Tonic water (20.0 mL) was added into each of two volumetric flasks (100 mL). The first flask was made up to volume with deionised water and produced an absorbance of 0.200. To the second flask was added an aliquot (20.0 mL) of a quinine standard solution (20.0 ppm) and after being made up to volume this produced an absorbance of 0.400. What is the concentration of quinine in the tonic water? a. 8.00 ppm a b. 800 ppm 40.0 ppm с. d. 400 ppm е. 20.0 ppm

Tonic water (20.0 mL) was added into each of two volumetric flasks (100 mL). The first flask was made up to volume with deionised water and produced an absorbance of 0.200. To the second flask was added an aliquot (20.0 mL) of a quinine standard solution (20.0 ppm) and after being made up to volume this produced an absorbance of 0.400. What is the concentration of quinine in the tonic water? a. 8.00 ppm a b. 800 ppm 40.0 ppm с. d. 400 ppm е. 20.0 ppm

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Solute, A, has a distribution ratio between water and ether of 7.5 A 50 ml aqueous solution of 1M of compound A was extracted with two consecutive extraction of 25ml ether( 25 x2); calculate the percent of A remaining in the aqueous phase Select one: 21.1 % 1.6 % 4.4 % 11.7 % 1.38 %
1)A bottle of concentrated aqueous sulfuric acid, labeled 95.00 wt% H2SO4, has a concentration of 16.5 M. Calculate the density of 95.00 wt% H2SO4. 2)Ascorbic acid in 5 vitamin C tablets was measured by a titration against (100 ± 0.002 M) NaOH solution. It required 10.00 ± 0.05 mL NaOH solution to reach the equivalent point. What is the average quantity of ascorbic acid per vitamin tablet?
What mass of MgCl₂ 6H₂O is required to make a 0.200 dm³ stock solution containing 25.0 ppm Mg(II)? What volumes of this stock solution are required to make 10.0 cm³ standard solutions containing 5.00, 1.00 and 0.10 ppm Mg(II)?
A mixture of benzoic acid and naphthalene was separated by a liquid-liquid extraction by converting the benzoic acid into its water soluble sodium salt. How can the benzoic acid be recovered after the two layers were separated? Group of answer choices Acidify the aqueous solution containing the sodium benzoate to pH 2 and filter. Add an excess of 1.0 M NaOH to the aqueous solution containing the sodium benzoate and filter. Add diethyl ether to the aqueous solution containing the sodium benzoate and filter. Dry the the aqueous solution containing the sodium benzoate with anhydrous sodium sulfate and filter.
In an experiment to determine the concentration of H2SO4 in a brand of toilet cleanser, 10.0 cm3 of the cleanser was first diluted to 250.0 cm3 with distilled water. 25.0 cm3 of the diluted cleanser were titrated with 0.320 mol dm–3 NaOH solution, using methyl orange as indicator.If 29.2 cm3 of NaOH solution is used, what is the concentration of H2SO4 in the undiluted toilet cleanser?a. 2.30 mol dm–3b. 4.60 mol dm–3 c. 9.20 mol dm–3 d. 11.50 mol dm–3
3.) The following Beer's Law calibration plot was collected at 391.9 nm using the five mixtures listed above. The trendline equation was y = 4617.1x. A saturated solution of lead(II) chromate had an absorbance of 0.0025. Calculate its solubility, in molarity. Molar Solubility of PbCrO4: x 107 M ABSORBANCE VS CHROMATE CONCENTRATION AT 391.9 NM 1.40 1.20 y = 4617.1x R-0.9972 1.00 0.80 0.60 0.40 0.20 0.00 C 0.00005 0.0001 0.00015 0.0002 0.00025 0.0003 Chromate concentration (mol.L)
A 100 ml bottle of metronidazole 100 mg/ml suspension is available in your pharmacy. Calculate the volume of this suspension needed to be diluted with cherry syrup to prepare 60 ml of a 4% metronidazole suspension. 1 ml of a 1:1000 epinephrine injection was mixed with 20 ml of 1% lidocaine injection. Calculate the new ratio strength of epinephrine in the admixture. (IGNORE ANY VOLUME CHANGES AFTER ADMIXTURE) Instead of preparing 4 grams of tetracaine hydrochloride 4% gel an 8% gel was compounded by mistake. How many grams of the 8% gel and gel base must be mixed to get 4 grams of a 4% gel? How many milliliters of 70% ethanol and 20% ethanol must be mixed to prepare 500 ml of 30% ethanol? A diphenhydramine elixir contains 12.5 mg drug in one teaspoon. The volume of oral vehicle that is to be added to 100 ml of this elixir to reduce its strength by one half its original strength is; 6. 90 capsules of Liothyronine (T3) 15 micrograms are to be prepared. The formula calls for a 1:10000…
A mixture of valine, glycine, isoleucine, aspartic acid, phenylalanine, arginine, lysine, asparagine, and methionine are put into an electrophoresis apparatus, with the buffer pH=6.5pH=6.5. Sort each amino acid according to its charge in the buffer with a pHpH of 6.5.
In the distillation of the mixture of acetic acid (MW=60.05 g/mole; d=1.05g/ml) and water (MW= 18.00 g/mole; 1.00 g/ml), a total of 0.028 Liters of 1.0 M std NaOH was used to reach the endpoint of a 23 ml of distillate. What is the mole ratio of the CH3COOH in the mixture? final answer in 3 decimal places.
Penicillin F is recovered from a dilute aqueous fermentation broth by extraction with amyl acetate, using 6.5 volumes of solvent per 100. volumes of the aqueous phase. At pH = 3.8 the distribution coefficient KD is 74. (a) What fraction of the penicillin would be recovered in a single ideal stage? (b) What would be the recovery with three-stage extraction using fresh solvent in both stages? (c) How many ideal stages would be needed to give the same recovery as in part (b) if a counterflow cascade were used with V/L = 0.065?
Calculate the percentage purity of naproxen (FW 230.26) from the following data. 212.9 mg of naproxen was weighed and dissolved in a mixture of 25 ml of water and 75 ml methanol. It was titrated with 0.1024 M sodium hydroxide solution, using 1 ml of phenolphthalein solution as indicator. 8.08 mL of sodium hydroxide was required to neutralize the solution. Record your answer in decimal notation to 2 decimal places.
A moving boundary experiment was performed at 25°C with 0.100 M KCI on the bottom and (initially) 0.0700 M NaCl on top. The transport numbers of K+ and Na+ in these solutions are 0.490 and 0.388, respectively. The boundary moved downward. The cross-sectional area of the tube was 0.100 cm². The charge passed through was 96.5 coulombs. How far did the boundary move in cm?