+ v υ 10Ω i₁ 603 40 ΜΗ· 1 μF Click to see additional instructions The sinusoidal current source in the provided figure produces the current is = 3cos200,000t A. Calculate the magnitude of the current i3 (in Ampere). Only type in the answer, do not include the unit.

Q: Determine the equivalent impedance across 'a' and 'b'. j120 5.2 W 4.2 j9n be ww 4.0 j130 j112 j20Ω…

A: Given impedance network as follows.

Q: Q1] find the current of the inductance 0.04H if the value of the source is: 3sin(100πt+30) volt…

A: To find thevenin impedence, short the voltage source and open the current source and then find the…

Q: Calculate the output voltage for the circuit given. The value of input voltage can be taken as 2mV,…

A:

Q: 4. Explain the three-level PWM by drawing waveforms.

A: Pulse width modulation(PWM): PWM is a powerful technique for controlling Analog circuits with a…

Q: Two parallel wires made of copper are placed in air. The inductance of each wire is 0.9 µH/m with…

A: Two parallel wires made of copper are placed in air.  Total inductance L= 0.9uH/m What is the…

Q: U1 C1 R1 4.233m 1kQ ??? V2 10 Vrms 5kHz 0° R2 C2 6800 0.05µF Şekil-3

A:

Q: A 252 B 202 HH 2F Em Pm C D 192 202 56V

A:

Q: Quiz Determine the value of ix and V. 20, 30° V 60Hz 10 92 1 H 0.1 F H- 0.5 H V

A: Given figure,

Q: Qui o 9v 0,2 U 3 0.2H What is the instantanees Curreat when the srwitch is elosed @ t =o After t =…

A: We need to current for resistor and inductor circuit .

Q: average power across combination of resistor and inductor

A: It is given that:

Q: (c) Measure the voltages of the resistor and capacitor and calculate the current using Ohm's Law…

A: Given:A circuit, we need to find:(c) Measure the voltages of the resistor and capacitor and…

Q: Question 1 Is the FSM a Mealy or Moore machine? Choose '0' for Mealy and '1' for Moore. Reset So…

A:

Q: need part a, b and c asap i willl give you upvote

A: a) The switch has just been closed. The given circuit can be redrawn as shown below, The capacitor…

Q: SPheres hauesta conducting charges .147 pC an T.851 pC sthy are two Hentiaal Conduc tiy Brought Ynto…

A: In this question we are given two charges . And when they came in contact , the charge is…

Q: In the figure below, the switch is closed. A diac with breakover voltage VBO = XX-2 V is connected…

A: Given circuit, In the shown diagram value of, XX = 29 YY = 27 ZZ= 15 Given data, Breakover voltage…

Q: 4. Current (mA) 30 20 10 0 -10 -20 -30 Be sure to show all your work and include units What is the…

A:

Q: 3.7.[1] The cylindrical surface p 8 cm contains the surface charge deasity Ps 5e-20|z| nC/m. (a)…

A: Note: Surface charge density can not be nc/m it will be nc/m2 Given data ρ=8 cmρs=5e-20|z|nC/m

Q: In an inductive circuit, What is the value of the instantaneous current if t-40 s .L= 10mH and v(t)…

A: Find the Instantaneously current at time to= 40s Voltage and inductance are given.

Q: Calculate the capacitative reactance and the voltage in each point. Also calculate the current and…

A:

Q: A factory is located near a waterfall where the usable head for power generation is 25 m. The river…

A: Given a factory is located near a waterfall where, Usable water head, H = 25 m. The river flow or…

Q: VL = 28.59385 V R L V Ns 2000 2H 50 100 1= 0.014297 A Find the value of L

A: Fig: Given circuit

Q: An inductor is connected in parallel with a 6540 resistor and a function generator. The applied…

A: Let current through the resistor be IR and current through the inductor is IL and I be total source…

Q: Indicate how much is the power of the dependent source

A:

Q: The coil winding in PMMC meter is -1 small heavy large fine

A: Given  The coil winding in PMMC meter is

Q: O 0.06 second

A:

Q: For a clamper circuit, if the input is the blue waveform and the output is the red one. Scale…

A: Given that: A clamper circuit waveform is shown below. Scale is 5 V/Div means that one block refers…

Q: 1 = 602-40° A E = 120/20⁰ V

A: We need to find out the reactance for given current and voltage

Q: Item 8 of 10 Most ac-supplies are in the form of Select the correct response: sine-wave…

A: This is a basic problem of sinusoidal and phasor. The solution is given in the next step

Q: Question 1 What would be the maximum current through the resistor? Express your answer in amperes…

A: As per the guidelines of Bartleby we suppose to answer first three subpart only for solution of…

Q: Q4. Find the value of C₁ in the figure below 5 V rms C₁ 4 mA C₂ 0.0022 μF C3 0.0015 μF Xc3= = 750 Ω

A: In this question, we need to determine the capacitance C1  shown in the circuit. Capacitive…

Q: Referring to the Figure 1 below, set the value of voltage Vs as: - Vs (rms) = (120+the last 2 digit…

A:

Q: You will calculate the time constant for the circuit shown in the illustration below using Equation…

A: The circuit diagram,

Q: For the circuit in the figure a) Determine the time constant. b) Write the mathematical expression…

A: As per policy solving only first three Given a) time constant in series RL circuit…

Q: C = 5 µF C3 = 8 µF C2 = 4 µF C4 = 6 µF C3 = 4 µF DUDACELL VT = 12 V

A: Option c 5.65 volt is correct Please note that 12 volt is parallel with ( 6 and 4 ) 12 volt parallel…

Q: Use superposituon to find the current flowing in the brarnch AB A 20L50° 20L-50° B 8! - 9 3. +,

A: PRESENCE OF SOURCE: In the presence of sources all the passive elements which are R, L and C always…

Q: 1. The resistor R₁ is adjusted until it absorbs the maximum average power. Calculate R₁ and the…

A: Given figure,

Q: 0.28 j1.13 A rms

A: Current is given as 0.28-j1.13 A (rms)

Q: Calculate the equivalent capacitance that would connect to points "A" and "B". Answer in…

A:

Q: What is the current in the inductor ILO in continuity mode before opening the switch. R₁ Select one:…

A: In the given R-L circuit, we need to determine the current through the inductor when the switch is…

Q: Solve for the value of the capacitance (in nF unit) if R2-1017 ohms and Xc = 2316 ohms. Round your…

A: The question is about finding capacitance value.

Q: Find the capacitor size that wiIl make the light stay on for 10 sec after power is removed switch is…

A: The solution is given below

Q: Calculate the inductance for a coil with 120 turns, a current of 0.47 mA, and a flux of 1.2x10 Wb. a…

A: Given: Coil with number of turns, N = 120 Current in the coil, I = 0.47 mA Flux, φ=1.2×10-6 Wb

Q: Find B C D

A: Given here a circuit and asked to find the values of B,C,D.