Using Eq. (5.23), determinc the capacitancc to neutral (in uF/km} of a three-phaselinc with three Cardinal ACSR conductors equilaterally spaccd 200 ft apart. What isthe charging current of the linc (in A/km) at 60 Hz and 100 kV line to linc?Еq. (5.23) :- С, 3F/m to neutralIn(Djr)(Kindly do not copy-paste answer from any other source. Kindly answer as asked in thequestion. Kindly show detailed steps, workings and provide explanantions for your answer.If you are confused about showing detailed steps, workings and providing explanations,then kindly skip the question and leave it for someone else.)

Three Phase Line: Electrical power lines are used in an electric power system to transport electric…

Using Eq. (5.23), determine the capacitancc to neutral (in µF/km) of a three-phase linc with threc Cardinal ACSR conductors equilaterally spaced 20 ft apart. What is the charging currcnt of the linc (in A/km) at 60 Hz and 100 kV line to linc? 2 Tk Eq. (5.23) :- C,n F/m to neutral %3D In(Djr)

Using Eq. (5.23), determine the capacitancc to neutral (in µF/km) of a three-phase linc with threc Cardinal ACSR conductors equilaterally spaced 20 ft apart. What is the charging currcnt of the linc (in A/km) at 60 Hz and 100 kV line to linc? 2 Tk Eq. (5.23) :- C,n F/m to neutral %3D In(Djr)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

a) The voltage across a 20uF capacitance is v. = 50 sin( at - 80) volts and Frequency equal to 100 Hz. Determine the current through the capacitor i and sketch its waveform. b) Define phasor
3.n Figure 3P.2 shows two capacitor banks, C, and C2, in a substation C is enercized, but C, is discharged. The three-phase, 60 Hz ratings of the banks are: C,, 5 MVA; C,, 3 MVA, on a 13.8 kV base. The source has a short circuit rating of 20 kA rms at 13.8 kV. The inductance of the loop between C, and C,, represented by L, is 30 µH. 13.8 kV V3 L L2 o to C2 Source Capacitor banks ouG OL 19 Fig. 3P.2. Calculate the peak transient voltage that will appear on C, and the peak transient current that will flow in L,, if the switch S is closed at the peak of the voltage cycle. Point out any assumptions you make.
-) Below are two voltage patterns measured from an oscilloscope. The voltage stage of the CHI probe is 5 V / div, the CH2 probe voltage stage is 10 V / div and the time axis is 2ms / div. According to this information, a) What are the peak to peak and rms voltage values of the voltages in CHI and CH2? b) What is the frequency of the voltages in Hz? c) How many degrees is the phase difference between the two voltages, which voltage is leading?
For the circuit shown below, determine the voltage of the -j10 capacitive reactance. -jsa jl0n 0.5L-90 ILOA(1 -j102 jsn 52 102 A
Another name for the RMS value of current or voltage is ... O the effective value O the exact value O the true value O the reactance value
We want to investigate how the field strength will be with air as dielectric and with steatite. A plate capacitor is placed in a 24 kV network between phase and ground. The relative permittivity of air is &=1 and for steatite &-6. The plate capacitor has area = 1m². The distance between the electrodes is 2 mm. Ep = 8.854-10-12 F/m A=1m² d=2mm a) Calculate the maximum field strength in the plate capacitor. (Answer: 9.8kV/mm) b) What is the capacitance of the capacitor if we use steatite? (Answer: C = 26.6nF)
Which of the following is true about all series ac circuits?(a) The voltage across any circuit element is a maximumwhen the current is a maximum in that circuit element.(b) The current at any point in the circuit is always thesame as the current at any other point in the circuit.(c) The current in the circuit is a maximum when thesource ac voltage is a maximum.(d) Resistors, capacitors, and inductors can all change thephase of the current.
1. a) Sketch the phasor diagram, using current as the reference phasor, for a load consisting of a resistor and capacitor in series. b) Sketch the phasor diagram, using current as the reference phasor, for a load consisting of a resistor and inductor in series.
26. The reactance offered by a capacitor to alternating current of frequency 50Hz is 10ohms. If the frequency is increased to 100Hz, the reactance becomes _____ ohms. A. 5 B. 40 C. 20 D. 2.5
What is the average power in ghe single phase ac circuit with the purely resistive load? It is sinusoidal steady state excitation.
An inductance of 2 henrys and a resistance of 10 ohms are connected in series with an emf of E volts. If the current is initially zero, find the current at the end of 0.5 second when (a) E=120 volts, and (b) E=120 sin⁡6t volts.
SINUSIODAL WAVEFORM FORMULA 1. What is the average voltage and peak-to-peak voltage for a given voltage having an equation of v-467sin8t? How long does it take in milliseconds for the waveform to complete Cycle if t=2.14 s? 2. Given a sinusoidal current of A=3cos(351t+0): what is the magnitude of the voltage at t-4.1 ms if the resistance is 48 Q and the phase difference is 1.53 rads, how long does it take for the waveform to complete 1/32 cycle? 3. An industrial motor circuit has a freguency of 60HZ and a sinusoidal voltage v-35sin(wt+68°); what is the magnitude of the current if the resistance is 430Q at t=3.15 ms. Find the average current and peak-to- peak current of the given sinusoidal formula.