urses Lancaster Geometry CP Sping 202 (Nancy Area of Sector Instructions: Find the area of the sector. Round your answer to the nearest tenth. 5 km. 270 Area of sector= km² Check

Q: Find the circumference and area of the circle. Round the answer to the nearest whole number. 24 yd O…

A: The given circle has diameter 24 yd. we have to find its circumference and area.

Q: Find the measure of the indicated arc, chord or variable. mLM

A: Circle question

Q: Determine the equation of the circle with center at the origin and a diameter of 30 units A.225…

A:

Q: A circle has an approximate area of 50.24 square yards. What is the approximate circumference of the…

A: Given that Approximate area of circle is 50.24 square yards To find Approximate circumference of…

Q: Both circles have the same center. The circumference of the inner circle is 182.12 miles. What is…

A:

Q: A B 50 80 ft

A: In triangle ABC                Cos 50 =  BC/AB                 AB = 80/cos 50                AB =…

Q: 2. . 16 110° 90° 12

A: Divide quadrilateral into 2 triangles. Then find area of each triangle.

Q: Given JKLM is a Rectangle, JL= 2x + 5 and MK = 4x-11 Find the value of x and MK. J M L

A: JKLM is a rectangle. The diagonals of a rectangle are equal.

Q: A lawn sprinkler that sprays water in a circular motion is to be used to water a square garden. If…

A:

Q: In the triangle below a = 21. What is the area of the triangle to the nearest hundredth of a unit?…

A:

Q: Find the area of the following triangle. Round your answers to the nearest tenth. a = 4.8 in, b =…

A: NOTE: Refresh your page if you can't see any equations. . here we have a=4.8 in b=6.3 in c=7.5 in

Cylinders

A cylinder is a three-dimensional solid shape with two parallel and congruent circular bases, joined by a curved surface at a fixed distance. A cylinder has an infinite curvilinear surface.

Cones

A cone is a three-dimensional solid shape having a flat base and a pointed edge at the top. The flat base of the cone tapers smoothly to form the pointed edge known as the apex. The flat base of the cone can either be circular or elliptical. A cone is drawn by joining the apex to all points on the base, using segments, lines, or half-lines, provided that the apex and the base both are in different planes.