Use Tinkercad or any other tool to implement the following project You have two Arduinos which are connected using serial cable Arduino#1 is connected to the following components:
Use Tinkercad or any other tool to implement the following project
You have two Arduinos which are connected using serial cable
Arduino#1 is connected to the following components:
1-Ultrasound Sensor to measure distance, if there is something in distance of 50 cm or less, a door (Servo meter) will open for 3 seconds. After the 3 seconds it will check again if something is still within 50 cm distance and if yes it will continue openning for another 3 seconds, if no then it will close (and so on).
2- Light Dependent Resistor - LDR (to detect Light) and Passive Infrared sensor - PIR (to detect movement). If there is no enough light “and” there is a movement then a bulb will be turned on for 1 minute (and so on).
3- Temperature Sensor to measure temperature, if the temperature is more than 30 degree, then a fan (DC Motor) will be turned on, and the fan will go faster as the temperature increases.
Arduino#2 is connected to the following components:
1- Switch : the switch will control if the system works in Automatic mode or manual mode. If in automatic mode then all work will be done automatically by Arduino#1. If in Manual Mode, then Arduino#2 will receive different alarms about the situation of Arduino#1, and use remote control to turn on/off the bulb, the door (servo motor), and the fan (DC motor).
2- LEDS and Buzzers to notify the user if anything needs an action (in case of Manual Mode).
3- Remote Control: to control all the actions (in case of Manual Mode).
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 2 images
