Using a prescribed fluid delivery rate of 5 mL/kg/hr during the first hour of anesthesia, and a macrodrip delivery set with a delivery rate of 15 gtt/mL, a 53 lb patient would require which of the following infusion and drip rates?265 mL/hr; 1 gtt/sec121 mL/hr; 1 gtt/sec121 mL/hr; 1 GTT/2 sec121 mL/hr; 1 gtt/4 sec
Q: Isotonic fluids should be used cautiously in clients with Hypertension and/or CCF. Please explain…
A: Isotonic fluids are used in management of shock ok and hypotension. Isotonic Fluids usually help to…
Q: What is the flow rate of a 100 mg/ 400 mL solution strength ordered to be infused at a rate of 20…
A: Question is related to the drug calculation. Detailed solution in step 2 .
Q: A physician orders an intravenous piggyback infusion of 100 mL of cefoxitin 1 g to run for 30…
A: An IV piggyback is a small bag which will have a particular amount of solution that must be infused…
Q: What is the correct infusion rate in mL/hour
A: 6mg forms 1mL 1mg forms 1/6 mL 90 mg forms 1/6×90= 15 mL Infusion to be given for 24 hour is 90mg…
Q: *A drug is ordered at 0.3 mg/kg/min. If the patient weighs 148 pounds, find the dosage rate in…
A: The daily fluid maintenance for a child can be calculated using a formula which is called as the…
Q: An IV fluid of 1000 mL of lactated Ringer’s (LR) solution was started in a patient at 8:00 AM and…
A: According to the this question solution given below
Q: How much potassium (in mmol/hour) is the patient receiving?
A: Given- KCL infused- 0.15%. Total KCL- 50mL Time required for receive 50mL KCL- 6hrs. 0.15% KCL -…
Q: The IV pump you were using to infuse Mr. Flint’s IVF is necessary for another patient and you must…
A: Flow rate = 33.2 gtt/min
Q: Over a period of 9 hours a patient is to receive half a liter of dextrose 4 % in 1/5 normal saline…
A: Conceptually, when setting the flow rate for an IV infusion, you need to consider the total volume…
Q: A normal saline solution (0.9 mg of sodium chloride per 100 ml of solution) is given intravenously…
A: The normal NaCl concentration of the blood/serum/plasma is 0.9%. This corresponds to 154 mM of NaCl.…
Q: A medication with a dosage of 250 mg is added to 125 mL solution and infused at 30 mL/hr. Calculate…
A: Concentration of drug= amount of drug÷volume
Q: A patient weighing 119lb is to receive 300 mg of medication in 750 mL solution is to be titrated at…
A: To solve the medication flow rate we will calculate it - Step I- Formula for calculation = Dose…
Q: The healthcare provider orders 90 mg of a drug IVPB q6h for a child. If the label on the drug vial…
A: To dispense doses of various medications, the device uses a volume control chamber instead of a…
Q: an infusion pump is set to administer 75 mL/hr. How many hours will it take for the client to…
A: Intravenous(IV) administration is one of the routes for administration of pharmaceutical…
Q: Jane who weighs 96 kg is to receive aciclovir at a dose of 5 mg/kg infused over 1.5 hours. The…
A: We are told that we have to give 5mg per kg drug over one and half hours. We have to calculate the…
Q: What flow rate is required to deliver 400 mL RL over 3 hr, 15 min?Indicate the quantity and unit of…
A: Approach to solving the question: To solve this problem, we need to use the formula for flow rate,…
Q: Find the flow rate( in drops/ min) for the given IV(assume a drop factor of 15 drops/ mL). 1,800mL…
A: IV stands for intravenous (IV) administration in which the medication is injected or infused through…
Q: A 500 mL infusion of glucose 5% is being given at a rate of 167 mL/hr. How long will the infusion…
A: Answer:- Drug calculations involve determining the correct dosage of medication based on various…
Q: Infuse 500 mL normal saline in 6 hr. Drop factor: 10 gtt/mL.
A: Hii... We will able to answer one question. Kindly specify the question number if you want other…
Q: A medication must be administered at a rate of 500 mg per hour in a total volume of 100 mL…
A: Q 1 formula desired dose / available in hand multiply by total volume Desired dose 500 mg per hour…
Q: drops per minute
A: Lincomycin is used in the cases of infections due to strains of streptococci, pneumococci, and…
Q: Blood plasma flows with a rate of 0.4 cm³/s through a tube with a diameter d = 0.18 cm and length I…
A: Solution for Maintaining Flow Rate and Pressure at ExitWe can solve this problem by considering two…
Q: How long will it take 1,000 mL to infuse if the flow rate is 125 mL/h? * How many mL of solution…
A: The nurse need to check "5" Rights of the drug before administration. They are, 1) Right drug. 2)…
Q: At an infusion rate of 125 ml/hr, match the amount of fluid a patient will receive at each of the…
A: To find out the amount of volume infused Volume infused = Rate of infusion × Time
Q: Your patient has been prescribed 600 mL of D5W to run over 7 hours. After 1 hour, she has received…
A: We need to compute the remaining volume that has to be infused as well as the remaining amount of…
Q: Order: Infuse Bretylol 2 mg/min via infusion pump. Supply: Bretylol 1 gm/500mL D5W. How many mL/hr?
A: Bretylol Generic Name: Bretylium tosylate It is an antiarrhythmic agent that blocks the release of…
Q: Calculate the patient’s 24 hr fluid balance using the information below: Input 0800 - 2000: Jevity…
A: Precisely calculating a patient's 24-hour fluid balance could be a basic aspect of healthcare,…
Q: Your patient's IV of N/S is running at 75 mL/hr and the drop factor is 25 gtt/mL. What is the drip…
A:
Q: A patient is to receive: Heparin 800.0 units per hour. 20,000.0 units of heparin have been added to…
A: Heparin is an anticoagulant. It is responsible for preventing the clotting of the blood.
Q: Calculate the flow rate for a solution of 18mg in 300 mL with a maintenance dose of 5 mcg/ min.
A: As per the given scenario Dose available = 18mg in 300 mL Dose prescribed = 5 mcg/ min
Q: The following results are obtained for a patient using a point-of-care device that employs the…
A: Hematocrit is the test used to measure the red blood cell proportion in the blood. RBC carries…
Q: The physician ordered 700ml of a special electrolyte solution to flow at 75 gtt/min. The drop factor…
A: The nurse should follow the "5 Rights" while administering the medication. They are Right patient,…
Q: rthy is given an intravenous antibiotic (gentamicin) at a dose of 7 mg/kg per day for a period of 7…
A: Gentamycin is an anti-bacterial injection used to prevent a wide variety of bacterial diseases.
Q: Calculate the flow rate for a solution of 18 mg in 300 mL with a maintenance dose of 5 mcg/min.
A: 18 mg in 300 mL maintenance dose to be given:- 5 mcg/min Flow rate:- ?
Q: An IV medication in 60 mL D5W is to be administered in 30 minutes. The drop factor is a microdrop…
A: What is D5W?? It stands for Dextrose 5% in water. It is an intravenous solution that contains 5%…
Q: a patient weighs 115 lb and is receiving a medication via an IV (600mg/500 mL) infusion at 20 mL/hr…
A: Medication administration is an important responsibility that is always carried out by nurses…
Q: Which of the following drop factors is not found in a typical IV infusion set? 60 gtt/mL…
A: The answer is 45 gtt/mL. Typical IV infusion sets come in two main categories: macrodrip and…
Using a prescribed fluid delivery rate of 5 mL/kg/hr during the first hour of anesthesia, and a macrodrip delivery set with a delivery rate of 15 gtt/mL, a 53 lb patient would require which of the following infusion and drip rates?
265 mL/hr; 1 gtt/sec
121 mL/hr; 1 gtt/sec
121 mL/hr; 1 GTT/2 sec
121 mL/hr; 1 gtt/4 sec
AI-generated content may present inaccurate or offensive content that does not represent bartleby’s views.
Unlock instant AI solutions
Tap the button
to generate a solution
Click the button to generate
a solution
- Give only typing answer with explanation and conclusion A patient is prescribed dobutamine at 2 micrograms/kg/min. The patient weighs 75 kg. You have prepared 200 mg in 50 mL infusion. What rate will you set the infusion pump in mL/hr?An 84 year old male patient has been given a loading dose of digoxin of 298 micrograms in divided doses by intravenous infusion. He has a creatinine clearance (Ccr) of 34 ml / min. What is the maintenance dose (in micrograms) that this patient should receive? Round your answer to the nearest whole number. Use the formula provided to calculate the maintenance dose. Maintenance Dose = Peak body stores x % daily loss 100 Where: Peak Body Stores = Loading Dose % Daily Loss = 14 + Creatinine clearance (Ccr) 56) A patient is prescribed a new drug that needs to be infused intravenously. The drug is available as a 20mg/mL solution and is run at a flow rate of 300mg/hour. Assuming that there are 20 drops in each mL, what is the flow rate in drops per minute of the infusion?unit- drops/min
- An infusion pump containing 250 mg dobutamine in 50 mL is running at a rate of 3.5 mL/hour. You want to convert back to mcg/kg/min to check that the pump is set correctly. (Patient's weight = 73 kgMetoprolol 25mg/100mL was orderd to infuse on an infusion pump at 17 mL/hr. The RN started the dose at 8:45 am. You return at 11:45 am and 56 mL is left to infuse. If the set calibration is a microdrip tubing, what would the new drip rate be?The erythrocyte sedimentation rate (heaviness) test of a blood sample is often used as a diagnosis of immune disorders and some other diseases. Assuming that the red blood cells are about a sphere with a diameter of (approximately 5 um) and a density (g/ml 1.125), and the density and viscosity of the plasma in which the red blood cells are settled (Pa.s), (1025 kg/m3 10-3 x 1.5) On arrangement and acceleration m/s2 9.81 Calculate the erythrocyte sedimentation rate (settlement rate).
- The volume of a 20mg dose of medication is 2ml. Dilute 15ml, and administer over 45 min with a 15 mo flush to follow. Determine the following: Dilution volume ml Rate in gtts/min Rate in ml/hr mlThe order reads Potassium Chloride drip: 40 meqs KCl in 500 mL in NSS IV @ 7 meqs/hr. Compute for infusion rate in ml/minOrder: 1500 mL D5NS IV to run over 12 hoursCalculate the drops per minute (gtts/min) for each of the different tubing.a) ML/hr b) Macro drop (10 gtt/mL) c) Micro drip (60 gtt/mL) Order: dobutamine (Dobutrex) 57mcg/kg/minute IVPatient: 70 lbSupply 500mg/250 mL D5W Solve for ml/hr.
- An IV is set to run at 94 gtt/min. What would the 15 second drip rate be? (Record answer as a whole number. Do not use a trailing zero.)An IV infusion is to contain 40 mEq of potassium ion and 10 mEq of sodium ion in 500 mL of D5W.Using a 20% w/v potassium chloride injection (MW 74.5, valence of 1) and 0.45% sodium chlorideinjection (MW 58.5, valence of 1), how many milliliters of each should be added to the 500mL bag ofD5W to supply the required ions?If an IV is running at a rate of 140 ml/hr, the IV tubing is calibrated at a drop factor of 20 gtt/mL. Calculate the gtt/min flow rate for this IV.