Using the Moment Distribution Method draw the shear force and bending moment diagram. A is a pin, B and C are rollers. EI is constant. D 200 lb/ft B POND 300 lb D

Q: How are GIS hardware differ

A: The tangible devices and instruments needed to execute and display software results are referred to…

Q: In the MIPS instruction "jr $1", what information does register $1 contain?     the address of the…

A:

Q: Are there any possibilities of conflicts between Drawings and Specifications?

A: The conflict between the drawings and specifications indicates that the details on the drawings…

Q: What is PostScript, and how does it contribute to high-quality printing? Provide examples of its…

A: PostScript is a page description language (PDL) developed by Adobe Systems. It's a programming…

Q: there a way to write this out so it is easier to read? thanks for you rhelp would be greatly…

A: Flexural Rigidity = 100000 N/mm2   Uniform Load over each box = 10 N/m   Spring stiffness constant,…

Q: 13.1500 13.1500 4 0000 - -2.0000 4.0000 -3.3500 0.0000 2.0000- 3.8000 -3.3500 2.0000 2.0000 2.0000…

A: We need to find out One Way Slab and Two way slab If Ly/Lx is equal to or more than 2 then One way…

Q: what does u stands for

A: Given Data  Diameter of water jet (d) = 25 mm  Velocity of water (V) = 10 m/s  Find force required…

Q: Indicate the sole instruments required to create FREEHAND drawings.

A: The following steps outline the only instruments required to create FREEHAND drawings.

Q: What is another name for offset lithographic printing

A: Offset lithographic printing is a flat or planographic technique of printing. It was developed by…

Q: What are master specifications?

A: Master specifications are a compilation of standardized, guide specifications or pre-written…

Q: What distinguishes open source software from closed source software? compile a list of every GIS…

A: Context: GIS Applications, Open source vs close ed source assest

Q: What text style is used on technical drawings?

A: The text style is used on technical drawings is mentioned in the following step

Q: Create a structure diagram that even individuals without technical knowledge may comprehend. In…

A: Solution: Let's assume the hospital to be a reference model for our structure. We are going to…

Q: How are lines used in Construction Drawings and why are they important?

A: Explanation of lines importance and uses.

Q: .what if i dont see on screen the command line or command prompt? in autocad 2.what if the command…

A: INTRODUCTION: In the autocad, if any command is missing then use the short cut command from keyboard…

Q: Please give typed answer

A: Given data:- Draw a horizontal line S60W with a length of 200m, Calculate the value of TL.

System of Forces

A force is an external influence or agent that changes the state of a system. According to Newton's second law, the force applied to a body is proportional to the change in momentum of a body. Hence, whenever a force is applied to a body, its momentum changes. If the body is at rest, under the action of force, its state of rest changes to motion. In other words, the magnitude of the momentum of the body changes from zero to a measurable value. Similarly, if the body possesses some initial velocity, it has some associated momentum, the effect of force can cause the body to halt or come to rest, that is, the momentum reduces to zero.