Use suitable illustrations to derive an. equation that can be used to determine total power delivered to a three phase using two wattmeters. the load

Q: Draw a simple pulse detector (positive-edge) diagram and explain how it works.

A: The edge detector circuit generates a positive spike at at the positive going or negative going edge…

Q: A 1-p On-Off AC voltage controller has the supply voltages of 220 volts and rms output voltage is…

A: Vs=220 volt Vo=110 volt

Q: What is the difference in output from switches and sensors?

A: The explanation is as follows.

Q: What is an example of inertial sensor

A: The sensor is an important part of the design which takes or sense physical signal like motion,…

Q: what is the STOP W.O.K.E Act

A: Florida state legislature, with the support of Republican Government- ‘Ron DeSantis’. passed a new…

Q: Does the guidelines provided by NEC is maximum

A: The solution is provided in the following section:

Q: If the proportional band of a proportional mode control system is zero percent, the system gain is…

A: If the proportional band of a proportional mode control system is zero percent, the system gain is…

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.