Two blocks of wood 50mm wide and 20mm thick are glued together. a. Using the free body diagram concept, determine the shear load and from it the shearing stress in the glued joint if P = 6000 N. b. Generalize the procedure of part (a) to show that the shearing stress on a plane Psin 20 inclined at an angle 0 to a transverse section of area is Ss = 24 20mm P = 6000 N 60° P = 6000 N wwos

Q: Question 1 B 900 mm 80 mm -40 mm T A The magnesium tube is bonded to the steel rod. Part A If the…

A: Shear stress of magnesium = 45 MPaShear stress of steel = 75 MPaModulus of rigidity magnesium = 18 ×…

Q: Required information Two horizontal 9-kip forces (P) are applied to pin 8 of the assembly shown. A…

A: Given :Diameter d = 0.8 inForce P = 9kip

Q: Question 1 A bar with a circular cross-section of diameter 12 mm is loaded with an axial force of 10…

A:

Q: 4. The rigid beam AB is supported by steel (E = 200 GPa, v = 0.3) rods AC and BD of identical…

A:

Q: as is subjected to a static eccentric force of F=25 kN in the plane of the welds. The allowable…

A: Given:- l1=350mm l2=200m d1=37.5mm d2=75mm

Q: 16 kN 125 mm 3. The two boards are joined by plywood splices that are fully glued on the surfaces in…

A:

Q: 31.1 Determine the shear stress in the bolts of a lap joint held by eight 10 mm diameter bolts if…

A: Given data is

Q: d AB consists of two cylindrical portions AC and BC, a mild steel with E= 200 GPa and oy= 250 MPa,…

A: The FBD is-

Q: Two wooden members shown which support a 4kip load, are joined by plywood splices fully glued on the…

A: Given Data The support load is: P=4 kip The ultimate shearing stress is: τu=360 psi The clearance…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.