Turbine work and compressor work in a Gas turbine cycle are found to be 335 kw and 178000 W respectively. The work ratio will be Select one: O a. 0.53 O b.0.35 O c. 0.88 O d. 0.46

Q: Determine Iy. 50 mm 50 mm 300 mm 50 mm y -200 mm an -X We Problem 4

A:

Q: State the difference between the eutectic and eutectoid points.

A: Eutectic point: In the iron carbon phase diagram at 2 percentage of carbon is called eutectic point.…

Q: Choose one of the following statements which is not true.

A: for solution refer below images.

Q: As the tempering temperature of a heat treated steel increases the associated values of Brinnell…

A: Tempering is a heat treatment technique applied to ferrous alloys, such as steel or cast iron, to…

Q: What is the maximum magnitude of the bending moment caused by force G? If none, enter zero. Do not…

A: It is required to determine the magnitude of the maximum bending moment by the force G.

Q: 1. The built-up beam pictured on the right is subjected to an internal moment of M = 75 kNm. a) At…

A: *The internal moment acting on the structure is M=75 kNm. *The total length of the T section is…

Q: Wind flows over a flat plate of length L = 25 mm and width W = 8 mm. The plate is maintained at a…

A:

Q: Degree of drawing is measured in terms of; Reduction in strain Reduction in area O Reduction in…

A: Degree of drawing is measured in terms of: Answer: Reduction in area

Q: What is the moment-area method?

A: The moment-area method is one of the methods for determining the slope and deflection generated in a…

Q: 2 Brass expands more than iron when heated. How would the strip look after prolonged exposure to…

A:

Q: Determine the x-y and n-t components of the 39-kip force F acting on the simply-supported beam. F =…

A:

Q: A force F = 6980 N acts upon a piston head, as shown in the figure. The gudgeon pin G connects the…

A:

Q: If the allowable tensile stress of the wires AB and AC is oallow = 250 Mpa, determine the largest…

A: