Answered: uring a tensile strength experiment, a… | bartleby

Related questions

Question

uring a tensile strength experiment, a small diameter fibre is elongated by a force
of 0.0250 N. The fibre has an initial length of 0.200 m and stretches 4 x 102 m.
Determine the diameter of the fibre?
The Young's modulus for the material being tested is 7.60 x 1010 Pa.

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

Consider a square-faced beam supporting a section of a building. a) Before installation, the length of the beam is found to be l0 = 15.02 m (figure a). After installation and construction, the length is remeasured and found to be l = 14.98 m (figure b). Determine Young's Modulus Y in N/m2 for the beam if it supports a mass m = 35000 kg and has a side length d = 1.9 m. b) Suppose that after the beam is installed it needs to be repaired. The weight it supports is removed and replaced with a new mass m2 (figure c). After the new mass is supported, the side length is remeasured and found to be larger with a difference of Δd. Assuming that this side length deformation is uniform and small, write an expression for determining Poisson's ratio v for this beam if its Young's modulus Y is known.
An amusement park ride consists of airplane-shaped cars attached to steel rods. Each rod has length 15m and cross-sectional area 8.00cm2. Take Young's modulus for steel to be Y=2.0×1011Pa. How much is the rod stretched (change in length of ΔL) when the ride is at rest? Assume that each car with two people seated in it has a total weight of 1900N. When the ride is operating, it has a maximum angular speed of ω=8.0rev/min. How much is the rod stretched then?
A 16.3 cm long tendon is found to stretch 2.11 mm when a force of 18.8 N is applied to it. If the tendon is round and as an average diameter of 5.13 mm, calculate the Young's modulus of this tendon.
What hanging mass will stretch a 2.2-m-long, 0.34 mm - diameter steel wire by 1.2 mm? The Young's modulus of steel is 20×10^10N/m2. Express your answer in kilograms.
A 600.00 N ballast is hung from the end of a wire of cross-sectional area 0.0000010 m^2. The wire stretches from its original length of 2.4000 m by 2.4080 mm. a) what is the stress or pressure on the wire? b) what is the elongation strain ( change in L/L initial) on the wire? c) determine young's modulus of the wire.
An 10.3-kg stone at the end of a steel (Young's modulus 2.0 x 1011 N/m?) wire is being whirled in a circle at a constant tangential speed of 10.0 m/s. The stone is moving on the surface of a frictionless horizontal table. The wire is 4.54 m long and has a radius of 3.56 x 10-3m. Find the strain in the wire.