: Q2: Consider the following control system K, (1+ 18) For K. = 2, tD = 1 and step change in load…

A:

Q: What is Peak-Inverse-Voltage (PIV)? Why is it considered important?

A: Peak Inverse Voltage (PIV)  refer to the maximum voltage a diode or other device can withstand in…

Q: Ex. 2110. Refer to Figure 2110. Assume MKS units. Given: V4=15/_ 0.30, XL1=16, R2= 4, 15= 3/ 1.40,…

A: The solution is given below

Q: Power Electronics.   Write necessity of power supply and briefly describe different types of SMPS…

A: Power supply: It is an electronic device  that supplies electric energy to an electric loads the…

Q: With a block-diagram, write about “TIE-LINE BIAS CONTROL

A: It is asked to write about Tie-line bias control with a block-diagram.

Q: Explain what is meant by maximum power point and outline the importance of MPP tracking in relation…

A: Maximum power point tracking (MPPT): MPPT is a technique used to maximize energy extraction with…

Q: What does a BISTABLE circuit do? How could these ideas be applied?

A: Bistable electrical device, often an integrated circuit, where the input signal or signals drive the…

Q: Is the PEC a law? What is a small appliance branch circuit?

A: Small appliance branch circuit: This circuit is used for mainly in the kitchen area and not used for…

Q: How do you find the ampacity and circuit breaker for a 12/2 type nm copper used for a…

A: Aim - To find the ampacity and circuit breaker for a 12/2 type nm copper used for a small-appliance…

Q: Question) Why to Digital and viee conversion im below mentioned process? need Amala we Nersa we…

A: Any physical signal,such as sound,or a light,or a voltage is considered an analog signal. The thing…

Q: b) Draw the graph and describe the relationship between near-end cross talk and attenuation.

A: we need to draw the graph and state the relationship between near end crosstalk and attenuation.

Q: Choose the correct answer: 1- Present-day applications of measuring instruments can be classified…

A: (1): Present day applications of measuring instruments can be classified into regulating trade and…

Q: As shown in Figure 3, the circuit output is 6.1 volts dc. without a filter capacitor onnected and in…

A: The explanation is as follows.

Q: justify balance modulators are used as mixers

A: The balanced  modulator or a mixer uses the  four-port hybrid junction that is shown below. The LO…

Q: Describe the Charging a Compressed Air Storage System.

A: Describe the Charging a Compressed Air Storage System.

Q: Choose the correct mode of operation for each MOS band diagram below. Vacuum level Vacuum level En…

A: We need to choose the correct mode of operation for each Mos band diagram.

Q: a) An SCR based AC power controller circuit is given in Figure 1. The circuit connects a 240V 50Hz…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: is the only quantity which may reduce with increasing number of stages of Cockroft Walton circuit…

A: a- As the number of stages increases , the ripple voltage also increases. Therefore this option is…

Q: How about the Norton Resistance (RN) of the circuit?

A:

Q: 2- Compare between TRIAC and Thyristor. Camnara h "DAIC

A: Semiconductor are the material made of pure Si or Ge or compound . They have conductivity in between…

Q: Prepare a mind map on Load curve analysis

A: Load Curve : Load curve is basically a simple graph which shows the relationship between the demand…

Q: Write short notes on the following: Circuit switching Packet switching Message switching Unguided…

A: The explanation to these communication system topics are as follows.

Q: What is biomedical Instrumentation explain with examples

A: Biomedical Instruments  Bio-Medical Instruments is the application of knowledge and technology to…

Q: Explain voltage and frequency operating limits

A: To move a charge from position to another position in an electric field a force, this force is…

Q: Provide brief answer only. Define a fixed DC source alomg with it's symbol and applications.

A: According to the given question, it is required to determine the definition of a fixed DC source…

Q: For a boost converter operating in continuous conduction mode, when the dc input voltage is 10…

A:

Q: a(t) +

A:

Q: What is voltage stability?

A: According to question, we need to explain the voltage stability.

Q: Q1. The set of independent of voltages are recoded as :50.8, 50.5, 50.2, 50.1, 50.3,50.6. Calculate:…

A: We are authorized to answer only 1 question and only 3 subparts at a time since you have not…

Q: 2. The impubs resporae tnla dsereeime LT sytem is shown in Figure ti Cetemine and sketch e cpu yn of…

A:

Q: Discuss the importance of power system protection and control

A: According to the question, we need to discuss the importance of power system protection and control.

Q: Research on "Power Outage Detection and Locating Methods", roguirod nribo ito

A: Power outage is also called as the cutting of power or the power out,the blackout of power, the…

Q: Explain the characteristics of LDR? What is the use of Multimeter in the experiment?

A:

Q: 7. When the automatic gain control voltage of a radio receiver is measured with a vacuum tube…

A: A voltmeter is used to measure the output voltage across an element. The resistance of an ideal…