Two gaseous streams enter a mixing chamber through two sections and leaves through one section. Entrance conditions are: A₁ = 450 cm2, ₁ = 150 m/s, v₁ = 0.625 m³/kg and A₂ = 380 cm², v₂ = 55 m/s, P₁ = 2 kg/m³. At the exit conditions are: 3 = 245 m/s and v3 = 0.58 m³/kg. Determine the area of the exit section.

Two gaseous streams enter a mixing chamber through two sections and leaves through one section. Entrance conditions are: A₁ = 450 cm2, ₁ = 150 m/s, v₁ = 0.625 m³/kg and A₂ = 380 cm², v₂ = 55 m/s, P₁ = 2 kg/m³. At the exit conditions are: 3 = 245 m/s and v3 = 0.58 m³/kg. Determine the area of the exit section.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

4) In the deep drawing of cups, blanks show a tendency to wrinkle up around the periphery (flange). The most likely cause and remedy of the phenomenon are respectively: Buckling due to circumferential compression; Increase blank holder pressure. High blank holder pressure and high friction; Reduce blank holder pressure and apply lubricant. High temperature causing an increase in circumferential length; Apply coolant to blank. Buckling due to circumferential compression; decrease blank holder pressure.
When does stress concentrations become important?
It is simple, help me to describe the part and write the steps of how to draw it in Solid Works
list five important criteria in predesign analysis for the whole process fabricating the jigs and fixtures.
23 Explain the difference between recovery and recycling as applied to solid industrial
For the mass production of flat metal sheet shapes; Waterjet cutting is the most appropriate manufacturing solution Stamping is used to obtain the sheet geometry Casting is an optimal solution Laser cutting is the optimal choice
How do you work with Sketch in SOLIDWORKS?
Explain with neat sketch, the surface finishing process of “Sandblasting
nQ2. Write short notes on Surface treatment process. List any two examples for Joining and assembly process.
Please don't provide handwritten solution .....
Describe working and environmental conditions that lead to failure for a product made from material from each of the four material categories.
If you were manufacturing a precision component which has a mass of around 15 grams and which was a solid 3D shape, which method would be appropriate?