Two smooth spheres of weight W and radius r each are in equilibrium in a horizontal channel of A and B vertical sides as shown in the figure. Find the force exerted by each sphere on the other. Calculate these values, if r - 250 mm, b = 900 mm and W = 100 N.

Two smooth spheres of weight W and radius r each are in equilibrium in a horizontal channel of A and B vertical sides as shown in the figure. Find the force exerted by each sphere on the other. Calculate these values, if r - 250 mm, b = 900 mm and W = 100 N.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The following figure shows a hollow piston of weight W=50 N and diameter D=3d occupies the position initial displayed. The lateral tube has a diameter d₁=d/2. Find the descent of the piston for the equilibrium position. (b=12 cm, d=8 cm, y=104 N/m³). TBL Agua D d₁
Hey...please help me here 1) Calculate the magnitude of the force in member CA in Newtons. 2) calculate the magnitude of the reaction force's horizontal and vertical component at the pin connection B in newtons.
Two weights, A and C, are fixed to a bar, B. Their masses are: A = 60 kg, B = 230 kg,C = 45 kg. B is, in turn, connected to a fixed vertical post by a hinge and a support cableD. The geometry of the system is shown at right. Treat weights A and C as point masses a)What is the tension in support cable D? Be sure to include a detailed freebody diagram to accompany your analysis.b) What is the magnitude of the force provided by the hinge?c) What is the moment of inertia of the A + B + C as a rigid system, for rotationabout the hinge? For analysis, break the beam into a short piece to the left of thehinge, and a separate longer piece to the right of the hinge. If the support cable D on should break,d) what is the angular acceleration of the beam and weights at the moment the cable breaks?e) what is the magnitude of the linear acceleration experienced by each of the weights, A and C, at moment the cable breaks?
The spring in Fig. is unstretched when e = 6 = 15°. Find the angle 6 for equilibrium if mg = 60 kg, mp = 25 kg, L=1 m, and & - 750 N/m. Assume that the masses of the bars are negligible. D mp
The light boom AB is attached to a vertical wall by a ball and socket joint at A and supported by two cables at B. A force P is applied at B where P = 18i - 15j kN.Note that the reaction force at A acts along the boom because it is a two-force member. Calculate the magnitude of the reaction force at A in kN.
Determine the magnitude of the moment of P about the origin (point O) in Nm. Answer: Answer
The Cylinder weighs 1000 kg, rest on an plane which is inclined at 34° from the horizontal. The normal force acting on a plane to the cylinder is 10 KN. Assume smooth surface, the cylinder leaned to a vertical rod of 8m long and has a weight of 5 KN which was supported by a cable and a hinged (as shown). Find the tensile force of the cable holding the rod and the reactions of hinged to support the cylinder from sliding.
Please answer this within 30 mins! I will upvote !
Determine the reactions at point A and B of the parallel force system shown in the figure to the right. Neglect the weight of the supporting member. 5940 lb 1170 lb/ft B 3.00- 5.00 -6.00 4.00- LENGTH IN FEET Question 2 v Saved Listen Location from the left end of the beam to the concentrated load that will replace the uniformly distributed load:
20 kg 75 kg 30° 60° Two cylinders having 75 kg and 20 kg mass are konnected with a cable and held in equilibrium on smooth surfaces as shown in the figure. Determine the contact forces between the cylinders and the surfaces, the tension in the cable and the angle 0.
Find the weight of WB necessary to hold WC in the position shown, given:WC = 250 N, θ = 20 °, Φ = 10 °, x,y,h = 4,3,5, respectively