Two clay specimens A and B, of thickness 2cm and 3cm, have equilibrium voids rations 0.68and 0.72 respectively under a pressure of 200 kN/m². If the equilibrium voids ratios of thetwo soils reduced to 0.50 and 0.62 respectively, when the pressure was increased to 400kN/m2, find the ratio of the coefficients of permeability of the two specimens. The timerequired by the specimen A to reach 40 percent degree of consolidation is 14 of that requiredby specimen B for reaching 40% degree of consolidation?UNIT - 5

Given: For Clay specimens A : initial void ratio, eo = 0.68 final void ratio, e = 0.50 So,…

Two clay specimens A and B, of thickness 2cm and 3cm, have equilibrium voids rations 0.68 and 0.72 respectively under a pressure of 200 kN/m². If the equilibrium voids ratios of the two soils reduced to 0.50 and 0.62 respectively, when the pressure was increased to 400 kN/m², find the ratio of the coefficients of permeability of the two specimens. The time required by the specimen A to reach 40 percent degree of consolidation is % of that required by specimen B for reaching 40% degree of consolidation?

Two clay specimens A and B, of thickness 2cm and 3cm, have equilibrium voids rations 0.68 and 0.72 respectively under a pressure of 200 kN/m². If the equilibrium voids ratios of the two soils reduced to 0.50 and 0.62 respectively, when the pressure was increased to 400 kN/m², find the ratio of the coefficients of permeability of the two specimens. The time required by the specimen A to reach 40 percent degree of consolidation is % of that required by specimen B for reaching 40% degree of consolidation?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A sample of coarse sand was found to have a void ratio of 0.87 and 0.52 in its loosest and densest states respectively. The in-situ density and water content of the sand were 1.95 g/cm3 and 23%. Determine the relative density of the sand in the field. Choose the corret answer below a.0.53b.0.59c.0.55d.0.57
The total unit weight, relative density, water content, and specific gravity of solids of a given sand are 17.98 KN/m^3, 62%, 7.6% and 2.65, respectively. a. If the minimum void ratio for this soil is 0.35, what would be its maximum void ratio? b. What is its unit weight in the loosest condition?
3. A 405 cm³ volume of fully saturated clay weights 8.1 N and the specific gravity of the solids is 2.70. Given the liquid limit and the plastic limit of the clay are LL (w₁) = 40% and PL (wp )= 10.5%, respectively. (1) Find the plasticity index PI of the clay. (2) What is the liquidity index of the clay? (3) Do you expect a brittle type of failure of this soil? Why?
A sample of uniform sand has a porosity of 43%.From the lab test, the value of the void ratio in theloosest condition is 0.85 and a void ratio of 0.35 inthe densest condition. If the water content is 12%and Gs = 2.7. Determine the following:a) Density indexb) Degree of saturationc) Determine the moist unit weight
4. A sandy soil sample was subjected to a consolidation pressure of 100 kPa and Consolidated drained test was conducted on it. The failure plane angle which the sample made at failure with respect to horizontal was 60°. Find the vertical stress at failure. If instead of increasing the vertical stress, it was decreased gradually, explain why the sample would fail. Obtain the shear and normal stress at failure for both of these conditions.
The laboratory consolidation test is conducted on a clay sample. The following data results were obtained P1 =55 kPa P2 = 130 kPa e1= 0.95 e2= 0.80 Thickness of the sample of clay= 35mm Time for 50% consolidation = 3.0 min Tv= 0.197 a. Find the coefficient of volume compressibility b. Determine the coefficient of consolidation if a sample of clay was drained on both sides c. Compute the hydraulic conductivity of the clay
‘mormally consolidated clay given: 1S kKN/m® ateo=122 = 430 KN/m? ate=098 * 10° m/sec, Find: long in days will it take for a 3 m thick lsyer of the same drained both sides in the field to reach 50% consolidation? is settlement at 50% consolidation?
Following table presents information for a fine-grained soil: Current effective stress (kPa) Current void ratio of the soil Overconsolidation Ratio (OCR) Compression index (Cc) Re-compression index (Cr) 30 0.96 7.06 0.18 0.06 Determine the void ratio of the soil at the preconsolidation pressure.
Consolidation The clay deposit of thickness 10 cm and void ratio 0.5 undergoes settlement and now its final void ratio is 0.2. The thickness (cm) of the settlement layer is
The layer is subjected to a uniform vertical stress increase of 100 kPa. The singly-drained clay layer has a coefficient of consolidation of 20 ft2 /yr. Determine the value of the excess pore pressure at point A 2 years after the application of the load. Also given is the chart giving the local degree of consolidation. a)4.4 kPa b)44 kPa c)88 kPa d)96 kPa
A consolidated undrained triaxial test was performed on a normally consolidated clay with a critical state friction angle of 230. After an initial isotropic consolidation at a cell pressure of 50 kPa, drainage was turned off, the cell pressure was increased to 85 kPa, and the sample was loaded to ultimate conditions. A pore pressure of 55 kPa was measured at ultimate state. What value of major principal total stress was measured at the ultimate state?
A certain saturated sand (S = 100%) has a moisture content of 27.9% and a specific gravity of solids of 2.61. It also has a maximum index void ratio of 0.90 and a minimum index void ratio of 0.33. Compute its relative density and classify its consistency. (Table on the right) Solution: Given the values of mmoisture content, specific gravity and degree of saturation, the void ratio can be estiamted as: e = Thus the relative density is found to be Dr = • According to the table, the soil is classified as %; soil. TABLE 3.3 CONSISTENCY OF COARSE-GRAINED SOILS AT VARIOUS RELATIVE DENSITIES (data from Lambe and Whitman, 1969) Relative Density, D,(%) 0-15 15-35 35-65 65-85 85-100 Classification Very loose Loose Medium denseª Dense Very dense "Lambe and Whitman used the term "medium," but "medium dense" is better because "medium" usually refers to the particle size distribution.