Two half-wave dipoles are arranged as shown in the figure below, with antenna 1 transmitting 300W at 300MHz. The current maximum in antenna 1 is known to be 2.87 A. Find the open-circuit voltage induced at the terminals of the receiving antenna, which is antenna 2. Hint: Consider the vector effective length concept. Notice that the antennas are 100m apart from each other. Take the impedance of free space to be 120m 2, and the speed of waves to be 3x108 m/s. Select one: O 0.2 V O O 0.5 V 1.0 V 1.2 V 2₁₁ 0₂ = 90° 60° r = 100 m

Two half-wave dipoles are arranged as shown in the figure below, with antenna 1 transmitting 300W at 300MHz. The current maximum in antenna 1 is known to be 2.87 A. Find the open-circuit voltage induced at the terminals of the receiving antenna, which is antenna 2. Hint: Consider the vector effective length concept. Notice that the antennas are 100m apart from each other. Take the impedance of free space to be 120m 2, and the speed of waves to be 3x108 m/s. Select one: O 0.2 V O O 0.5 V 1.0 V 1.2 V 2₁₁ 0₂ = 90° 60° r = 100 m

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

(a) A rectangular waveguide with an inner dimension of (4.0 x 2.0) cm is used for propagating a microwave signal at mode TE11. If the microwave frequency given is 12 GHz, calculate the cut-off frequency, cut-off wavelength, guide wavelength and velocity of the waveguide.
We have discussed in class that a wire should be treated as a transmission line when its length exceeds an appreciable fraction of the wavelength. If this fraction is 1%, calculate the maximum frequencies at which you can neglect the transmission line effects for the following (assume the wave velocity is equal to speed of light in free space) and make the comparisons indicated: a. Power line of length 300 km (How does this frequency compare with the line frequency used for AC power?) b. Phone line of length 3 km c. USB cable of length 0.3 m (How does this compare with today's USB data rates?) d. CMOS circuit trace of length 300 μm (How does this compare with today's processor frequencies?)
For an Omni-directional antenna, the measurements show the Half Power Beam Width (HPBW) in vertical and horizontal planes are 30 degree and 20 degree respectively. If this antenna has a loss resistance of 25ohm and efficiency n=0.8, calculate:i. Antenna’s gain in dB;ii. Radiation resistanceiii. How the efficiency of this antenna can be improved? Support your answer with applicable equations and results.
I am struggling with this question
A 10 GHz uniform plane wave is propagating in the positive z direction and is incident from free space to a fiberglass (e,= 4.9, Ho, o = 4.9, Mo, the Air Eo. Ho 0) radome as in Figure 4. Fiberglass e=4.9 Poia=0 Figure 4 Air Eo. Po a) Determine the thickness of the radome so that there will be no reflection. b) If the amplitude of the incident electric field 1 = 100 ejot and if we maintain the same physical thickness (in meters) of the fiberglass radome determined in part (a), use a Smith chart to determine the amplitude of the transmitted electric field in the fiberglass when the frequency is decreased by 10%.
answer #4
1. A quarter-wave dipole oriented on z-axis is placed vertically at a height of h = 0.285A above an infinite electric ground plane, a. Write the expression of the electric field, b. Plot the element factor, array factor, and total pattern on yz-plane, c. Redo parts (b) if h = 0, d. Find the input impedance of the dipole if h = 0.
I need a solution within 15 minutes
Antenna connected to a 150- lossless line, produces a standing wave ratio of 2.6. Ifmeasurements indicate that voltage maxima are 120 cm apart and that the last maximum is 40 cmfrom the antenna, calculate:(1) The operating frequency(2) The antenna impedance(3) The reflection coefficient. Assume that the phase velocity = c.
A centre fed linear dipole antenna, three and half wavelength long, has a feed current of 15 A RMS. Calculate the rms electric field at seven wavelength away from the antenna.
Problem 2.4 Assume that the antennas in Problem 2.3 are dish antennas such that A =. If the beamwidth factor for either antenna is 51°, find the beamwidth of each antenna for each frequency. Problem 2.5 A receiver is located 5 km from a transmitter in free space. The output at the termi- nals of the receive antenna is -87 dBm. The receive antenna has a gain of 2 dBd and there is a total of 2.8 dB of system loss. Calculate the transmitter EIRP in watts given a transmit frequency of 890 MHz. If the transmit antenna has a gain of 7.5 dBi, what is the transmit power in watts? Problem 2.6 A transmitter radiates an ElIRP of 1 W into free space. A receive antenna located at 1 km from the transmitter has a gain of 5 dBi. Assume that there are 2 dB of system loss. A. If the system operates at 900 MHz, what is the power level at the output of the ontonna terminals?
if in a rectangular waveguide for which a=2b , the cuttoff frequency for TE02 mode is 12 GHz ,the cutoff frequency for TM11 mode is