Tow super-elented concentric roadways Separated by a distame of 12.19m between their center Lines, if the road vadius and the rate of super elevation for the in side roat is 304.8 and P.1, vespectively the design speed CV)

Tow super-elented concentric roadways Separated by a distame of 12.19m between their center Lines, if the road vadius and the rate of super elevation for the in side roat is 304.8 and P.1, vespectively the design speed CV)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A vehicle moving in wet weather along down grade highway of (- 4%) grade. The design speed…

A: Given- V=48 mile/hrV=21.46m/secn=-4%f=0.30t=2.50sec

Q: A Yu highway difflicate by angle of 50° 40 Find: 1. The tangent and curve length, D=4° 2.…

Q: A four-lane undivided multilane motorway in a suburban area has the subsequent characteristics:…

Q: Q1/A horizontal curve with degree of curvature of 4° and intersection angle of 55°25', the PC is…

A: A curve is given between two stations with the following observations.degree of curve, D=…

Q: II. PROBLEMS 1) Module 12 - Horizontal Curves An existing highway with bearing of N20°E is to be…

Q: Example : A road way deflect by an angle of 50° 40'. The two tangent intersection of station 20 +00.…

Q: please solve this homework question I can’t seem to understand

A: Given data - Lcr - lateral distance from the right end Lcl - lateral distance from left edge of…

Q: The ordinates of a 4-hour unit hydrograph for a particular basn s gven pelow Determine the ordinates…

A: The ordinates of S curve and 6-hr Unit Hydrograph is shown in the table below.

Q: The design speed of a parabolic curve is 80 kph with a soil grade of g1 of 3% and g2 of -4% with Ss…

Q: I want a good solution and good traffic, I would appreciate it very much (descriptive geometry -…

A: descriptive geometry problem in the Diedric system.Completing the Front View of Segment ABProject…

Q: For a design speed of 80 kmph, if the deviation angle of a valley curve is 1/30 then the length of…

A: Given that :- Design speed = V = 80 Kmph if the deviation angle of a valley curve = 1/30 To…

Q: Question 11 A 12-degree s imple curve is to between the tired and pavement is designed for a maximum…

A: V=88kmph f=0.4 D=12o

Q: A vertical curve on a roadway has a BVC at station 23+00 and an elevation of 900.00'. If the EVC is…

A: Given data: BVC station=23+00 EVC station=33+00 g1=4.00% g2=-3.50% Elev at station 29+00=?

Q: 4. Posted speed limits in rural major collectors road are between (....) kph. 5. Maximum width of…

A: Given 4. Posted speed limits in rural major collectors road are between ( ________) kph. 5. Maximum…

Q: Determine the grades of a symmetric VC that requires a stopping sight distance of 434.3 ft and…

Q: Example: A road way deflect by an angle of 50° 40. The two tangent intersection of station 20 +00.…

Q: (2) What is the reduction of the free-flow speed due to the given right-shoulder lateral clearance…

A: Lane Width Adjustment Correction Factor This Correction is applied when Lane Width is narrower than…

Q: Q41. If the stopping distance is 60 metres, then the minimum stopping sight distance for two lane,…

A: given- stopping distance-SD=60 mtwo lane, two way traffic

Q: A 1800-kg truck travels at 85kph around a banked curve with a radius elevation so that the tire…

A: V=85kmph R=250m

Q: The extra-widening required for off tracking due to rigidity of wheel base for a vehicle moving on…

A: Given - Speed of vehicle = 50 kmph Radius of curve, R = 360 m Length of vehicle, l = 6 m Number of…

Q: the radius of a horizontal curve on an existing highway is 250m.if the superelevation at the curve…

Q: True or False – For sag vertical curves, a driver’s ability to see upcoming obstructions in highway…

A: Answer - FALSE This Above statement is false , it actually happens in crest vertical curves .

Q: A 2 lane highway with a grade of 6% has a posted speed limit of 50 mph and a design speed of 55mph.…

A: The stopping sight distance (SSD) : The stopping sight distance (SSD) is the minimal sight distance…

Q: A 1 in 10 turnout taking off from a straight BG track having the heel divergence 10 cm, the value of…

Q: Ass: maximum velocity that pass through a vag parabolic curve having sight distance of 500 ff when…

A: Answer We are given Sight distance S = 500 ft G1 = -1.5% G2 = 2.5% Calculations shown in steps…

Q: when designing a highway curve is it required that cars at a constant speed of 33 m/s must not have…

Q: A horizontal curve has a design speed of 50 mph. Compute the degree of the curve if e = 0.10m/m and…

Q: Determine the angle that the beam of the car's headlamp will make above the longtudinal axis of the…

Q: 15. Q2. Using a superelevation of 0.06 and given a flat highway exit ramp with 850ft radius, what…

A: Solution given in next step

Q: A 7.0m wide (3.5m lanes) two-way two-lane (TWTL) rural road curves around an obstruction…

A: Answer We are given Width of Lane w = 7 m Radius of curve R = 425 m Design speed V= 90 km/hr Since…

Q: if the dwsign speed of a multilane highway is 100km/hr what is the minimum sight distance that…

A: Given:- The design speed of a multilane highway = 100 km/hr The perception reaction time = 2.5 sec…

Q: Problem 5 A two-lane road has a horizontal curve on with a degree of curvature equal to 5 and a…

A: Given: Stopping sight distance (SSD) =340feet Degree of curvature =5ο Backslope = 4:1

Q: One of the main differences between freeways and local streets is

A: Freeway is a highway that does not have a toll. It has wide roads for fast-moving traffic and…

Q: Calculate the minimum length af a crest vertical curve for a two lane highway with an initial grade…

A: Initial grade = g1 = +3.5% Final grade = g2 = -2% Passing Sight Distance = PSD = 700ft Design speed…

Q: For a design speed of 80 kmph, if the deviation angle of a valley curve is 1/20 then the length of a…

A: Given data in question Design speed 80 kmph Deviation angle 1/20 Valley curve To find out Length…

Q: For a 3-hr unit hydrograph, determine a 3-hr S-Curve? Time (hours) 0 Q (cfs/inch) 6 12 18 24 100 40…

A: Given data:- Time (Hours) 0 6 12 18 24 Q (cfs /inch) 0 30 100 40 0

Q: Q-A cross-over occur between two Meter Gauge parallel tracks of same crossing number 1 in 12 with…

A: Given- Crossing number 1 in 12, Distance between centers of tracks=3.5 m, G=1 m,

Q: A rural highway difflicate by angle of 50° 40' Find: I. The tangent and curve length, D=4° 2.…

Q: A horizontal curve is being designed for a new two-lane highway (12-ft lanes). The PC is at station…

A: Horizontal Curve: A horizontal curve is a curve that shows the change in the alignment of two…

Q: d, e =0, determine the horizontal sightline offset (HSO) that a large billboard can be placed from…

A: Given:- radius of 800 ft posted speed limit of 35 mi/h e =0, To find:- the horizontal sightline…

Concept explainers

Drainage of Pavements

Pavement Drainage holds ample significance, as it prevents the accumulation of water or any liquid on the surface of pavements and ensures proper drainage system. With proper design and gradual slopes provided, the water gets easily removed from the surface into the drains, which are essential during heavy rains and unusual weather conditions keeping it less prone to accidents and increasing the durability of the pavement structure.

Question

Tow super-elented concentric roadways
Separated by a distame of 12.19m between
their center Lines, if the fead vadius and the rate
of super elevation for the in side roat is 304.8
and 8.1, vespectively the design speed CV)
and (fs) are the same for both wondways
find (e) for the outside reado

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data

VIEW

Step 2: Finding super elevation (e) for the outside road

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Determine variables requested below for a horizontal curve with the following characteristics. Length of curve 1255', Radius 1200', sta of PC 12+00 superelevation rotated about the roadway centerline, 3 lane roadway, 14ft lane width, entire road section normal crown=2%, road design speed%3D60 mph, max superelevation=8% 6) The length in full superelevation, in ft, is: O 790 O 1100 O 1410 O 1875 O 2075
Please i need solve on 10 minute
A valley curve is formed by a descending grade of 1 in 20 meeting an ascending grade of 1 in 30. What is the length of valley curve (in m) to fulfill comfort condition for a design speed kmph? of 85 [Assume allowable rate of change of centrifugal acceleration, C 0.65 m/sec³]
I need the answer as soon as possible
Determine the minimum sight distance for a two-lane divided Highway in hilly terrain on a 4% descending grade. data as per IRC recommendations given are V=60kmph, f=0.36, t=2.5sec.
Determine the length required for the exit ramp having a downward slope of 2% and with the following information: Expressway Speed = 96 kph Exit sign letter height = 3 in Exit sign is located 80 m. from exit ramp. Motorist can see 1 in. of letter height at 50 ft. Perception-Reaction Time = 2.5 sec Friction = 0.35 %3D
The design speed of a horizontal curve on a two-lane freeway is 70 mph. The central angle is 40 degree and the lane width is 11 ft. The superelevation is 6 and was set assuming maximum friction factor, what distance (in ft) must be cleared from the inside edge of the most inside lane to provide adequate stopping sight distance? A. Other B. 27 C. 42 D. 33
Determine the grades of a symmetric VC that requires a stopping sight distance of 434.3 ft and minimum length of VC 873.9 ft. Determine also the maximum speed limit to be imposed if it is to be by increments of 5 mi/hr and 10 mi/hr. Assume vehicle eye levels of 3.5’ and 2.0’, both situated inside the VC. Use the same deceleration value in the previous problem.
limit to 3 decimal places
A vertical curve joining a (-5%) and (+3%) grades in a rural highway has a design speed of 100kph. The tangents intersect at a station (225+71.35) at an elevation of 290m. Caleulate the elevations of intermediate points on the curve each 100m, and determine the stations and elevations of PVC, PVT. It s important to know that the driver acceleration rate is 3m/sec2 and the perception & reaction time is 2.5 seconds.
Milel l 1431,62| g0 An Engineer has the following data for a highway segment o (Mpik)| 60 |5211 |34 22 k( Vely 431,62180 I .... a) Estimate the mean free flow speed and jammed density b) What are the maximum flow rate and corresponding density c) What are the average headway and spacing when k= 50 veh./mile solution
A two lane national highway having design speed of 50 kmph passing through a hilly terrain has a horizontal curve of radius equal to ruling minimum radius. Design all geometrical features of the curve. Calculate set back distance for SSD also.