Two conductive spheres with radii of 0.3 and 0.9 m are placed far apart from each other. The small sphere has an electric field of 15000 N/C on its surface, while the other sphere is uncharged. If these spheres are connected to each other with a non-resistive wire, how many uC load will pass to the big sphere? O A) 0,1 O D) 0,4 O B) 0,5 O E) 0,2 O C) 0,3

Two conductive spheres with radii of 0.3 and 0.9 m are placed far apart from each other. The small sphere has an electric field of 15000 N/C on its surface, while the other sphere is uncharged. If these spheres are connected to each other with a non-resistive wire, how many uC load will pass to the big sphere? O A) 0,1 O D) 0,4 O B) 0,5 O E) 0,2 O C) 0,3

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter7: Electric Potential

Section: Chapter Questions

Problem 90AP: (a) Find the voltage near a 10.0 cm diameter metal sphere that has 8.00 C of excess positive charge...

See similar textbooks

Similar questions

(a) Calculate the number of electrons in a small, electrically neutral silver pin that has a mass of 10.0 g. Silver has 47 electrons per atom, and its molar mass is 107.87 g/mol. (b) Imagine adding electrons to the pin until the negative charge has the very large value 1.00 mC. How many electrons are added for every 109 electrons already present?
The electric field strength between two parallel conducting plates separated by 4.00 cm is 7.50 104 V/m. (a) What is the potential difference between the plates? (b) The plate with the lowest potential is taken to be at zero volts. What is the potential 1.00 cm from that plate (and 3.00 cm from the other)?
A water molecule is made up of two hydrogen atoms and one oxygen atom, with a total of 10 electrons and 10 protons. The molecule is modeled as a dipole with an effective separation d = 3.9 1012 m between its positive and negative particles. What is the electric potential energy stored in the dipole? What does the sign of your answer mean?
Two parallel conducting plates are separated by 10.0 cm, and one of them is taken to be at zero volts, (a) What is the electric field strength between them, if the potential 8.00 cm from the zero volt plate (and 2.00 cm from the other) is 450 V? (b) What is the voltage between the plates?
(a) Find the voltage near a 10.0 cm diameter metal sphere that has 8.00 C of excess positive charge on it. (b) What is unreasonable about this result? (c) Which assumptions are responsible?
A large parallel-plate capacitor is attached to a battery that has terminal potential (Fig. 27.15A). After a period of time, the capacitor stores charge Q so that its top plate is positive and its bottom plate is negative, and the potential difference between the plates is VC = . An I-shaped neutral conductor consisting of two parallel plates connected by a wire is slipped between the plates of the capacitor so that all four plates are parallel (Fig. 27.15B). What are the charges q1, and q2 on the plates of the I-shaped conductor? What is the potential difference VC between the top and bottom plates of the capacitor?
Lightning can be studied with a Van de Graaff generator, which consists of a spherical dome on which charge is continuously deposited by a moving belt. Charge can be added until the electric field at the surface of the dome becomes equal to the dielectric strength of air. Any more charge leaks off in sparks as shown in Figure P20.67. Assume the dome has a diameter of 30.0 cm and is surrounded by dry air with a breakdown electric field of 3.00 106 V/m. (a) What is the maximum potential of the dome? (b) What is the maximum charge on the dome? Figure P20.67 David Evison/Shutterstock.com
A particle with charge 1.60 1019 C enters midway between two charged plates, one positive and the other negative. The initial velocity of the particle is parallel to the plates and along the midline between them (Fig. P26.48). A potential difference of 300.0 V is maintained between the two charged plates. If the lengths of the plates are 10.0 cm and they are separated by 2.00 cm, find the greatest initial velocity for which the particle will not be able to exit the region between the plates. The mass of the particle is 12.0 1024 kg. FIGURE P26.48
Find an expression for the electric field between the two conducting disks in Figure P27.61. Make sure your expression is general enough to include the possibility of a dielectric between the disks. Check your answer using the information given in Section 27-8. Figure P27.61
(a) Will the electric field strength between two parallel conducting plates exceed the breakdown strength for air ( 3.0 106 V/m) if the plates are separated by 2.00 mm and a potential difference of 5.0 103 V is applied? (b) How close together can the plates be with this applied voltage?
Two square plates of sides are placed parallel to each other with separation d as suggested in Figure P20.86. You may assume d is much less than . The plates carry uniformly distributed static charges +Q0 and Q0. A block of metal has width , length , and thickness slightly less than d. It is inserted a distance x into the space between the plates. The charges on the plates remain uniformly distributed as the block slides in. In a static situation, a metal prevents an electric field from penetrating inside it. The metal can be thought of as a perfect dielectric, with . (a) Calculate the stored energy in the system as a function of x. (b) Find the direction and magnitude of the force that acts on the metallic block. (c) The area of the advancing front face of the block is essentially equal to d. Considering the force on the block as acting on this face, find the stress (force per area) on it. (d) Express the energy density in the electric field between the charged plates in terms of Q0, , d, and 0. (e) Explain how the answers to parts (c) and (d) compare with each other. Figure P20.86
Each of the following statements is related to conductors in electrostatic equilibrium. Choose the words that make each statement correct. (i) The net charge is always zero [(a) inside; (b) on] the surface of an isolated conductor. (ii) The electric field is always zero [(c) inside; (d) just outside] a perfect conductor. (iii) The charge density on the surface of an isolated, charged conductor is highest where the surface is [(e) sharpest; (f) smoothest].