5. The following is the hourly irradiation readings for a site where a solar array will be installed.Time Irradiation recorded for Wh/m27.00 am - 8.00 am1808.00 am - 9.00 am3009.00 am - 10.00 am40010.00 am - 11.00 am60011.00 am - 12.00 am80012.00 noon - 1.00 pm8001.00 pm - 2.00 pm6002.00 pm - 3.00 pm4003.00 pm - 4.00 pm3004.00 pm - 5.00 pm180Total Irradiation (kWh/m2): 4.56 kWh/m2If the site is shaded from 11 AM to 2.00 PM what is the total available daily irradiation for thesite?a. 2.36 kWh/m2b. 3.96 kWh/m2C. 4.56 kWh/m2d. 2.96 kWh/m2

The area under the curve wh/m2 and time will give the solar irradiation of the site , we need to…

Answered: total available daily irradiation

Engineering

Electrical Engineering

total available daily irradiation

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Eriefly explain half wave f Rectifies cirwit with (apacitive tilter.

A: Rectifier is device which convert alternating signal in to pulsating direct signal. The half wave…

Q: When the diode is reversed biased, the terminal that is connected to the lower potential of the…

A: Diode is said to be reverse biased when cathode voltage is greater than anode voltage.

Q: Wave Luminous Color Wattage (W) Voltage (V) Lamp life ( hours) Current Power Re-Strike S.no length…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: 81 Battery B2 Battery ကိုမင်းကို 51 Switch -O- E - 3.32 နိုင် 0 3 VOLTS MAX ၂ဝ KIT NO.

Q: The current rating of the fuse is always less than its minimum fusing current O True False

A: We know that fusing factor shoulde be less than one. And fusing factor can be defined as the ratio…

Q: What will be the value of thermal voltage for 47oC temperature?

A: Given temperature is –

Q: (c) Based on diode circuit shown in Figure 1, determine the voltage across diode, VF and current, IF…

A: First we will check whether the diode will be on or off then we will find out current and voltage…

Q: Determine Zener diode voltage value as well as the ripple percentage of the circuit below

A: We are given the circuit shown below: We have to calculate: Zener diode voltage value; The ripple…

Q: 5 procedures in building a sustainable lamp

A: Procedures in designing a sustainable lamp system or lighting system is as follows: 1) Choosing the…

Q: Vhich of the following is not a factor which affects solar panel efficiency. O a. Temperature O b.…

A: Given To find which parameter does not effect solar panel efficiency.

Q: thyristor used in a half wave rectifier used 50 KV , with firing angle 30° , total sistance load 5…

A: *Keeping a note ?as per our company guidelines we are supposed to answer ?️only first 3️⃣ sub-parts.…

Q: The average value of a half-wave rectified voltage with a peak value of 200 V is___

A: The average value of a half-wave rectified voltage with a peak value of 200 V is___

Q: Formulate approach boundaries in the light of exposed live parts

A: Nominal system voltage (Phase to Phase) Limited approach boundary Exposed movable conductor…

Q: The rate of fall of current in a diode with reverse recovery charge and reverse recovery current of…

A: Given Reverse recovery charge= 38 µC and reverse recovery current =27.5 A

Q: Calculate the average value of a half-wave rectified voltage with a peak value of 100 V

Q: Discuss the mechanism of incandescent bulb, fluorescent lamp and LED

A: (1) Incandescent Lamp The incandescent lamp works on the principle of heating effect of the…

Q: Conduct an FMEA for the simple lighting circuit shown below. Battery tililt Switch 1 Switch 2 Lamp

A: FEMA stands for Failure Mode and Effect Analysis (FMEA). It is conducted in order to analyze the…

Q: What is the best ampere of fuse for 3W LED CHIP LIGHT without flickering

A: Given An Led of 3W power rating.we need to determine the fuse amperage. Please find the below…

Q: USEFUL FORMULA 44 AVE

A: FIND: Forward resistance of given graph

Q: What are the reasons causing the unstability of perovskite solar cells?

A: To do: We have to explain about reasons causing the unstability of perovskite solar cells.

Q: Name the functional unit for an electric car battery

A: The most common battery that is used in electric cars is a Lithium-ion battery. There are many…

Q: A thyristor used in a half wave rectifier used 50 KV, with firing angle 30° , total resistance load…

Q: 3. Choose the suitable sensor to detect a part inside paper box as shown in Figure 1. Figure 1 a)…

A: The capacitive proximity sensor detects only non ferrous materials with a range of 3mm to 60mm.…

Q: (a) Determine the colour bands and indicate the resistance range values (minimum - maximum) for each…

Q: Explain the operation of each of the following Devices Thyristor Diode 11.

A: i) we have to explain the Thysristor, it is consist of foure layer of semiconductor device it is…

Q: QUESTIONS: 1. A transformer is rated at 120V primary/23V secondary. What peak to peak secondary…

A: As per the honor code I will do only first question. Kindly repost the other questions again. THANK…

Q: O 63.7 volts

Q: 2-what design paramelers of the Fall ware rectifier-

A: To construction of full wave rectifier we need 1.step down transformer…

Q: What is tungsten,CFL,led bulb... Which one save electricity and why ?

A: Please find your answer below.

Q: What are the parameters of the ff: Incandescent Lamps Tungsten-halogen Lamps Gaseous Discharge…

A: 1. Incandescent Lamps: - Light Generation: Incandescent lamps produce light by passing an electric…

Q: 1. Choose one type of diode and explain its function, operation, and different applications. Your…

Q: 03: There is threshold voltage in GM counter but in ionization chamber no threshold is required why?

A: 3) Threshold voltage" is utilized just to distinguish the voltage which is essential across a G-M…

Q: Vo +8V W R3=4700 2200 Si V2 Ge 3300 V1

A: Diodes: Cut in voltage of si=0.7v Cut in voltage of Ge=0.3v

Question

5. The following is the hourly irradiation readings for a site where a solar array will be installed.
Time Irradiation recorded for Wh/m2
7.00 am - 8.00 am
180
8.00 am - 9.00 am
300
9.00 am - 10.00 am
400
10.00 am - 11.00 am
600
11.00 am - 12.00 am
800
12.00 noon - 1.00 pm
800
1.00 pm - 2.00 pm
600
2.00 pm - 3.00 pm
400
3.00 pm - 4.00 pm
300
4.00 pm - 5.00 pm
180
Total Irradiation (kWh/m2): 4.56 kWh/m2
If the site is shaded from 11 AM to 2.00 PM what is the total available daily irradiation for the
site?
a. 2.36 kWh/m2
b. 3.96 kWh/m2
C. 4.56 kWh/m2
d. 2.96 kWh/m2

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Question: A UJT exhibits negative resistance region Option 1: Before the peak points Option 2: Both Before the peak points and After the valley points Option 3: After the valley points Option 4: Before the peak and valley points
13 - Resistance thermometers should be immersed in a minimum of ..... to ..... times their outer diameter to measure the temperature properly and accurately.A) 6 to 15B) 10 to 25C) 15 to 25D) 10 to 15E) 20 to 30
solution for Convert 160 Mil wire to millimeter
What is the meaning of the acronym, PVC? A. Polyvinyl Chloride B. Perovinyl Chloride C. Pure Vinyl Compound D. Polyvitamin Chlorine
write 4 points on working of nuclear power station
This battery operated leak detector can detect very accurately leaks of up to a quarter of an ounce per year. d) propane lighter a) electronic detector c) halura torch b) ultrasonic detector
What is the relationship of temperature and irradiation on the output of the solar
Q#04: i- Why free-wheeling (also called fly-wheel) diode is used? ii- Explain & illustrate with figures/graphs.
will the solution remain the same if the diod was si diod ?
A platinum resistance temperature detector (RTD) is used to measured temperature of the hot gas. The resistance of sensing element is 250.3 ohm when it contact with hot gas, calculate the temperature of the gas. The RTD has a resistance of 120 ohm and 80 ohm at 100°C respectively. The temperature coefficient of platinum is 0.0039 C^-1.
What is the resistance of thermistors at boiling temperature (100 deg C)
Convert 350 watts to BTU/hour.