Two coils are placed close together in a physics lab to demonstrate Faraday's law of induction. A current of 5.4 A in one is switched off in 1.00 ms, inducing a 9.35 V emf in the other. What is their mutual inductance? 1.15 103 mH Show hint

Q: 2100 turns of wire are wrapped in a solenoid that is 5.0 cm long, with a cross sectional area of 2.2…

A:

Q: An indictor with inductance L = 0.2 H and negligible resistance is connected to a battery, a switch…

A: Given:  L = 0.2 H R2 = 10 ohms R1 = 15 ohms  E = 80 Volts

Q: 6. a. Calculate the inductance of a solenoid containing 300 turns if the length of the solenoid is…

A: Given data- turns n=300,   length l=25 cm=0.25 m,  cross sectional area A=4×10-4 m2 Inductance of a…

Q: A coil has 2.55-ΩΩ resistance and 121-mH inductance. If the current is 3.00 A and is increasing at…

A:

Q: 3. A 12.0 V battery is connected in series with a 10.0 O resistor, an inductor and a switch. At time…

A:

Q: The self-inductance of the circuit in the figure below is 9.60  10-8 H. Find the back emf when the…

A: Given data The self-inductance is given as L = 9.60 x 10-8 H. The rate of increase in current is…

Q: Camera flashes charge a capacitor to high voltage by switching the current through an inductor on…

A:

Q: The self-inductance of the circuit in the figure below is 1.10 x 10-7H. Find the back emf when the…

A: Given: The inductance of the circuit is 1.1x10-7 H. The rate of current increasing at the rate of…

Q: A solenoid of radius 3.5 cm has 580 turns and a length of 25 cm. Find its inductance. ______mH…

A:

Q: primary voltage to many thousands of volts in order to produce electric sparks several inches long.…

A: Based on bartleby  policy I am only answering  1st three sub parts if you want complete  answer…

Q: A 506-turn solenoid has a radius of 7.80 mm and an overall length of 12.6 cm. (a) What is its…

A: Given,  Number of turns, n=506 radius =7.80 mm length =12.6 cm a.  When a coil whose length is much…

Q: In the L-C circuit in the figure, the ammeter reads a maximum cur­rent of I = 5.19 mA. The…

A:

Q: The self-inductance of the circuit in the figure below is 9.10 x 10-8 H. Find the back emf when the…

A:

Q: 4.30 32 3. In the circuit the emf ɛ = 21.3 volts and the inductance L= 150 mH. What will be the…

A: emf (E) = 21.3 volts L = 150 mH = 0.15 H t = 15.5 ms = 0.0155 s

Q: In the circuit, the capacitor is fully charged when switch S is closed. Calculate the time needed…

A: Given data,

Q: coil has 2.55-Ω resistance and 121-mH inductance. If the current is 3.00 A and is increasing at a…

A:

Q: Which of the following statements are true? Choose all that apply. A changing magnetic field will…

A: Choose true statements.

Q: A 15.0 kHz, 32.0 V source connected to an inductor produces a 1.90 A current. What is the inductance…

A:

Q: peak magnetic flux th

A:

Q: The current in a coil drops from 3.5 A to 2.0 A in 0.50 s. Ifthe average emf induced in the coil is…

A: Writing the formula for induced emf:

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.