Two kg of Argon at 25 deg C, 1 bar are contained in a rigid tank connected by a valve to another rigid tank containing 1.6kg of O2 at 127 deg C, 4.5 bar. The valve is opened, and the gases are allowed to mix, achieving an equilibrium state at 85 deg C. Determine: The volume of Argon tank The volume of 02 tank Final pressure after mixing: m3 m3 bar

Two kg of Argon at 25 deg C, 1 bar are contained in a rigid tank connected by a valve to another rigid tank containing 1.6kg of O2 at 127 deg C, 4.5 bar. The valve is opened, and the gases are allowed to mix, achieving an equilibrium state at 85 deg C. Determine: The volume of Argon tank The volume of 02 tank Final pressure after mixing: m3 m3 bar

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A gear drive A has a diameter of 2 inches and gear drive B has a diameter of 6 inches. Calculate the speed in RPM of the larger gear if the smaller gear is rotating at a speed of 150 RPM.
Identify the true statement from the following a. Unit of cutting speed in millimetre per minute b. Unit of feed is in meter per tooth c. Unit of cutting speed is in meter per second d. Unit of feed is millimetre per tooth
What depth of cut is needed for a ¾ inch wide keyway in a 3 inches diameter shaft?
The temperature distribution at a certain input of time in concrete slab during curing is given by T= 3+3r + 16 where x is in cm and T is in K. The rate of change of temperature with time is given (a = 0.003 cm2/s). (a) 0.009 K/s (b) 0.0048 K/s (c) -0.0012 K/s (d) -0.0018 K/s
In which lathe operation enlarging the already drilled hole can be produced. O Profilng O Knurling operation O Parting off O Boring operation
Q7
Determine the number of fully rotating cranks in the planar mechanisms shown below. Show your calculations.
What is the MMC of shaft "C"?
In a taper turning operation 35 is the diameter of the large end in mm, 25 is the taper angle in ° and 24 is the length of taper in mm. Find the diameter (d) of the small end in mm Diameter (d) of the small end in mm
is the lathe operation, which is performed without the cutting tool moving perpendicular to the axis of workpiece. Grooving Operation Knurling Parting-Off O Facing
TYPEWRITTEN ONLY PLEASE FOR UPVOTE. DOWNVOTE FOR HANDWRITTEN. DO NOT ANSWER IF YOU ALREADY ANSWERED THIS. I'LL DOWNVOTE.
Q1. The lathe operates on the principle of.. a. the cutter revolving against the work piece. b. the cutting tool, that can be controlled, can be moved vertically across the work piece_ c. the work piece rotating against the cutting tool, which can be controlled. d. both cutter and work piece rotating.