total deformation in ansys

Q: What is notch sensitivity?

A: Notch sensitivity:- When a material undergoes cyclic or fluctuating lading then in that case notches…

Q: The redesigned brake caliper is manufactured using SLM from Titanium Ti6Al-4V alloy powder. How many…

A:

Q: Hardness tests are performed more frequently than any other mechanical test for several reasons:…

A:

Q: What is creep and stress rupture testing?

A: Creep and stress rupture testing: The creep and stress rupture testing is used to check the…

Q: What results do we get from the tension test?

A: In a tension test, the tensile force is applied to a material to measure the stress. so that the…

Q: What does a tensile test show?

A: Tensile test is destructive test in which multiple mechanical properties are measured. It is called…

Q: A brittle fracture of a test specimen in an impact test is usually characterised by; A plastically…

A: A brittle fracture of a test specimen in an impact test is usually characterized by a bright…

Q: What is compression testing?

A: Compression testing Compression tests are used to verify a material's behavior under applied…

Q: what is the Rockwell hardness test

A: The rockwell hardness test is a technique of measuring the hardness of materials. The rockwell…

Q: What are three commonly used test to measure the hardness related properties of materials?

A: there are so many methods or test to measure hardness of material.

Q: A reciprocating type ball-on-disc tribometer was used to measure the tribological behaviour of the…

A: wear Area, A = 300 m2 = 30010-6 mm2Sliding velocity, V = 3.14 cm/s = 31.4 mm/sTest frequency = 1 Hz…