vertical Hydro that where is the W

Q: The tank in Fig.  is fi lled with water and has a venthole at point A. The tank is 1 m wide into the…

A: Understand that the tank accelerates to the right at 5 m/s2 and as the tank accelerates it causes…

Q: P2.96 The tank in Fig. P2.96 is 3 m wide into the paper. Ne- glecting atmospheric pressure, compute…

A: Given: The width of tank b=3 m, The length AB is AB=6 m, The radius of the quarter circle is…

Q: If the rectangular tank full of water in Fig. P3.37 has itsright-hand wall lowered by an amount δ ,…

A: The time required to reduce the excess water level depends upon the outer flow of the tank, volume…

Q: The manometer fl uid in Fig.  is mercury. Estimatethe volume fl ow in the tube if the fl owing fl…

A: Draw a diagram for the problem. Here the points 1 and 2 are as shown in the diagram. Write the…

Q: In a certain industrial process, oil of density ρ fl ows throughthe inclined pipe in Fig. C3.1. A U…

A: Considering a datum as shown According to Pascal’s law, pressure at same level will be constant in a…

Q: Fluid Force on a Tank Wall :- In the given question/s find the fluid force on the vertical side of…

A: Write down the given value using suitable variables. Here b signifies triangle base and h signifies…

Q: A block of wood (SG = 0.6) fl oats in fl uid X in Fig.such that 75 percent of its volume is…

A: Calculate the density of the fluid X. Weight of body = weight of fluid X displaced + weight of air…

Q: In Fig. , vertical, unsymmetrical trapezoidal panelABCD is submerged in fresh water with side AB 12…

A: Given Data: The height from surface to the side AB is: L=12 ft The height of the trapezoidal is: h…

Q: The tank shown in Fig, is accelerated to theright at 5 m/s". Find:(a) PA (b) Pa (C) Pc. l

A:

Q: The tank of water in Fig.  is full and open to the atmosphereat point A. For what acceleration a x…

A: Assumptions Water in the tank is assumed as rigid and there is no spill of water from tank while…

Q: P2.128 The 5-cm by 5-cm by 3.6-m spar buoy from Fig. has 2 kg of steel attached and has gone aground…

A: if a body is immeresed in fluid an upward force is exerted by the fluid on the body. This force is…

Q: A trough with a trapezoidal cross-section, as shown in the figure, contains vegetable oil with…

A: An equation of the side AB is given by,Here, the end on which we need to find the hydrostatic force…

Q: Oil h a m bm Water B

A: The pressure gradient along vertical direction in a hydrostatic system depends on density and…

Q: Q3/ A hinged rectangular gate is held at an angle of 70 degrees to the horizon by a cable, with…

A: VERTICAL DISTANCE,h: h=l/sin70' h=3/0.94 h=3.19m   Magnitude of hydrostatic force(F), F=yAh…

Q: 1- In the fig.(1) A cube of wood lave 40cm on each side floats in water, the value of submerging…

A: 1) Each side of  the cube (h) = 40 cm = 0.4 m The volume of the cube (V) = h3 = (0.4)3 = 0.064 m3…

Q: The ABC cover in the figure is R = 270 cm in diameter and in the form of a semi-circle and its…

A: Given Data, R = Radius of the cover ABC = 270 cm = 2.7 m w= Width of the cover into the paper = 140…

Q: two plates shaped like right triangles are placed aon a vertical wall even with the surface of a…

A:

Q: PROBLEM 1 A hydroelectric power plant has the hydraulic turbine located 60 m below the elevation of…

A:

Q: In Fig. , gate AB is circular. Find the moment of thehydrostatic force on this gate about axis A .

A: Given data

Q: plllz help me right nowwww   The gate is 160 cm wide, is hinged at point B, and rests against a…

A:

Q: 37. For a tank (T = 41 C°, volume = 0.051 m³, the rate change of density = 2.6 kg-m-s"), through a…

A: Giventemperature T=41oCvolume of tank V=0.051m3rate change of density ρ˙=2.6kg/m3sarea of hole…

Q: Determine all the forces acting on the cglinder at y-direction

A: The density of the cylinder is ρ. The height of the cylinder is h. The radius of the cylinder is r.…

Q: The gauge pressure in a liquid at a depth of 2.7m is 55.8 kPa. What is the gauage pressure kPa in…

A:

Q: ( liquid of (u = 1.25 Pa s.) fills the space of (Sum) shown in figure below. Calcalate Hthe torque…

A:

Q: SEA WATER T SIDE FRS 7ml Faf FRESH WATER SIDE As shown in the figure, a vertical wall Seperates a…

A:

Q: Q2: Gate (AB) is hinged at (B) with = 53.3°, having (1.8m) wide and (92.5kN) weight, find water…

A: The weight of gate is .The inclination angle is .The width of gate is .Gate is hinged at B.

Q: : Gate AB in Fig. 3 is 6 m wide into the paper. It is hinged at A, and restrained by a stop at B.…

A:

Q: 2.96 The tank in Fig. P2.96 is 3 m wide into the paper. Ne- glecting atmospheric pressure, compute…

A: Ans(a) Horizontal force  Fx=ρgh+ρg(h+r)2Projected AreaFx=1000(9.81)6+1000(9.81)1024(3)=941.76 KN

Q: The swing-check valve in Fig.  covers a 22.86-cmdiameter opening in the slanted wall. The hinge is…

A: Given: The value of the diameter of the opening is d=22.86 cm=0.2286 m. The value of the hinge from…

Q: In Fig., gate AB is 5 ft wide into the paper, and stopB will break if the water force on it equals…

A: Given Data Brake force, B=9200 lb Width of gate AB, b= 5ft length of gate AB, l=4 ft Area of the…

Q: The tank in Fig.  has a 4-cm-diameter plug at the bottomon the right. All fl uids are at 20 ° C. The…

A: Given data The density of mercury, ρHg=13,546Kg/m3 The density of water, ρwater=1000Kg/m3

Q: 95kPa B AIR in he A hA An Air tank is connect to a U-tube that contains three separate liquids as…

A: The heights are The atmospheric pressure is Liquid A is mercury.Liquid B is kerosene.Liquid C is…

Q: The U-tube in Fig.  is open at A and closed at D. Ifaccelerated to the right at uniform a x , what…

A: The pressure at C is atmospheric pressure when the water level in the right limb falls up to point…

Q: O A rigid ring A and a rigid thin disk B both made of same material when gently placed on water just…

A:

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.