Two large parallel plates at temperatures 1000 K and 600 K have emissivity of 0.5 and 0.8, respectively. A radiation shield has emissivity 0.1 on one side and 0.05 on the other side is placed between plates. Calculate the heat transfer rate by radiation per square meter with and without a shield

Two large parallel plates at temperatures 1000 K and 600 K have emissivity of 0.5 and 0.8, respectively. A radiation shield has emissivity 0.1 on one side and 0.05 on the other side is placed between plates. Calculate the heat transfer rate by radiation per square meter with and without a shield

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The door of an oven in the kitchen of a house is 0.5 m high and 0.7 m wide. When the oven is operating, the outside temperature of the door reaches 32°C. Calculate the heat transfer from the oven door towards the room at 22°C, taking into account the effects of radiation. The emissivity of the oven door is 1 and the walls of the kitchen are at 22°C. (σ = 5.67 x 10-8 W/m 2K4 , g = 9.81 m/s2 ) NOTE: More precise values for weather characteristics can be obtained from resources on the internet. Also indicate the source you received.
An astronaut performing an extra-vehicular activity(space walk) shaded from the Sun is wearing a spacesuitthat can be approximated as perfectly white (e = 0) exceptfor a 5 cm × 8 cm patch in the form of the astronaut’snational flag. The patch has emissivity 0.300. The spacesuitunder the patch is 0.500 cm thick, with a thermalconductivity k = 0.0600 W/m °C , and its inner surface isat a temperature of 20.0 °C . What is the temperature of thepatch, and what is the rate of heat loss through it? Assumethe patch is so thin that its outer surface is at the sametemperature as the outer surface of the spacesuit under it.Also assume the temperature of outer space is 0 K. You willget an equation that is very hard to solve in closed form,so you can solve it numerically with a graphing calculator,with software, or even by trial and error with a calculator.
Consider a silicon wafer positioned in a furnace that is zone-heated on the top section and cooled on the lower section. The wafer is placed such that the top and bottom surfaces of the wafer exchange radiation with the hot and cold zones respectively of the furnace. The zone temperatures are Tsur,h = 1050 K and Tsur.e = 330 K. The emissivity and thickness of the wafer are e = 0.65 and d = 0.78 mm, respectively. With the ambient gas at T. = 700 K, convection heat transfer coefficients at the upper and lower surfaces of the wafer are 8 and 4 W/m²-K. Find the steady-state temperature of the wafer, in K. Tw i K
Determine the heat loss by radiation from an oven wall to the wall of a room to which the oven wall is directly facing. Assume that no heat flows through the adjacent walls, which are coated with a reradiating material. The oven wall is square, 4 ft on one side, and is 2 ft from the room wall and parallel to it. The oven wall is steel sheet and is at 400°F, and the wall is at 80°F and is of asbestos board.
A long, thin-walled horizontal tube 10.0cm in diameter with an emissivity of 0.80 is maintained at 120.0°C by the passage of pressurized steam inside the tube. To reduce radiation heat transfer losses, a round, tubular radiation shield with an emissivity of 0.10 is installed surrounding the heated tube, with a gap of 1.00cm between the outside of the tube and the radiation shield. At steady-state operating conditions, the temperature of the radiation shield is measured to be 35.0°C. Calculate the total heat transfer rate per meter length assuming that the gap between the pipe and heat shield is now filled with air at a pressure of 1.00 atm.
A concentric cylinder with outer and inner radii of 8 cm and 6 cm, respectively, has length of 1 mwith emissivities of the inner and outer radii at 0.4 and 0.6, respectively. Determine the heattransfer from the outer cylinder to the inner cylinder if the inner and outer temperatures are400K and 600K, respectively.
A composite wall is comprised of two large plates separated by sheets of refractory insulation. In the installation process, the sheets of thickness L = 50 mm and thermal conductivity k = 0.05 W/mK are separated at 1-m intervals by gaps of width w = 10 mm. The hot and cold plates have temperatures and emissivities of T1 = 400 deg C, emissivity1 = 0.85 and T2 = 35 deg C, emissivity2 = 0.5, respectively. Assume that the plates and insulation are diffuse-gray surfaces. %3D Determine the heat loss by radiation through the gap per unit length of the composite wall (normal to the page). Recognizing that the gaps are located on a 1-m spacing, determine what fraction of the total heat loss through the composite wall is due to transfer by radiation through the insulation gap. Hot side Gap w = 10 mm A. 47 W/m, 9.2% T1 = 400°C B. 47 W/m, 10.2% L = 50 mm C. 37 W/m, 10.2% D. 37 W/m, 9.2% T2 = 35°C Cold side 1 m Insulation, k = 0.05 W/m-K
A long electrical conductor of 10 mm diameter is concentric with a refrigerated cylindrical tube of 50 mm diameter whose surface has an emissivity of 0.9 and temperature of 27 °C. The electrical conductor has a surface emissivity of 0.6 and dissipates 6.0 W per meter length. Assuming that the space between the two surfaces is empty, calculate the surface temperature of the conductor.
A tube pipe is heated to a temperature of 150°C with an outside diameter of 12cm and it’s enclosed in a large room of 20°C. Calculate the radiant heat loss per unit length, if the surface emissivity is 0.65.
. Calculate the heat transfer rate per m² area by radiation between the surfaces of two long cylinders having radii 100 mm and 50 mm respectively. The smaller cylinder being in the larger cylinder. The axes of the cylinders are parallel to each other and separated by a distance of 20 mm. The surfaces of inner and outer cylinders are maintained at 127°C and 27°C respectively. The emissivity of both the surfaces is 0.5.
An opaque surface which is insulated at the back side has a total, hemispherical absorptivity a=0.8 for solar radiation and a total, hemispherical emissivity of e=0.2. A solar radiation flux of 800 W/m2 is incident on this surface. The surface is exposed to the ambient air at T 300 K and convective heat transfer coefficient is h=15 W/m2 K. Neglect the sky radiation. • Sketch the heat fluxes received and dissipated by this surface • Estimate the equilibrium temperature of the surface (assume the surface temperature is higher than the ambient air temperature). 1.= 300 K, h-15 W/m*K 800 W/m? a-0.8 , e-0.2
Two very large parallel plates are kept at uniform temperatures T1=800 K and T2=500 K, and have emissivities ε1=0.2 y ε2=0.7, respectively, as shown in the figure. Determine the net rate of radiation heat transfer between the two surfaces per unit surface area of the plates.