V Dre Matm Ot *Exercise 1: The gale 90 is suhjected to waler pressure as shown in figure. Find (Fy and F) Water surface 90 Ans. Fy-245.2 KN Fy = 70 kN 5 m

Q: For the 40 ° C water fl ow in Fig. P3.134, estimate the volumefl ow through the pipe, assuming no…

A: Given: For the 40 ° C water flow,the following diagram is given below,

Q: 65 A 2.5-m length of a steel pipe of 300-mm outer diameter and 15-mm wall thickness is used as a…

A:

Q: Answer the attached question.

A: Given:- speed = 10000acfmT=200 oF1 atmParticle density = 1200kg/m3To find:-Lappe conventional…

Q: Determine the dimensions of a rapid-mixing basin to process 3.0 MGD of water. The basin will be…

A: Determine the dimensions of a rapid-mixing basin to process 3.0 MGD of water. The basin will be…

Q: a 100mm height cylinder with specific weight of 5kn/m^3 is submerged ina a a fresh water with…

A:

Q: Q.28 Viscous damping force acting upon SDOF system is 1000 Nat a velocity of 50 mm/s. The damping…

A: Given, Damping force =1000N Velocity= 50mm/s

Q: Using three moment equation method compute and show the complete solution of the ff: 1.RA 8. Moment…

A:

Q: 4. Given f = 0.008, determine energy lost and Pressure drop between points 1 and 2 [307.7 J/kg,…

A: As per our guidelines we are supposed to answer first question only. So please repost others as…

Q: Verticle load is 258 kN as opposed to 25*8kN - Apologies

A: Yes,    As in the previous answer, it is notes as 25×8 .    Now In this Solution I will provide you…

Q: What must be the mass of block A if it is to descend 12 m in the first 3s after the system is…

A:

Braced cuts

The braced cut is a method of providing lateral support to the soil in foundation trenches, to prevent the trenches from deformation by the caving in of soil and resisting it from moving laterally. During shallow excavation in firm soil, generally, slopes are provided to resist the caving in of soil. During shallow excavation in soft soil and deep excavation, the chances of caving in of soil increase. Hence, it becomes necessary to make a provision to resist the deformation of trenches due to caving in of soil. The braced cut is the method used for such conditions. The excavation using braced cuts is a bit uneconomical as compared to the traditional open-cut excavation method but provides better safety than the cut excavation method.