Two coaxial cylinders 250 mr high have a liquid in between them, the outer cylinder had internal diameter 100 mm and the internal cylinder has external diameter 97.5 mm. Find the viscosity of liquid which produces a torque of 1 Nm upon the inner cylinder when outer one rotates at 90 rpm.

Two coaxial cylinders 250 mr high have a liquid in between them, the outer cylinder had internal diameter 100 mm and the internal cylinder has external diameter 97.5 mm. Find the viscosity of liquid which produces a torque of 1 Nm upon the inner cylinder when outer one rotates at 90 rpm.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: PLEASE ANSWER THE FF GIVEN THE DIAGRAM: 1. The horizontal reaction at A (Ah) is 2. The vertical…

A: Given data: Internal hinge at B.

Q: Two circular shafts are joined together between fixed supports to resist a torsional moment of 80…

A: Given SteelHollow circularDo=100mmDi=80mmG=150GPa AluminiumSolid circularD=75mmG=70GPa To Find…

Q: The 5 ft diameter cylinder weighs 5000 lbs. and is 5 ft long as shown.compute the vertical reaction…

A: Diameter of cylinder (d) = 5 ft Length of cylinder (L) = 5 ft Weight of cylinder (W) = 5000 lb…

Q: The triangular distributed load acting on the beam can be replaced by a concentrated load of ...…

Q: 2 k/ft Ap RUOY TROY3V0 y-1009 - 12 ft 3 k/ft -UZI 8 JETIRAM H2A0-3 2 2 k/ft RSV B 38 WOb BOTYRA

A: Determine the reactions on the beam

Q: The external and internal diameters of a collar bearing are 200 mm and 150 mm respectively. Between…

A: Given: External diameter, D2 = 200 mm = 0.2 m Internal diameter, D1 = 150 mm = 0.15 m Oil film…

Q: Straight beam AE is pin-connected at its one end A and to an L-shaped beam EF at its other 2. 200 lb…

A: Free body diagram of the given problem:

Q: Write the equation in the simplest possible form.

A: The given figure is shown below Assume the deflection at C is δ Draw free body diagram of the span…

Q: 2. The propulsive force drives the jet in the a) Backward direction

A: To find: Populsive force drives jet in which direction.

Q: 5 ft 7.84 Find the smallest angle B for which the uniform crate can be tipped about corner A. Also…

A: Show the free body diagram of the uniform crate as in Figure (1).

Q: 5-A wooden block with a density of q1 is floating completely submerged at the interface of two…

Q: 700 N.m D 0.6 m 1.2m

Q: The buckling load of a slender column clamped at both the ends is 4000 N. The column is subjected to…

Q: поор thickness of 0.25 in., and width of 1 in. If it and t meter rigid cylinder have a temperature…

Q: The flywheel A rotates clockwise under the action of a 700 N-m couple. A band break is to be used to…

Q: Problem (1): Determine the internal torque in shaft (3) 50 N-m 28 N-m 21 N-m 14 N-m (4) E B…

A: When the load is acting on the body or specimen there is some deformation or change in the dimension…

Q: assuming smooth contact surfaces, determine the reactions A,B,C and D on the cylinders as shown in…

A: Consider the reaction force at D is RD and the reaction force at C is RC. Similarly, the reaction…

Q: 3. Determine the ffg: a. resultant force of the forces shown. (in lb) b. reaction at A and (in lb)…

Q: 5 ft 500 lb B 5 ft 1500 lb C 2 ft 5 ft D

A: From the given figure it is required to calculate the unknown forces.

Q: Q9 A shaft of diameter 10 cm having a clearance of 1.5 mm rotates at 180 rpm in a bearing which is…

Q: sm steel helln circular DoI00 mm Di 80 mm duminum Solid circular D= 75 mnv G- D GPo G- 1S0 6Pa

Q: Derive a formula for the pressure difference Pa - P in terms of the system parameters in the figure…

Q: The flywheel A rotates clockwise under the action of a 700 N-m couple. A band break is to be used to…

Q: Example 123. The compound beam is fixed at A, pin connected at B, and supported by a roller at C.…

Q: A load P=5 KN is supported by two concentric springs arranged as shown in figure below. The inner…

A: Load supported by two concentric springs = 5 kNNumber of turns in inner spring, n1 = 30…

Q: Determine the resultant force Por the Rorca system shown below. 201bA 10016 80 1b in

Q: The external and internal diameters of a collar bearing are 200 mm and 150 mm Tespectivery. Between…

A: Given: Internal diameter, D1 = 150 mm = 0.15 m External diameter, D2 = 200 mm = 0.2 m Thickness of…

Q: inimum thickness o o 40 MN/m² and th mm -600r Figures P-1

A: Solution Given That Limited Stress σ=40 MN/m2 Internal Pressure P=1.5 MN/m2

Q: 2000 N/m 1000 N 70ON/m A 1.2m 0.6 .9m 1.8 m

Q: E Oil (0.80) D f B A

A: A we have to determine the reaction at B

Q: The 480-lb V-8 engine is supported on an engine stand and rotated 90 degrees from its upright…

A: It is Given that :

Q: and length L is her shaft B of the me length, but half ed to the same O angles of twist of aloc

Q: 4 KN 3kN Sm C 5m Ē Sm Ġ 5m The reaction at Ay is || KN (two decimal places) The reaction at Hx is KN…

Q: Fluid enters through the eye of the impeller and then travels outward between the vanes of the…

A: Given - Fluid enters through the eye of the impeller and then travels outward between the vanes of…

Q: A U-tube with both limbs open to atmosphere contains two in.miscible liquids of densities P₁ and p2…

Q: c) If the shaft is hollow core and the maximum allowable shear stress in the shaft is 37 MPa,…

Q: water 3cm D=5 cm Mercury The tank in the has a plug at the 5cm diameter bottom. on the rrght. All…

Q: Q/ Find the reaction forces at point (B)

A: Given Data:W=300kg= 300×9.81=2943NL=3.6m

Q: The flywheel A rotates clockwise under the action of a 700 N-m couple. A band break is to be used to…

Q: The angle of twist between A and B is equal to in rad: The angle of twist between B and C is equal…

Question

3.
Two coaxial cylinders 250 mr high have a liquid in between them, the outer
cylinder had internal diameter 100 mm and the internal cylinder has external
diameter 97.5 mm. Find the viscosity of liquid which produces a torque of 1
Nm upon the inner cylinder when outer one rotates at 90 rpm.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data

VIEW

Step 2: Calculation of tangential velocity of outer cylinder

VIEW

Step 3: Calculation of viscosity of liquid

VIEW

Solution

VIEW

Step by step

Solved in 4 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

For ACB beam with elasticity module E and inertia I;a) Find the elastic curve equation by singularity method?b) Find the reaction forces at point A?c) Find the reaction force at point B?
with water and is the tank reads The hight h The gage pre ssure acting Surface long The pressure gogle 0.5 bar. Determine s on open water column and on the bottom tank AB and The abselute pressune of the air in the top of the tank of the local atme în the pressure s 1 bar 0.5 bar open water A
Determine the reaction at the roller support in N. 100 N 200 N 300 N 60 45 30 8 1 m 1m 1m 1 m O 205 O 305 O 285 O 265 O 215 O 315 O 335 O o o o o
13 and 14 please :) ill thumbs up
3. If the coefficient of static friction at contact points A and B is μs = 0.3, determine the maximum force P that can be applied without causing the 100-kg spool to move. : P 343 N ↑ Engineering Mechanics 51 52 0.6 m 0.9 m Lecturer Dr.Isrra Hasan Nayel
i need the answer quickly
The 5 ft diameter cylinder weighs 5000 lbs. and is 5 ft long as shown.compute the horizontal reaction at A (in lb)
Problem-ddd: Consider FIG-ddd in the appendix. Note: The band brake is use... P = 100 N D H = 0.30 300 mm ¡30% 200 mm 100 mm 150 mm A FIGURE-ddd Problem-ddd: Consider FIG-ddd in the appendix. Note: The band brake is used to slow a rotating drum (spinning clockwise about O). a The braking process takes 5 seconds. a The static coefficient of friction between the belt and the drum is 0.50. Calculate: See Blackboard Your analysis is at 2 seconds into the 5 seconds braking process. Problem-ddd The magnitude of the x-component of the reaction force at 'A' is The magnitude of the y-component of the reaction force at 'B' is The magnitude of the "low tension" in the band brake is The magnitude of the angle of belt contact with the drum is N. N. N. radians.
Determine the magnitude and location of the equivalent resultantforce acting on the shaft shown.
Question 7 (a) - Drive the equilibrium equation of motion for 2 DOF system equipped with base isolation as showed in following figure. (b) - Drive base isolation natural frequency. kb mb Xb K₁ www m₁ X₁ K₂ ww m₂ X2
If the 500-kg drum has a center of mass at point G, determine the horizontal component of force acting at pin A on member DAB. The grip at B on member DAB resists both horizontal and vertical components of force at the rim of the drum. Determinne the following reactions : Ax,Ay,NC and ND
Solve, Thank you