TTTT Draw AFD, SFD and BMD for the following frame, and determine the following . Vertical Reaction at A - Vertical Reaction at D • Horizontal Reaction at G • Maximum Axial Force • Maximum Shear Force Maximum Bending Moment 40KN/m F H. 30kN/m 6m G 4m 3m 4m 12m J 40kNm 6m 7m 6m 75kN B y D 3m >x A

Q: Calculate the forces in members BF, BE, and EF. P=30 P kN 3 m B 3 m 3 m D 1 m 3 m 3 m E

A:

Q: For the truss shown, loads are transmitted to the bottom chord. Draw the influence diagram of member…

A: Maximum tensile force The maximum tensile load a body can sustain before failure divided by its…

Q: a) Find minimum diameter nceded if the allowabe shear stress is 140 Mpa and the otation of point A…

A: Solution:-  We know that torsion equation is, TJ=τr=GθL here, net torsion is , T=T3-T1+T2  =10-4+2…

Q: Determine the forces in each member of the truss. Start to solve from Joint H and also from Joint D…

A: The given truss is shown below.

Q: 200 400 A В 200 N m E D 200 F Dimensions in mm Determine the magnitude of the force (in N) of the…

A: To find x component of internal pin at D

Q: The idealize model for suspension bridge is shown in the figure. The truss are pin connected at a,…

A: We have to determine the design diameter of the cable if the allowable tensile stress is 150 MPa and…

Q: Im 0.5 m 0.5 m 0.5 m B D 1 m- 0.5 m E

A: carrier system is givensupported at A and CG=2KNFindthe vertical support reactions and the rod…

Q: Draw AFD, SFD and BMD for the following frame, and determine the following Horizontal Reaction at G…

A: Horizontal Reaction at G =24 KN Maximum Bending  moment =1050KNm at C Shear force at C = 56KN…

Q: Draw the ILD diagram for the member DG and determine the maximum force developed in member DG of the…

A: To construct ILD for member GD, apply unit load load at every junction and calculate the load…

Q: 00144 0.01am 0.09m 0.0144m 0.09m For the beams shown below: 1- Draw shear force and bending moment…

A: Note:-As per the guidelines we are only supposed to answer first question. With three sub parts.…

Q: Replace the forces acting on the plate by a wrench. Specify the force and couple moment for the…

A: Consider the figure,

Design criteria for structural loading

The different loads such as loads due to self-weight (dead load) and external loads such as live load, wind loads, seismic load, snow load, and other loads and load combinations that influence the design of a building are called structural loading. The nature of the applied load differs from changes in the location, design, and type of materials used. The design criteria require that structures must be designed and constructed to be able to withstand all load types that are expected to act upon the structure and render its usage for the designated purpose. The structural members such as beams, slabs, columns, and foundations help the structure to withstand the applied load. There are different institutes such as ASCE and ACI that provide building design codes to assure minimum safety requirements and quality of the structures.