Two reservoirs A and B having elevations 250 m and 100 m, respectively are connected  by a 250-mm diameter pipe 250-m long, A turbine is installed between the two reservoirs.  The flow of water in the pipe is 140 L/s. Use C = 120. Determine the following: a. Head loss in the pipe due to friction.

Q: 1-The storage tank shown below is to be used to supply a community such that the pressure at Point B…

A: Q= ,  , D = 600mm=0.6m , L = 1000mTo Determine: Water Depth(h) in the tank that will meet the design…

Q: A sump pump (used to drain water from the basement of houses built below the water table) is…

A:

Q: A rectangular channel has a width b = 19 m. The critical specific energy in the channel (E) = 28 m.…

A: GIVEN DATA:- WIDTH OF RECTANGULAR CHANNEL=19 M CRITICAL SPECIFIC ENERGY OF CHANNEL EC=2.8 M

Q: A pipe of 0.7 m diameter has a length of 6 km and connects two reservoirs A and B. The water level…

A:

Q: 22. A 350 mm pipeline 3000 m long runs on a constant grade between two reservoir of surface…

A: The objective of the question is to calculate the energy produced by the pump. The energy produced…

Q: (5 points) It is proposed to build a 1000 MWelectric power plant with steam as the working fluid.…

A: Given:- power of electric power plant= 1000MW  Maximum steam temperature= 550°C  Pressure in…

Q: an irrigation line carries water from a lake down into an arid valley floor 810 ft below the surface…

A: step 1-

Q: Water is being discharged from an upper reservoir to a lower reservoir through a turbine (assume 80%…

A: Given  Discharge = 0.15 cumec Efficiency = 80%  Height difference = 197.3- 50 = 147.3 m To calculate…

Q: Two reservoirs 1500 m apart have a water surface elevation difference of 18 m. A cast iron pipe with…

A:

Q: Water 6 m F₂ Figure la F₁ 2 m Gate m

A:

Hydroelectric Energy

Hydroelectric energy is also known as hydropower or hydroelectricity. The term hydropower refers to the power obtained from water motion. By the term 'power', primarily means the generation of electricity. A hydropower plant or hydroelectric power plant utilizes the kinetic energy or pressure energy of flowing water into electrical energy. Unlike conventional energy sources used for power generation, electricity obtained from hydraulic power contributes to zero greenhouse gas emissions.