Two impedances Z=2+j4 and Z= R+j0, are connected in parallel. Determine R so that the pf of the circuits is 0.9 lagging.

Q: d) A coil of negligible resistance and inductance 110mH is connected in series with a capacitance of…

A: d)

Q: The junction temperature in a BJT is 45° Celsius, the ambient temperature or surrounding temperature…

A: To calculate the thermal resistance of the BJT, we need to use the formula: Thermal Resistance (θ)…

Q: Q6) A 1000 KVA 50Hz 34500/400 Volt, AY distribution transformer has an equivalent resistance and…

A: In this question we need to find the primary voltage and voltage regulation of the given transformer…

Q: 6) Find Nodal matrix and find Vo(t) for t> 0 using Laplace transformer. 10 www 3u(t) A CO5F 2023…

A: The given circuit isWe need to determine the nodal matrix and vo(t) for t > 0 using Laplace…

Q: A coil of resistance of 15 ohms and inductance 0.05 H is connected in parallel with a non-inductive…

A:

Q: (ii) A current transducer was used to monitor the usage of the electric heater. The signal power at…

A: Solution of question 1.(a).(ii): Given information, The signal power input of the current transducer…

Q: Find the Fourier transforms of a) x(t) = 2u(t + 1)-8u(t - 2) + 6u(t - 3) b) y(t) = 6 cos 5t c) z(t)…

A:

Q: An inductive coil with a resistance R and inductance L is connected in parallel with a 30 ohm…

A:

Q: 8N www Isc 24V Vo 2V₂ www. 452 20 www Rth ܕܢ www a) Determine the Thevenin equivalent of the circuit…

A:

Q: A coil of 50 ohm resistance and of 150 mH inductance is connected in parallel with a 50 micro-farad…

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines…

Q: Determine Ve and lo for the configurations in Figure Q4 using the approximate equivalent model for…

A: Given that diodes are Si diodes. Cut-in voltage of Si diode is 0.7 V. First check, which diodes are…

Q: With Is=1.0 Amps, R1-50 ohms, R2=30 ohms, and C= 310 ufarads What is Vc( t = 0 sec) when the switch…

A: The circuit diagram,The value of resistors,The capacitor,

Q: 01 A 230-V d.c. shunt motor has an armature resistance of 0.3Q and field resistance of 115 Q. At no…

A:

Q: A resistor and an inductor a

A:

Q: 6. Evaluate the voltages at all nodes and the currents through all branches. Assume: VBE (or VEB for…

A: Given:

Q: A coil of a 50 ohm resistance and of 150 mH inductance is connected in parallel with a 50 µf…

A:

Q: A given load takes 40 kVA at 50 % lagging power factor while another load connected in parallel…

A:

Q: Implement a full-adder circuit with a decoder and two OR gates.

A: Implementation of a full adder circuit with a decoder and two OR gates.

Q: Question 4: Determine the diode state and the values of I and VR for the circuit below, assuming…

A: Need to determine the diode state and the values of I and VR for the given circuit.

Q: A source alphabet consists of N symbols with the probability of the first two symbols being the…

A: The number of symbols in the source alphabet is "N". The probability of the first two symbols is the…

Q: A source of 100 volts rms is supplying a resistance 80 ohms in parallel with a 200 mH inductor. To…

A:

Q: An impedances Za=4+j4 ohms is connected in parallel with an impedance Zb=12+j6. The input reactive…

A:

Q: A choking coil of inductance 0.08 H and resistance 12 ohms, is connected in parallel with a…

A:

Q: Determine the output y(t) and generate a plot of both the input, x(t) and the output y(t). The…

A:

Q: A resistance of 20 ohms and an unknown capacitance are connected in parallel across a 110 V,…

A:

Q: Problem 10:Given that y(-1)=5 and y(-2)=0, Solve the difference equation, yn - 3yn-1-4yn2 = 0, n ≥ 0

A:

Q: In a series-parallel circuit, the two parallel branches A and B are in series with C. The impedances…

A:

Q: Write the VHDL code that will implement this function. Please respect the VHDL syntax and upload…

A:

Q: coil of inductance 120µH and 8 2 resistance and (iii) a 6 2 resistor in series with a 0.3µF…

A:

Q: white noise has a 2-sided power spectral density of kW/MHz. It is passed through a low pass filter…

A: The two-sided power spectral density is 6 kW/MHz.This white noise is passed through a low pass…

Q: arallel branches have admittances 0.3 + j0.4 and 0.2 – j0.25, respectively. If the curren first…

A: Solve the problem

Q: A parallel circuit consists of a resistor having a conductance of 4 siemens, an inductive reactor…

A:

Q: A resistor R is connected in parallel with a 10 ohm inductive reactance. The combina then connected…

A: Solve the problem

Q: A capacitor branch having a ratio of Xc to R of 5 is paralleled with an impedance consisting of a 4…

A: In this question one parallel circuit is given which includes RL and RC branch... Overall power…

Q: Two impedances, Z1= 0.8 + j5 .6 and Z2 = 8 - j16 and a single-phase motor are connected in parallel…

A:

Q: G4 C G2 G3 G6 + R(s) G1 H1 G5 H.

A: Simple problem on control analysis. look below for the solution once

Q: b) For the 4-bit bidirectional shift register, determine the state of the register after each clock…

A:

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.