Total body force on the entire particle is, Mass of the entire fluid particle is; ..... .....

Q: In the drawing operation, technological property weldability is an important parameter. Select one:…

A: Drawing: It is a process in which uses tensile forces is used to stretch metal.

Q: Hi is there any way the format can be changed a little bit so I can see the full explanation?

A: Given Data

Q: 2. Sharp notches are often added to plastic food packages to help open them (along with arrows…

A: Detailed explanation:Sharp notches are a very good example of the functional features to the plastic…

Q: 3

A: intro- defects on any material is cause of failure of material.

Q: To show how individual pieces fit together, it is necessary to use larger-scale drawings and section…

A:

Q: What are the four basic steps of creating a circular shape in perspective? Using any digital medium,…

A:

Q: What type of lines can be used in a drawing to show that part of an object has been removed ?

A: Solution : There are two types of line which are used to show the removed part of an object : Break…

Q: 9. The top view shows a bend radius of the thin metal. Would a bend radius of 1/8" meet the…

A: If the bend radius lies with in the given range then it will meet the requirements. 18"=0.125" The…

Q: Automotive body panels are.... Are produced using Additive Manufacturing Usually manufactured by…

A: Given:- Automotive body panels To find:- The manufacturing method for automotive body panels.

Q: Note 1 indicates 10 GAGE 1010-1020 sheet metal can be used to make the main body of this part…

A: Tolerance is the difference between the maximum size and the minimum size of the part or element.

Q: The Sleeve Bearing Problem A machinist had pressed a new prelubricated, porous sintered bronze…

A: There may be following reasons of bearing failurePoor finishing on the bearing surface after…

Q: Explain the following with appropriate examples (at least 2 examples) 1. Grubler's criterion. 2.…

A: The Grubler's criterion gives the number of degrees of freedom of a mechanism involving links and…

Q: I asked for problems 6 and 7 to be answered, but I did not get a properly structured answered as the…

A: Chamfer the edge at  45o  with 0.250” leg distance.

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.