Under DC conditions, find the energy stored in the 20uF capacitor in micro Jules. 3 ΚΩ ww 10 V Question 10 1 ΚΩ 4A 10 μF Find ve under DC conditions (in Volts). 0.25 Η m www 3 Ω HE 20 μF 1Ω www. 6ΚΩ + VC 2F

Q: please need correct answer and fast    Q2)  The certain operational amplifier has the following…

A:

Q: Explain the successive approximation

A:

Q: The ARDUINO IDE stands for. O a. Integrated development environment O b. None of these O c.…

A: The correct option for 57 is option a

Q: Differentiate between MCB and kit kat fuse

A: MCB : MCB stands for miniature circuit breaker it is a electrical device in such way that it…

Q: The total turn ON time of SCR is 24 . If the sum of delay and spread time is 19 , the rise time of…

A: The solution can be achieved as follows.

Q: During dead space the output value of the instrument will be _____________ over a range of input…

A: Dead space is the range of different value of the input  at which there is no change in output…

Q: Approximately, what is the percent jitter for the following signal? 0.012 0.005 0.011 0.01 主

A: Jitter is a plot which is used to show the value distribution which are very consolidated. It gives…

Q: Modulator is a term used to describe any device that converts signals.explain

A: For the wireless transmission of the signal, the signal message signal must be amplified and must be…

Q: Cần be driven by a single digital 1C output is a characteristic called a) low power dissipation. c)…

A: 2. The number of parallel loads that can be driven by the single digital IC output is a…

Q: can i series my led chip even though i don't put any fuse. Is it safe?

A: Most of circuit does not contain fuse for LED Chip Reason behind not putting fuse for LED Chip is…

Q: Draw the equivalent circuits of Class E chopper for the different quadrant operation and write its…

A: According to question we need to, Draw the equivalent circuits of Class E chopper for the different…

Q: What will be the charge and mass of an electron? I am stuck. Please help. Will give good feedback.

A: Electrons are negatively charged particles and they revolve in elliptical orbits around the atomic…

Q: a. Draw the block diagram for the digital frequency meter. b. Explain the operation of digital…

A: a.Draw the block diagram for digital frequency meter. b.Explain the operation of digital frequency…

Q: What is the cross over distortion in class B?

A: In the given questions we need to discuss about the cross over distortion in class B amplifier.

Q: A circuit has two pushbutton switches connected to pin PB2and PB3 and two LEDs connected to pin PC0…

A:

Q: The total turn ON time of SCR is 21 . If the sum of spread and rise time is 19 , the delay time of…

A: total turn on time of SCR = delay time + rise time + spread time therefore delay time  =turn on time…

Q: Subject:electronic engineering How BJT acts as a switch?

A: One of the major applications of the Bipolar Junction transistors is the switch. The transistor act…

Q: Q#O4) Explain in detail the performance enhancement technique Pipelining, also provide example of…

A:

Q: The frequency shift keying is based on a digital carrier. a sophisticated digital modulation…

A: We know that Frequency-shift keying is a frequency modulation scheme in which digital information is…

Q: Create a sequence detector that detects the sequence 1001 or 0110 by using Verilog Code. Construct…

A: Detects the sequence 1001 or 0110 by using Verilog code.

Q: What do you mean by cutoff voltage for JFET?

A: The JFET is the abbreviation for junction field effect transistor. There are two types of JFET…

Q: your take on the FSF and what it entails.

A:

Q: Problem 2: Digital VLSI What is setup time and what is hold time?

A:

Q: Can We usẽ a non-conducting tip STM? EXplälh your answer.

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: For a boost converter operating in continuous conduction mode, when the dc input voltage is 10…

A:

Q: Which is easier to use a bnc connector or sma connector

A: BNC are bigger and easier and faster to handle. SMA are quite a bit higher in frequency capability…

Q: When the pinch-off voltage is exceeded, ID will ____ as VDD increases.   a. double   b.…

A:

Q: Q5: Explain the function of three Forces Involved in A Deflection Instrument illustrate the…

A: The other name for the deflection instrument is the indicating type instrument. The indicating…

Q: IV- Define with draw the block diagram the sensor fusion.

A: Sensor fusion aims to overcome the limitations of individual sensors by gathering and fusing data…

Q: I have four ESP-WROOM-32D boards, and four NRF24L01 modules. Each ESP-WROOM-32D board is connected…

A: You can use the RF24 library for NRF24L01 modules and the ArduinoJson library for handling JSON…

Q: I opened a broken Coin Pusher Arcade game to fix, and I saw a burned IC. Between Microprocessor and…

A: An arcade game is a game machine which usually found in public places like malls, restaurants and…

Q: a) Explain the operational concept of the components below that is included in a…

A:

Q: How exactly does one go about clearing an EPROM for the very first time?

A: EPROMs (Erasable Programmable Read-Only Memory) are non-volatile memory devices that can be…

Q: what are the kinds of circuit that can control the bass/treble in an audio system. with some…

A: In an audio system,tone control circuits attenuates the low or high frequency of the input…